Facing problems with network due which the phone goes into hangs status
Facing problems with network due which the phone goes into hangs status. some one help me with switching between 2g and 3G network
Hi Mani Nair,
I apologize, I'm a bit unclear on the exact nature of the issue you are describing. If you are talking about having issues with a 3G cellular data network, you may find the troubleshooting steps outlined in the following article helpful:
iPhone cellular data connection issues
Regards,
- Brenden
Similar Messages
-
The report goes into hang mode
While running a oracle 6i report , the report back ground engine displays the status message Formating page1 for a very long time (about 30 minutes) and finally the report goes into hang mode. What would be the reason ?
mmm..
You know always this kind of problem are easy....
In my case I'm calling the report without the extention (rdf)
Old:
set_report_object_property(repid,REPORT_FILENAME,lower(reportName));
Solution
set_report_object_property(repid,REPORT_FILENAME,lower(reportName) || '.rdf');
$%###$""$"##$%&%%% -
Im facing problem with my back camera.it's keep on hanging
PLease help me fix my problem regarding my back camera because it keeps on hanging.please help solve this problem.
Try:
- Reset the iOS device. Nothing will be lost
Reset iOS device: Hold down the On/Off button and the Home button at the same time for at
least ten seconds, until the Apple logo appears.
- Reset all settings
Go to Settings > General > Reset and tap Reset All Settings.
All your preferences and settings are reset. Information (such as contacts and calendars) and media (such as songs and videos) aren’t affected.
- Restore from backup. See:
iOS: How to back up
- Restore to factory settings/new iOS device.
If still problem, make an appointment at the Genius Bar of an Apple store since it appears you have a hardware problem.
Apple Retail Store - Genius Bar
If the iPod is defective and not abused Apple will exchange your iPod for a refurbished one at no cost -
the iphone goes from recovery mode to some other mode where it keeps restarting with apple logo flashing on the screen continuously. and there is no error in itunes at all which stays in "waiting for iphone" status
Hi there yaswanthfromcumbum,
You may find the troubleshooting steps in the article below helpful.
If you can't update or restore your iOS device
http://support.apple.com/kb/ht1808
-Griff W. -
I was running an app and I tried to open the apps bar at the bottom, but the loading star appears and the phone reports entering into 'safe mode'. It says something about cydia, a program i haven't used but once, a really long time ago. how can i exit the safe mode? should i reset my phone? iphone4
Try a reset by pressing the Sleep/Wake button and Home button at the same time for ten seconds until the Apple logo appears. Note: No data will be lost
-
Bluetooth Audio dropping out when Phone goes into screen lock
I have a 3G running 3.0 and a Sony Bluetooth audio capable car stereo. The audio streams perfectly via bluetooth until the phone goes into screen lock or "sleep ", at which time the audio starts drooping out. As soon as you slide to unlock the screen everything works fine again.
Anyone else with this issue ?Yup, that's exactly what I've had.
I paired a Jabra BT3030 BlueTooth stereo headset module to my 3G and it worked perfectly until the screen went off and then the audio could only be heard intermittently. When the screen came back on, audio was perfect again. This was completely repeatable.
I posted about this the other day, but just prior to that tried again to confirm and I could NOT get it to occur. No matter how many times I put the iPhone to sleep and woke it up, the audio played consistently with NO dropout which is somewhat frustrating and a bit bizarre.
Looks like there is an issue with A2DP if several of us are experiencing the same problem so bug report/feedback to Apple is required I think.
Has anyone else had the problem go away next time you try? -
I spend good money for my iPhone i have the iPhone 5 with the new charger slot which is smaller. I have been through at least 3 charging cords and this is not acceptable to me. i never had a problem with this on my older phone. apple needs to correct this and reimburse me for this cord.
Charging cords are covered by the iPhone warranty or their own warranty
if puchased separately. Take your iPhone and the cords to your local
Apple store for evaluation and possible replacement. -
I am trying to update my phone so I can save my info on my old phone & get a new phone, but I get a error that says "There was a problem with downloading teh software, the network connection timed out.." HELP! Not sure what my settings shoud be...
I never updated anything until now...I want o update my iPhone to the newest version, but i do not want ot loose all that I have on this phone. I was told I needed to update the operating systems so i can put things into the cloud for transport to new phone, but I am just not sure how to do this..Can you help out here??Dear Jody..jone5
Good for you that can't update your iphone because I did it and my iphone dosen't work for example I can't download any app like Wecaht or Twitter..
Goodluck
Atousa -
I have iphone 4 and the software is ios 7.0.2. I am facing problems with my phone. Since the last software update my phone has started giving problems. like it hangs sometime when i recieve an incoming call. The carrier status bar shifts down a bit and sometimes it vanishes automatically. I,m confused.
Secondly i have an update IOS 7.0.4 waiting in my Software Update menu. I have tried so many times to update my iphone but it always fails to update the IOS 7.0.4. Any body suggest anything regarding thisWow. Lots of help. Thanks apple
-
I have purchased my iPhone 4S from USA. Its a Factory unlocked phone. I am facing problem with the hardware. Is there any support that apple provides to send the phone from India to USA to get it replaced? Also if there is any travelers Policy?
No and no.
-
good evening i have an problem with my iphone 4 the wif and network cant on now if i tray is showing iTunes i tray to reload the ios is showing an error -1 can you help me
No problem, glad to help!
Update: my PC USB hub was connected to a USB 3 port, I connected the 30 pin cable directly to my PC, And the restore worked just fine. Restored phone from iCloud backup and seems to be working fine. -
I am having a problem with facebook notifications. The sound doesn't work but appears as a banner. I've tried everything but restoring the phone. Is this a phone problem or an app problem? Has anybody experienced this problem and were they able to correct it?
1) This is because of software version 1.1. See this
thread for some options as to how to go back to 1.0,
which will correct the problem...
http://discussions.apple.com/thread.jspa?threadID=3754
59&tstart=0
2) This tends to happen after videos. Give the iPod a
minute or two to readjust. It should now be more
accurate.
3) This?
iPod shows a folder icon with exclamation
point
4) Restore the iPod
5) Try these...
iPod Only Shows An Apple Logo and Will Not Start
Up
iPod Only Shows An Apple Logo
I think 3,4, and 5 are related. Try the options I
posted for each one.
btabz
I just noticed that one of the restore methods you posted was to put it into Disk Mode First rather than just use the resstore straight off, I Have tried that and seems to have solved the problem, If it has thank you. previously I have only tried just restoring it skipping this extra step. Hope my iPod stays healthy, if it doesnt its a warrenty job me thinks any way thanks again -
hi guy! I have been using iPhone since 2010 but now I'm facing problem with hardware still after i reclaim new iPhone some times my phone just completely blackout!! any idea??
If there is a problem with your AppleID, you - and not the provider - must
straighten out the matter.
AppleID disabled:
http://support.apple.com/kb/TS2446
http://www.apple.com/support/itunes/contact/
https://getsupport.apple.com/Issues.action -
Facing problem with logo in the PDF attachment when sending mail...
hi friends,
i'm facing problem with logo in the PDF attachment to the mail.
my requirement:
1. enter spool number and mail id in the selection screen.
process:
1. now the program will fetch the spool data and converts it to PDF.
2. but when i'm trying to send mail with this PDF as attachment.
when i open the PDF file from the mail, logo is not coming properly (looks disturbed).
can anyone help me how to resolve this issue...
thanks in advance, murashali.hi dinakar, thanks for your mail...
logo looks good in spool/script/smartform.
even it look good when i download this spool to pdf and to the presentation server as pdf file.
i'm using CONVERT_OTFSPOOLJOB_2_PDF.
when i used CONVERT_ABAPSPOOLJOB_2_PDF, is gives a msg - 'spool number not found'.
here i'm using folloing code to pass pdf to the function module: SO_NEW_DOCUMENT_ATT_SEND_API1.
code:
Transfer the 132-long strings to 255-long strings
lt_mtab_pdf[] = pdf[].
LOOP AT lt_mtab_pdf INTO lwa_mtab_pdf.
TRANSLATE lwa_mtab_pdf USING ' ~'.
CONCATENATE lv_gd_buffer lwa_mtab_pdf INTO lv_gd_buffer.
CLEAR lwa_mtab_pdf.
ENDLOOP.
TRANSLATE lv_gd_buffer USING '~ '.
DO.
lwa_mess_att = lv_gd_buffer.
APPEND lwa_mess_att TO lt_mess_att.
CLEAR lwa_mess_att.
SHIFT lv_gd_buffer LEFT BY 255 PLACES.
IF lv_gd_buffer IS INITIAL.
EXIT.
ENDIF.
ENDDO.
NOTE: problem i believe is with ''. i'm getting this tilt symbol () in my pdf internal table. here in the above code the line TRANSLATE lv_gd_buffer USING '~ ' is changing the existing tilt to space. so my logo is getting disturbed.
even i tried with REPLACE this tilt with other char, but it doent work.
can you give any idea... -
my phone has been losing calls and according to the apple store i need to reset it due to a software fault - i have done this and still have the same problems. how do i reset the phone without reinstalling the soft ware fault by way of icloud backup
Well, it appears that your backup is corrupt, thus causing your issue. So, you'll have to restore as a new device, & not from backup. Follow this by syncing your content back to your phone:
http://support.apple.com/kb/ht1414
Do not restore from backup.
Maybe you are looking for
-
Hi Experts, I have posted one document with amount of USD 30000.00 against 30001 Fund center ... Document Number is :- 280000001 same amount has released as consumable amount ,release document number is :- 29000001 Now i am not understand why system
-
Is there a way to map videos in a 3D environment?
Sorry, this is kinda hard to explain. Is it possible to have the area in which you put clips be a 3D environment. For example, could I put several clips around eachother in the shape of a sphere and scroll the camera around the sphere? If this is
-
When I use my dvd on my Imac I get a system error for the visualisor when switching to apple TV
When I use my dvd on my IMac I get a visualisor system error when I activate Apple TV
-
IPad - computer is not authorised error
Purchased 3 series of the same program from Itunes. Series 1 copied but series 2 & 3 won't copy to ipad 1, error message is that the computer is not authorised. Had the same problem with the apple tv and had to buy a tv show from the apple TV to so
-
How to start service to run Discoverer Viewer on 10.2 EE on web-port 7778?
I have installed 10.2 EntEdition db on Windows, with OLAP and DataMining options "on", and wish to know what steps can enable me to run Discoverer Viewer (for example, http://mymachine:7778/discoverer/viewer ). What service must be turned on for ther