Show history no longer works above enable mode

Question

Somewhere in the 15.2 train I noticed I could no longer see the command history in global config or any other config mode. It only works in enable mode.
Has anyone else noticed this?
Do I now have to enable show history for config mode?

Answer 1

Hi Jason,
I didn't know so far that the output of "do show history" in config mode shows the config commands too, particulary because the command description only says:
To list the commands you have entered in the current EXEC session, use the show history command in EXEC mode.
But your're right, with my 12.4(21) it does:
R1(config)#do show history int loop0 ip addr 192.168.1.1 255.255.255.0 end
However, if they've changed that behavior somewhere in 15.2, there's a simple alternative:
R1#show run | b ^archivearchive     log config      logging enable      hidekeys!R1#show archive log config all idx   sess           user@line      Logged command 1     3        console@console  |interface Loopback0 2     3        console@console  | ip address 192.168.1.1 255.255.255.0
That's even better because the archive remains after logoff.
Hope that helps
Rolf