ONS 14454 SSM, Why is it sending DUS out this interface?

We have a 454 with three timing references set up-
Ref-1 = BITS-1
Ref-2 = OC-48 Slot 12
Ref-3 = OC-48 slot 6
The unit is using Ref-1 for timing. Both optical interfaces are set to use SSM and I have veriifed that they are. The OC-48 interface in slot 12 is sending DUS to it's neighbor, Slot 6 is sending PRS. If I change the timing to Ref-3 (slot 6) the SSM out of slot 12 changes to PRS. If I switch timing back to BITS then slot 12 changes SSM to DUS.
My expectation is when using BITS that all optical interfaces with SSM enabled would send SSM PRS.
Anybody have any explaination as to why slot 12 is sending DUS in this configuration?
Thanks
Ian

I finally figured this out. The BITS-1 and BITS-2 Out interfaces were using one of the optical interfaces as their reference source. Apparenty this results in the NE sending SSM DUS out the optical interface being used to time the BITS "Out" interfaces.

Similar Messages

  • Cisco ASA won't send Syslog out management interface

    I have been trying to get my ASA to send syslog out of the management interface without any luck. When I do a packet tracer it says that the global implicit deny rule is blocking it, but I tried to add a permit all in front of it and it still blocks it. Everything is configured correctly from what I can tell and the static routes and routing are correct. This has me baffled. Does anyone know what might be causing this or what I should look at in the config to get this working?

    Hi Mark,
          Talking of packet tracer, it would give you correct output for a through the box traffic, not for to the box or from the box traffic.
    So firstly we have two questions:
    1) Is this a through the box traffic, then you need to permit the traffic through ACL(if from lower sec level to higher) and add a NAT statement(depending on the ASA IOS Version you are using anything above 8.2.5 wont require a NAT).
    2) If this is a syslog from the firewall scenario, then you need to make sure to get the following logging configuration on ASA
    -enable logging
    -logging host management X.X.X.X --------(X.X.X.X is the ip of the syslog server)
    -logging trap debugging ----------(debugging is the level, you could use any other too, but to check would sugest this one)
    -Further if you have already sorted out till here, get us the following outputs:
    -show run
    -show logging
    -show logging queue
    Hope it helps
    Cheers,
    Naveen
    Please Rate Helpful posts.

  • Why does Firefox send scary warning "This Connection is Untrusted" for URLs that I know are OK?

    Example: I try to log on to renew automobile registration at www.DMV.state.pa.us or other innocuous locations and I receive that scary warning. So I log in on Explorer on my PC and the website works OK. Am I doing something wrong?

    as far as I know, you are not doing anything wrong. I get the same message for some government managed pages. I believe it has to do with who furnishes their certificates.
    Firefox has a article that explains security certificates here:
    http://support.mozilla.com/en-US/kb/This%20connection%20is%20untrusted

  • TS3899 In my iPad 2 with IO6 today I can not send emails from my gmail account, they go to the outbox directly...why? How can i solve this problem? ..I restarted the IPad but the problem was not solved. Please help.

    In my iPad 2 with IO6 today I can not send emails from my gmail account, they go to the outbox directly...why? How can i solve this problem? ..I restarted the IPad but the problem was not solved. Please help.

    Greetings,
    Questions:
    1. What version of the Mac OS are you running (Apple > About this Mac)?
    2. What version of the iOS are you running (Settings > About)?
    3. Do you use MobileMe/ iCloud or another server based sync solution like Google or Yahoo?
    4. Do other changes to synced information like Address Book content sync successfully back and forth?
    Based on your description it sounds like you have a 1 way sync issue.  Events sync fine between the iOS devices and fine from the computer to the iOS devices but not from the iOS devices to the computer.
    Try:
    Backup your computer and iOS devices before doing anything else:
    http://support.apple.com/kb/HT1427
    http://support.apple.com/kb/ht1766
    Ensure all the devices in use are fully up to date: Apple > Software Update / Settings > General > Software Update
    Make separate backups of critical data:
    Backup your computer Addressbook: http://docs.info.apple.com/article.html?path=AddressBook/4.0/en/ad961.html
    Backup your computer iCal: http://support.apple.com/kb/HT2966
    Reset syncing on your Mac: http://support.apple.com/kb/TS1627
    Reply back if that does not resolve your issue.
    Hope that helps.

  • Why when I send a message my friends receive it from my email account..

    Every time I send a iMessage to somebody that person doesn't receive it from my phone number but from my email account which is annoying...
    How can I fix it/how can I turn it off??
    Thanks

    This is not really enough information to offer informed assistance...
    marilenac wrote:
    why when I send messages from my Iphone, they come back to me?
    However... Check where you are sending them to...
    Make sure you are not sending them to yourself.

  • Why is the send button grayed when sending a message from contacts on my I pad

    Why is the send button grayed out when trying to send a message from contacts using my I pad

    Stick with one post at a time. Otherwise, it gets very confusing.
    https://discussions.apple.com/message/18529200#18529200

  • Why is a sender communication channel not required for IDOC and PROXY ?

    Hello,
    In case of IDOCs, metadata will be available in PI for the IDOCs used both at inbound and outbound.
    Why is a sender communication channel is not required in case of IDOC and PROXY outbound scenarios (i.e. IDOC to File or PROXY to file ..)  when a receiver channel is required for scenarios like file to IDOC or file to PROXY.
    Though this might be a regular question, I am not able to find a proper reason.
    Please let me know the reason for the above request.
    Thanks & Regards.

    You will create RFC destination in ECC , it will have details about PI system details, when ever you send IDoc, ECC will use Port and RFC destination to connect PI Integratiion engine to deliver data to PI.
    But when receiver side you will create RFC destination in PI with ECC details, but to call RFC destination and Port we need medium that was the reason we create IDoc communication channel.
    Even the same case for Proxy also, but HTTP deastination establish the conection between ECC and PI, but receiver side you have to create XI channel with PI integratioin engine adress to post data.
    Regards,
    Raj

  • Why i cant send itunes gift using my credit card?

    Why i cant send itunes gift using my credit card?

    What happens when you try to send a gift ? If you are getting an error message then what does it say ?
    If you are getting a message to contact iTunes Support when trying to send it then to do so (these are user-to-user forums) :
    - go to http://www.apple.com/support/itunes/ww
    - click on your country's flag
    - click on the Contact Support at the bottom of the left-hand column
    - click on Contact iTunes Store Support on the right-hand side of the page
    - then Purchases, Billing & Redemption
    If it's a different problem ... ?

  • Why did you send me a download in XML format, instead of WORD?

    Why did you send me a download in XML format?

    balancedphoto, I just sent you a private message. Please check your inbox. :: Yuri

  • Why when someone sends me a picture or video and i reply to it my reply goes to everyone the picture or video originally when too.?

    Why when someone sends me a picture or video and i reply to it, my reply goes to everybody that originally was sent the picture.

    This is because group messaging is turned on. This means that when you send a text to multiple people they can see who it was sent to. Any response from any of those people will be to sent everybody on the text sorta like CC on an email.  To change this go to Settings>Messages>Group Messaging. If you turn it off you WILL be able to send groups messages but the people you send it to won't see who you sent it to sorta like BCC on email.

  • Why does itunes send me an error message that says to verify my network setting when I try to download updates?

    Why does Itunes send me an error message that says to verify network settings when I try to download updates?

    Disable ALL security software (firewall, antivirus/spyware, etc) when updating.

  • Hi, I am in Winnipeg, MB.  I don't know why they kept sending me a via email about the billing....what's that for?  Carol.

    Hi I am from Winnipeg, MB.  I don't know why they kept sending me an email about the billing so what's that for?  Please help me.  Thanks, Carol

    If they are asking for credit card information it's a scam, not Apple.

  • Why does Mail send two copies of my emails?

    Why does Mail send two copies of my emails?
    Thank you.

    I'm experiencing this issue also. Just one user where I work, Mail in 10.9.3 and Office 365. In-house users only receiving duplicate messages, i.e. the same message twice. Any idea why or how to fix this?

  • Why can I send  but not receive them?

    Why can I send  but not receive them?

    Macrumors posted a solution for this.  I used it and it seems to have worked for me.
    Here's what they said:
    1. Turn off iMessage in Settings > Messages
    2. Reset networking settings in Settings > General > Reset
    3. Reenable iMessage in Settings > Messages
    Source:
    http://www.macrumors.com/2013/09/30/resetting-network-settings-may-fix-imessages -not-working-in-ios-7/

  • Why I cannot send Chinese SMS to China using IPHONE?

    Hi, can anyone tell me why I cannot send Chinese SMS to my friend in China? I can type Chinese character in Iphone after upgrading to Ver 2.0, and send it. But my friend in China said he doesn't even receive it. Any ways to solve? Thanks in advance.

    still not solved can anybody help me?
    I've seen reports somewhere that the SMS network used by ATT does not support Chinese and various other languages yet.

Maybe you are looking for