Need to explicitly setup AutoRerun for new installations of SCDPM2012 R2?

Question

Do I have to explicitly create the AutoRerunNumberOfAttempts
and AutoRerunDelay keys in the registry of my DPM servers for
AutoRun to work or is it built into SCDPM2012 R2 to automatically perform a rerun when a Sync and Recovery Point (RP) fails? 
HKLM\Software\Microsoft\Microsoft Data Protection Manager\Configuration
The reason for the question is that I have a case were a Synchronization failed for a volume, I have automatically set the protection group (PG) to run Consistency Check (CC) when a sync failure occurs.  This CC runs successfully immediately after the
sync failure, however the create RP doesn't automatically run after the CC. 
This particular PG only runs once weekly.  This means that even after a successful CC the RP is missing up to 2 weeks.
Thank you in advance for considering this question.

Answer 1

It looks like Auto-Rerun is enabled automatically per the following reference:
http://social.technet.microsoft.com/Forums/en-US/73e15ee3-1904-4623-a0a7-dd5859ca36cd/autohealis-autorerun-enabled-by-default-for-dpm-2012-sp1?forum=dpmfilebackup
Also, I looked into the DPMAccessManager*.errlog and found Auto-Rerun active.
However, now I'm wondering why the Recovery Point job doesn't run until the next scheduled time.
Scenario: (1) Protection Group set to run weekly on Monday at 8 am, (2) Sync fails at 8:05 a.m., (3) Auto-CC runs at 8:15 a.m. and finishes successfully at 8:45 a.m., (4) Recovery point doesn't run until NEXT Monday, in effect skipping this weeks RP,
however no errors are reported for the volume.
Why doesn't the recovery point re-run?
-Jenna