My Ipod touch is in recovery mode but when I go to restore it in itunes it only stays connected for a few seconds then ejects itself. How do I keep my ipod on long enough to restore it?
My Ipod touch is in recovery mode but when I go into Itunes to restore it, it will only stay connected for a few seconds then ejects itself from itunes. How do I keep my Ipod connected long enough to go through the restore process?
Error 1611
This error typically occur when security software interferes with the restore and update process. FollowTroubleshooting security software issues to resolve this issue. In rare cases, this error may be a hardware issue. If the errors persist on another computer, the device may need service.
Similar Messages
-
im having issues with hard drive im trying to install football manager 2015 it reads disk for a few seconds then ejects itself other cds read fine
and have tried older versions of football manager and they dont read either
any help would be greatly appreciated
thanksTry resetting the SMC 2-3 times, if that does not work then the DVD may need cleaning. Get a dry cleaning kit from your local office supply store.
Intel iMac SMC and PRAM resets -
Why does my ipod classic (80gb) connect for a few seconds then disconnect?
I have a ipod classic 80gb, granted its old, but it has a big memory so I can store my whole collection. Anyway, when I connect it to my PC (with windows 8.1) it will connect for a few seconds then disconnect. It will sometimes start to sync, but then disconnect after a few seconds. My computer is pretty new, Acer Aspire V5. I have tried reinstalling itunes, a new cable to connect it, different usb ports(2) and with and without the pc plugged into the mains, which is when it starts to sync for a brief second. Has anyone else had the same problem??
The S.I. prefix Giga is used to mean both 1000x1000x1000 and 1024x1024x1024. Computer software typically uses the second version, but using the first number makes the same number of bytes appear bigger when expressed as Gb, so is favoured by hard drive manufactures.
80Gb10 = 74.3Gb2
It's a bit like specifying a quantity in gallons without saying whether they are US or Imperial gallons - everybody gets the same volume but one number will be bigger than the other. I could offer you a tank with 10 Imperial gallons of fuel in it - but if I tell you it's 12 US gallons it sounds like you're getting more for your money.
Once the total size of your library exceeds the capacity of your device all you need to do is create some size limited playlists to determine what goes on the device. Don't sync all movies, sync one or two that you plan to watch soon. Likewise with TV Shows. Limit podcasts to unplayed episodes and finally create a music subset. What worked for me for some time was a smart playlist called Steve's Tunes defined as Playlist is Music and Playlist is not Exclude where Exclude was regular playlist that I would manually add to until Steve's Tunes was small enough to fit. These days I run an iPhone and have a number of smart playlists with ? Gb of most played, ? Gb of highly rated, ? Gb of recently added, ? Gb of essentials, ? Gb of unplayed etc. Each time I sync I get slightly updated selection without having to put any extra effort in.
tt2 -
I'm trying to play this new movie i bought with my macbook but every time i put the movie in it makes a noise and only stays there for 6 seconds then ejects itself how can i fix this problem?
Restart your phone,hold the home button and the off button down till the apple symbol comes up. If that doesnt fix it , you need to do a restore in itunes by connecting to itunes , click on your phones name to the left, then click restore in the center of the screen and restore from backup.
-
I just bought the new MacBook Air a few days ago and my Internet connection is so slow. My iPhone's connection works fine when connected to the wifi but the MacBook connects for a few seconds then drops completely. What do I do? I tried connecting it to my phone's hotspot and it works perfectly. I'm a new Mac user so I have no idea what to do. I have Comcast xfinity cable and Internet. Thanks for the help.
Your warranty includes 90 days of phone support. Contact Apple.
-
My ipod shuffle 4th generation was working fine for a few months. My son then bit the USB charger. I bought a new USB charger, but the shuffle is not charging and not showing up under the devices in itunes. It also doesn't appear in my windows under my computer. Just to note. I also have a new ipod touch. I am able to charge that fine on the same computer using the USB charger. The device (Ipod touch) does show up in windows and in itunes. The shuffle doesn't show in either place.
I have tried to use the apple support page. I went through each step. I made all of my USB drives not shut down, I had my computer on all night to try and charge the shuffle. All I see is a red light that appears on the shuffle for a few seconds when I first connect the USB charger to the computer. Then, nothing. Since this was working a bit ago, I don't think that I have a defective shuffle. The USB charger is brand new, I just picked it up yesterday from the apple store. I have the short one, and the longer cable as well.
Any help that you might be able to give to me would be much appreciated. My daughter is missing listening to her music. Thanks!Instead of "charger," you should call it the "USB cable" to avoid confusion. When started reading your post, I was thinking, how can your son break a USB power adapter (the "charger" that plugs into a wall socket) by biting it...
Since you got the product with the two USB cables at the Apple Store, you have the right replacement (some third-party replacements are for the 2nd gen shuffle and do not work with the 4th gen shuffle). Make sure you are completely inserting the plug into the headphones jack. The fit may be tighter than expected, since the connectors are new.
http://support.apple.com/kb/TS3572
If you tried both of those cables, it would be unlikely that you got two faulty cables in one package. If a new USB device has been added to the computer between the time it worked with the old cable and now, there could be a problem on the USB bus (such as not enough power or a device conflict).
As a test, you should shut down (power off) the computer and disconnect all USB devices (including any hub), except for standard keyboard and mouse (if used). Do this to reset the shuffle
http://support.apple.com/kb/ht1655
Start up computer, run iTunes, and connect the shuffle by itself to a direct USB port on the computer. -
Please help me!
Try a manual install (using DFU Mode), as outlined in the link below.
Basic troubleshooting steps
17" 2.2GHz i7 Quad-Core MacBook Pro 8G RAM 750G HD + OCZ Vertex 3 SSD Boot HD
Got problems with your Apple iDevice-like iPhone, iPad or iPod touch? Try Troubleshooting 101
In Memory of Steve Jobs -
My ipod touch is in recovery mode and I don't want to restore it
My ipod touch is in recovery mode but I don't have my photos, apps, videos backed up. How do I keep my stuff without restoring it?
If this program will not get it out of recovery mode (very doubtful) you will have to restore and erase the iPod.
RecBoot: Easy Way to Put iPhone into Recovery Mode -
screen locked up and shows the battery with low red and ligtning bolt and cannot hard shut down or reset just stays there for a few seconds then black screen. hooked up to computer and itunes doesnt recognize it or even shows that it is pluged in. looked and made sure nothing is broken or metal in ligting port or on cable which would prevent it from accepting a charge. ipod is only a month old and seems like a waste of money if its so hard to try to get an explanation of why this is ive been tryning to get an answer from apple for a week now.
Try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- Try on another computer
- Try another cable. Some 5G iPods were shipped with Lightning cable that were either initially defective or failed after short use.
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar -
The phone button on my iPhone 3G no longer works. Everything else on the iPhone works fine. I can receive incoming calls. I can make calls directly from Contacts. But if I press the phone button I get a blank white screen for a few seconds then it goes back to the home screen. I've tried the hard reset and also restoring orignall settings via iTunes but keep getting the same problem. Does anyone know how to fix this?
Thank you, Neil.Thanks for the advice but I've tried resetting network settings and also the reset by pressing home and sleep buttons until getting the Apple logo. Still have the same problem. To be clear (because I mistakenly typed black instead of blank in the title to this thread): If I press the phone button I get a BLANK WHITE screen for a few seconds then it goes back to the home screen. I doubt it's the SIM card as I can receive calls and make them directly from contacts. What I can't do is view my favourite numbers or missed calls or access my voicemail, i.e. all the things you get to via pressing the phone button.
-
I 'think' my Ipod Touch is in recovery mode and people say to hold the power and home button for 10 sec and i did, but its still not turning back on. Plus its dead and wont charge. PLZ HELP ME!!!!
- If in recovery mode the screen will have an iTunes logo with an USB plug.
- Have you tried connecting it to your computer for a n hw and then see if it appears in iTunes. If it does restore the iPod.
- If screen is blank, try placing he iPod in recovery mode and then restoring. For recovery mode:
iPhone and iPod touch: Unable to update or restore -
My iPod touch is stuck in recovery mode, but when I connect it to my computer to restore it, my computer does not recognize it. It does not appear as a device in my iTunes. What can I do to restore it/make my computer recognize it?
DId it successfully connect to this computer before?
Try:
iOS: Device not recognized in iTunes for Windows
or
V
Also try placing the iPod in DFU mode and then try restoring
iPhone, iPad, iPod touch: Device not recognized in iTunes for Mac OS X -
IPod Touch stuck in recovery mode, error message 1611 when trying to restore.
I bought a 2nd generation ipod touch from someone on CL and it appeared to me that it just needed to be plugged into the computer and be synced with itunes. But its stuck in recovery mode. When I plug it into my computer, itunes says it sees the ipod is in recovery mode and needs to be restored. Sout t I click on restore and it tries to restore it, but then it stops in the process and gives me error message 1611. I looked up this error message and it has to do with system security. I messed with my security settings and I still get this message. I tried using my home computer instead of my laptop and it still gave me the same message. Ive also tried holding down the power and home button for several seconds and it still goes back to recovery and gives me the same error message when I try to restore it. Also, itunes recognizes my ipod, but my computer does not.. Can anyone help me? Do I just have to bring the ipod into an apple store and have them figure it out? Thanks in advance!
Error 1611
This error typically occur when security software interferes with the restore and update process. FollowTroubleshooting security software issues to resolve this issue. In rare cases, this error may be a hardware issue. If the errors persist on another computer, the device may need service.
Have you tried what is in bold -
Ipod screen says to connect to itunes but won't let me enter my password. Tried recovery mode but when I click 'restore' itunes says it cannot connect to update server. Help!
Place the iPOo in recovery mode for the passcode issue. For recovery mode:
iPhone and iPod touch: Unable to update or restore
Also see:
iTunes for Windows: iTunes cannot contact the iPhone, iPad, or iPod software update server -
How do i get my ipod touch out of recovery mode......keep getting error message saying ipod could not be restored an unknown error occurred.
Been trying all night to sort out but just going around in circlesI have not seen a solution for that error but try:
- Place the iPod in DFU mode and then restore
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- Try on another computer
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar
Maybe you are looking for
-
Where is dbc_file path in JDeveloper 10.1.3.3.0?
Hi Gurus, I have just started learning OAF for Oracle Apps. I have downloaded the template.dbc file from the $FND_TOP/secure but I could not able to get this path (<JDEV_USER_HOME>\dbc_files\secure directory) in my machine JDEVELOPER Version 10.1.3.3
-
Any way to get video out from your Treo 800???
I have video files on my treo 800. I can view them on my treo 800. Is there any way to "pipe" the video output through the usb port and wirelessly to something else so I can take my treo 800 to a customer presentation and play a video for them on a
-
I suddenly started getting these errors last night and can't for the life of me figure it out. I did an Internet search and just got more confused. It is happening with Path Finder ans Adobe Photoshop CS4 Extended. Only PS crashes right off. I have t
-
Import purchased music to iTunes
Hi! I just bought a new iMac, but I'm having some problems getting the old music I purchased into the new iMac. I can see a list over all the music, but not an option to import it to iTunes. Can anyone help me? Thank you
-
Photoshop Double-clicking to open files stops working
The files in photoshop Cs3 in finder, when I Double-click to open files, the files not open, but photoshop open... Any Help?...