Using an If-Else type condition in condition step

Question

Hi Gurus,
I am requried to use an If - Else kind of condition before branching out.
I tried using the condition step and parantheses but am not able to figure out how to go about it.
IF you have used a simlar condition before,kindly share with me how I can achieve it.
My requirement is :
IF x = '123' or '456'.
do your work
elseif.
x = '111' or '222'.
do your work(2)
endif.
Thanks and Regards,
Ameya Kulkarni

Answer 1

Hi,
  There must be 4 element x1, x2, x3, x4
  At first select Multiple condition step.
Then in condition Tab select type as Switch.
Then click on the Condition of 1st line.
There a new window open. There click on expression select x1 , click on operator select = ,  click on expression 2 ,  write 123 ,  click on AND/OR, select OR , Then  click again on expression select x2 , click on operator select = ,  click on expression 2 ,  write 456 . 
Then click on the Condition of 2nd line.
There a new window open. There click on expression select x3 , click on operator select = ,  click on expression 2 ,  write 111 ,  click on AND/OR, select OR , Then  click again on expression select x4 , click on operator select = ,  click on expression 2 ,  write 222 .
In this way you can do this.