Receiver file name should contain the same plant value as sender filename

Question

Hi All,
I have a requirement in PI 7.0 and the scenario is synchronous which is as follows:
- XI will read a flat file which has the naming convention Plant_100.txt where 100 is the plant number , after reading the file XI will trigger standard BAPI call to ECC system.
- ECC system will return an response message back to XI , XI need to need write this message in to a log file and the file name should be Plant_100_logs.txt.
- Here plant value 100 is neither passed to ECC system nor this value will be returend back from ECC system . So , is there anyway where we can make sure that plant value can be added to the log file without using an BPM in between ??
Regards
Vinay P.

Answer 1

Hi,
Using Dynamic configuration in Message mapping you can read the source file name and creta the target file name as same as source file.
For BAPI call in Mapping you can use RFC lookup.
So crete a scenario FILE to log FILE
In mapping using RFC lookup make a BAPI call.
And use dynamic configuration to set the file name.
Refer this
http://www.****************/Tips/XI/ASMA/Index.htm