How To Disable Verify Database Message Alert

Question

How To Disable Verify Database Message Alert?
I have a VB6 open Crystal Reports using Crystal Reports XI R2 (SP5) and almost every time I open a report, I get an alert message about the table has been changed and I have to click "Ok" to make it goes away. Is there a way to  disabled this alert or set default to "Ok" so I do not have to  click this message every report. Thank you very  much.

Answer 1

Hello,
You must verify if the database has changed so you can't disable the message. CR must match what the DB is using or the reports will fail or return wrong data.
It's odd that even after verifying the DB in the designer your app still needs it to be verify the report. You did save the report correct?
Also:
Dim CRApplication As CRAXDDRT.Application
Dim Report As CRAXDDRT.Report
Is the report creation engine and you should be using craxdrt.dll. You need to be licnesed to use craxddrt.dll and this may cause problems for you later when deploying.
Use:
Dim CRApplication As CRAXDRT.Application
Dim Report As CRAXDRT.Report
The mapping is not a switch you can turn on or off but it is Event driven. You need to add code to the viewer section to capture the event if the mapping event fires. Then you can set it to the way you want to use it.
I suggest you purchase a case on line and get to the Report Design team to figure out why when you verify the report your app still thinks it needs to be verified. Something going on in your report that the forum makes it difficult to debug the problem. You can't attach files to forums.
Link to Single Case purchase:
http://store.businessobjects.com/store/bobjamer/DisplayProductByTypePage&parentCategoryID=&categoryID=11522300
Thank you
Don