6500 FWSM ipv6 ospf routing equal network cmd

Question

Hi
As I understand there is no "network" cmd in cisco 6500 ipv6 OSPF config, we need to use "ipv6 ospf procid# area #" under interface. I need to config 6500 FWSM to work on OSPF, can anyone help to point out how to configure FWSM ipv6 OSPF? and what are the equal cmds to config OSPF network?
Thanks in advance.
gy

Answer 1

Your configurations are not making much sense.
You have the same vlan interfaces with the same IP addresses on all devices and multiple static routes for 192.168.1.0/24.
This is what you should change -
1) the clients only connect to MSHQ3 so remove all vlan interfaces off all the other switches for the client vlans.
Also remove the server vlan interface off MSHQ3
2) the server vlan only connects to MSHQ4 so remove the server vlan off all other switches and remove all the client vlan interfaces off MSHQ4
3) interconnect all your switches with L3 links because you are routing vlans locally on MSHQ3 and MSHQ4 so there is no need for any L2 links between switches.
Note also in a true routed design MSHQ3 should not connect to MSHQ4 ie. traffic between those devices goes via MSHQ1 and MSHQ2
4) remove all static routes for 192.168.1.0/24 from all devices
5) run OSPF on all devices and only advertise the locally connected subnets off each device.
For the switch interconnects use new IP subnets, don't reuse any of your existing vlan subnets.
If you do all of the above then you have a routed access design with your distribution switches, MSHQ1 and MSHQ2 routing between access layer switches and the router.
If you are trying to achieve something else other than a routed access layer design then please come back and clarify.
But either way what you have now is not good and will not work properly.
Jon