7940 IP Phone not working across VPN with 861 but works with ASA5505.

Hello, I've been trying to get a basic set up working with the 861w where this is being set up at my home with a 7940 IP phone hooked into it to go across an EZVPN tunnel to connect to my office's uc560.
Now, I have an ASA5505 which works fine, but I'm not sure what differences or tweaks I need to make to get it to work on the 861.
I've attached my 861 configuration.  When plugged in, the IP Phone tries to configure the VLAN and CM List. It just appears to get stuck and starts over.  If I hook up my 5505 instead, it connects and works just fine.
Any help would be appreciated!

Hello!
I think I spoke too soon. I can get calls to initiate and I can hear the other end and complete the calls, but I notice some pings drop when I'm trying to ping the phone system on the other end, and when I try to complete a call, it doesn't hang up when I hang the receiver up. I also see this in the 861w:
Feb 26 06:18:48.823: %FW-4-TCP_OoO_SEG: Deleting session as expected TCP segment with seq:4016134121 has not arrived even after 25 seconds - session 192.168.88.16:51758 to 192.168.248.1:2000
That always occurs after attempting to make a call, which a lot of times goes through, but then hangs and dies.  The missing pings may be the issue, but why when I plug my ASA 5505 in, the calls and everything works perfectly? Do I need quality of service policies or changes to the inspect rules of the 861w?
I have to think it is the 861w configuration since the 5505 works like a charm from my end.

Similar Messages

  • Dear sir I bought my iPhone 4 from Apple store in Charlotte N/C about 2years ago without contract. Now I tried to upgrade it to iOS 7.0.4.but after that my phone not work with last sim card. And invalid sim appeared.so I bought it without contract but it

    Dear sir
    I bought my iPhone 4 from Apple store in Charlotte N/C about 2years ago without contract.
    Now I tried to upgrade it to iOS 7.0.4.but after that my phone not work with last sim card.
    And invalid sim appeared.so I bought it without contract but it seems to be lock in my country
    Please tell me whats the matter?
    My phone serial no  86034HTCA4T
    Modem firmware  04.12.09
    Thanks

    Without contract is not the same as unlocked. The update to iOS 7 relocked
    the iPhone to the wireless carrier to which it was originally locked. You must
    contact that wireless carrier to see if they offer unlocking and if you qualify.
    If you used jailbreak or other hack to unlock the iPhone initially, the method
    used may prevent a legitimate unlock from succeeding and may render your
    iPhone unuseable.

  • I bought iphone 5c 4-5 days back from india and today back button of this phone not working, i am totally dissatisfy with the apple service support. i want replacement

    (i bought iphone 5c 4-5 days back from india and today back button of this phone not working, i am totally dissatisfy with the apple service support. i want replacement.)
    Hello i am nitin from india, i purchased a iphone5c because i heard that iphone comes with a great coustmer service, but this statment becomes totally wrong today, when i faced coustmer executive at service center of iphone then he said that i have to check it out and it may be a physical damage, ( how it is possible even i carried this phone with anti shock cover guard and its never fall down from my hand.) the simple thing i know that i want my phone replaced, otherwise it would be a great mistake of my life to purchase an iphone.
                                                                                          Thanks to all apple team for your wonderful service,

    Welcome to the user to User Technical Support Forum provided by Apple.
    For your issue... See here...
    Contacting Apple World Wide for Support and Service
    http://support.apple.com/kb/HE57
    Apple Warranty  >  http://www.apple.com/legal/warranty/
    iPhone Warranty  >  The warranty is only valid in the country of original purchase... Except for EU Countries...

  • Phone not working after update volume. Battery life resets on own

    Ever since last ISO update phone not working right. Looses volume. Shuts off   Battery life went out to lunch. Texting slow. Any fix yet I see lots of issues. And tec support wants to charge as phone is off warranty. Was working finè before update.
    Very sad customer

    Hello 2canoes and welcome to the BlackBerry Support Community Forums.
    Sorry to hear you're experiencing issues with your device after updating your software.
    It's recommended you contact your mobile service provider for investigation on this matter and to open a support ticket with BlackBerry technical support.
    Thanks!
    -HMthePirate
    Come follow your BlackBerry Technical Team on twitter! @BlackBerryHelp
    Be sure to click Kudos! for those who have helped you.Click Solution? for posts that have solved your issue(s)!

  • Phone not working after OS update, phone not working after OS update

    phone not working after OS update, phone not working after OS update

    I do have a questiion.  I started the most recent iOS update on my iPhone last night and before it was ever completed a message appeared on my screen.  It is a pic of the docking/charging cord with an arrow pointing to an iTunes logo...HELP!!!!!  I have tried holding down the home key and power button several times and the same message continues to appear. 

  • I need help!! I drop my iphone4s in the toilet and its been in rice since Saturday and it wont turn on. I plugged it in and it got really hot. Is my phone not working at all no more.

    I need help!! I drop my iphone4s in the toilet and its been in rice since Saturday and it wont turn on. I plugged it in and it got really hot. Is my phone not working at all no more.

    1lozano1 wrote:
    I need help!! I drop my iphone4s in the toilet and its been in rice since Saturday
    Should have waited at least 4 more days.
    See this -> Apple Service Answer Center - iPhone
    Out-of-Warranty Service
    If you own an iPhone that is ineligible for warranty service but is eligible for Out-of-Warranty (OOW) Service, Apple will service your iPhone for the Out-of-Warranty Service fee listed below.
    iPhone model
    Out-of-Warranty Service
    iPhone 5s, iPhone 5c,
    iPhone 5
    $269
    iPhone 4s
    $199
    iPhone 4, iPhone 3GS,
    iPhone 3G, Original iPhone
    $149
    A $6.95 shipping fee will be added if service is arranged through Apple and requires shipping. All fees are in U.S. dollars and are subject to local tax. When setting up out-of-warranty service, Apple will request credit card pre-authorization for the maximum service fee listed above.  This amount will be deducted from your credit limit. The final service fee we charge will be determined during testing and may be less than the service fee listed above.Certain damage is ineligible for out-of-warranty service, including catastrophic damage, such as the device separating into multiple pieces, and inoperability caused by unauthorized modifications. However, an iPhone that has failed due to contact with liquid may be eligible for out-of-warranty service.Apple reserves the right to determine whether or not your iPhone is eligible for Out-of-Warranty service. iPhones that are repaired or replaced have a 90-day limited hardware warranty or assume the remainder of your standard warranty or AppleCare product coverage, whichever is longer. Please see Apple's Repair Terms And Conditions for further details.

  • BT answer phone not working

    Hi first time post etc. My old landline phone/answer phone wasn't working well so bought new phone yesterday (BT Concero 1400) plugged it into the master socket and neither the machines answer phone or caller display work despite being set up as they should be.    BT helpline not overly helpful - I suspect they wil say third party equipment so no their fault but I've read on other posts that a poor quality line can lead to answer phones not working - any advice?  

    peterg68 wrote:
    Keith, hi sorry I've been out all afternoon!  it just rings and rings until the caller rings off.
    Cheers
    PEte 
    Sorry to ask an obvious question, are you sure that the phone base unit is set so that the answering machine is turned on?
    If it on, it would show "00" on the LED display. If its off, it shows "--"
    If the base station is ringing, and the answering machine part of it is turned on, then it should answer the call.
    Have you tried the answer machine on another phone line?
    Also see http://bt.custhelp.com/app/answers/detail/a_id/10843/related/1
    There are some useful help pages here, for BT Broadband customers only, on my personal website.
    BT Broadband customers - help with broadband, WiFi, networking, e-mail and phones.

  • Head phone not working...

    head phone not working after i update to yosemite , I tried with different headphones but it didn't work. I am able to control the volume with the head phone buttons.

    Take each of the following steps that you haven't already tried.
    1. If your model has an audio-out (headphone) port, and a red light is coming from it, the internal switch is stuck in the position for digital output. You may be able to free it by inserting and removing a mini-stereo jack of the proper size. Inserting any kind of tool in the port may cause damage that won't be covered by your warranty.
    If there's no red light, the switch may still be stuck in the headphone position. Try to free it the same way.
    2. From the menu bar, select
     ▹ System Preferences ▹ Sound ▹ Output
    Check the settings. The internal speakers should be selected as the output device, the Mute box should not be checked, and the volume slider should be at least halfway to the right.
    3. Boot in safe mode. It will take much longer than usual. You don't have to log in; just reboot as usual when the login screen appears. Note: If FileVault is enabled under OS X 10.7 or later, or if a firmware password is set, or if the boot volume is a software RAID, you can’t boot in safe mode.
    4. Reset the NVRAM.
    5. Reset the SMC.
    6. Reinstall OS X after backing up all data as a precaution. You won't need your backup unless something goes wrong.
    7. Make a "Genius" appointment at an Apple Store.
    Back up all data on the internal drive(s) before you hand over your computer to anyone. If privacy is a concern, erase the data partition(s) with the option to write zeros* (do this only if you have at least two complete, independent backups, and you know how to restore to bare metal from any of them.) Don’t erase the recovery partition, if present.
    *An SSD doesn't need to be zeroed.

  • Phone not working after 8.1.1 update in iPhone 5

    Did 8.1.1 update (stupid 1.2 GB) and now phone not working. It give a funny number on My Number

    To add further info: iPhone 5s and using CDMA mobile service. I either get no sim card or no service.

  • Phone not working after 8.1 download cannot unlockit

    phone not working after 8.1 download, cannot get into menu

    To add further info: iPhone 5s and using CDMA mobile service. I either get no sim card or no service.

  • Find my phone not working

    Find my phone not working - Location services on, feature is turned on in Icloud, everything is on for this to work, wifi on too, why isnt it locating my device? Can anyone help?  It is showing offline, even though phone is not.  Please help, thanks in advance bella

    Try turning it off, then back on in Settings on your phone.

  • Ear phone not working

    Ear phone not working when I make phone call I have to use speeker to resive call

    OK.  Thanks for letting us know.

  • My 3G I Phone Not Working With My SIM Card After I Updated my phone

    my 3g iphone now ner not working with my sim card aftet i updated my iphone

    Was your phone originally locked to a different carrier?

  • 2G phone not working with "Dead iPhone" message

    There's an old 2G iphone my son was using, when the phone part just stopped working; it says "no service".  As far as I can tell, everything else is just fine. I used the sim card in a different phone so it's not the card.  With the phone plugged into computer, the device actually comes up as "Dead iPhone" as well as when looking in phone menu under "about", the same "Dead iPhone" descriptor.  Any suggestions on what to try?

    Where do you see "Dead Iphone?"
    It is likely that you're looking at the name of the iPhone.  You see that because someone wanted to title the bacups that are resident on the computer.
    The status of the service is an entirely separate issue.  Contact your carrier, to make sure the SIM card is active on the network.

  • WMI Scripts not Running Across VPN

    Hi
    I have a strange problem where i have 2 sites connected  using  a VPN on 2  CISCO877.  But WMI scripts are not running across the link. if i pull these out an replace them with a Draytek, the scripts run fine.
    Broad Lane LAN ----- Cisco 877 ========= Internet & VPN Tunnel ============== Cisco 877 ---- Southam LAN1.0.39.0/8                      1.0.39.253                                                                                                              192.168.55.1   192.168.55.0/24 The server at Broad Lane is  GIMILI (1.0.39.109) and at Southam is FRODO (192.168.55.4). The following will not work through the tunnel from Broad Lane LAN. Set objWMIService = GetObject("winmgmts:\\192.168.55.4\root\cimv2") if err.number=0 then serverexist=true else serverexist=falsemsgbox(server.exist)
    Is is possible for the  CISCO877 to block WMI traffic?
    Any suggestions please?
    Rgds
    Phil

    Phil,
    Thank you for your question.  This community is for Cisco Small Business products and your question is in reference to a Cisco Elite/Classic product.  Please post your question in the Cisco NetPro forums located here: http://forums.cisco.com/eforum/servlet/NetProf?page=main  This forum has subject matter experts on Cisco Elite/Classic products that may be able to answer your question.
    Bill

Maybe you are looking for