Custom infotype with table

Question

Hi Guyz,
i have to create a custom infotype with a table in it.i have created the PS structure (PM01)with fields a,b,c,d,e. i gave the infotype charac, techn attr, activated the PA table and P structure . In the lay out editor i created a table and put the fields a, b and c. i dragged the input/output field on the table and then dragged the text fileds above them. when i check the layout i get the following error in the flow logic.
Program MP988800 Screen 2000
The field P9888-ZA is not assigned to a loop. "LOOP............ENDLOOP" must
appear in "PBO" and "PAI"
can anyone tell me how and where should i write the code for the table to get activated. Thanks a lot.

Answer 1

HI Ranjeth,
  i have tried the code you provided. I am getting errors.can you please tell me what IT_TBCTRL_BEHAVIOR and IS_TBCTRL_BEHAVIOR are.
i am getting the following errors.
Statement CONTROLS is not defined.
IS_TBCTRL_BEHAVIOR-CODETXT not defined
IS_TBCTRL_BEHAVIOR-RATE not defined.
  i have replaced i_bc_tbctrl with the table name which i defined in the layout editor.  i have put your code in the flow logic. check the code below
CONTROL: options TYPE TABLEVIEW USING SCREEN 2000.
PROCESS BEFORE OUTPUT.
LOOP AT IT_TBCTRL_BEHAVIOR
INTO IS_TBCTRL_BEHAVIOR
WITH CONTROL options
CURSOR options-CURRENT_LINE.
MODULE options_GET_LINES.
ENDLOOP.
        general infotype-independent operations
  MODULE BEFORE_OUTPUT.
  CALL SUBSCREEN subscreen_empl   INCLUDING empl_prog empl_dynnr.
  CALL SUBSCREEN subscreen_header INCLUDING header_prog header_dynnr.
        infotype specific operations
  MODULE P9111.
  MODULE HIDDEN_DATA.
PROCESS AFTER INPUT.
LOOP AT IT_TBCTRL_BEHAVIOR.
CHAIN.
FIELD IS_TBCTRL_BEHAVIOR-CODETXT.
FIELD IS_TBCTRL_BEHAVIOR-RATE.
MODULE options_MODIFY ON CHAIN-REQUEST.
ENDCHAIN.
ENDLOOP.
process exit commands
  MODULE EXIT AT EXIT-COMMAND.
        processing after input
        check and mark if there was any input: all fields that
        accept input HAVE TO BE listed here