HT201263 My 3GS has gone faulty. It won't power up and with a wall charger connected, only gets as far as the apple logo. It then makes a vibration noise and shuts down again
Hi guys, looking for some assistance with my 3GS. A few weeks back it started playing up. Shutting down suddenly and the like. Now, it's failing to start up. When I connect it to a wall charger, the apple logo comes on and after a short while it vibrates and then gives the 'connect to iTunes' message. The minute I disconnect from the wall, it just shuts down. If I keep it connected at the wall it goes through the above sequence before shutting down and repeats the cycle again and again.
I've tried all the 'recovery' methods without any success. The device is not recognised by iTunes. I've taken it to small independent repair outlets who say they can't repair it. Is there anything I can do or is it totally gone for good?
It MAY have a bad battery, and that may be all it needs. But you can't find out until you replace the battery, and then you might find out it's something different. It's a 4 year old phone; consider getting a newer model. If you take it to an Apple store they should be able to diagnose it. Make a Genius Bar appointment before going to avoid a long wait.
Similar Messages
-
I recently updated a app on my iPad 2.it asked me to turn it off then on so I did .now every time I turn it on the apple logo appears then it automatically shuts down an does the same untill the battery's gone ?
You probably need to restore your iPad now. Pay attention to the last part of this kb article where it explains about using recovery mode. You may need to restore the iPad using that method.
iTunes: Restoring iOS software -
I just upgraded to Snow Leopard then Lion and the computer shut down after installation.
Now when it starts up it gets as far as the apple icon and then shuts down again
whenever I turn it on it loads that far and then closes.
HELP!Restore your bootable backup/clone or Time Machine backup of Snow Leopard, launch Disk Utility from the install disc, repair the boot volume, and reinstall Lion.
-
when i try starting my IPod it won't start, the Apple logo comes up for a few seconds,and then. it just shut off . I tried to charged it through an outlet, the IPod didn't eve charger so I tried to restore my setting in my computer, i tunes won't
But that requires the computer to see the ipod. I am having the same problem and I keep being told to restore it, but you have to either get the ipod to turn on or have the computer see it in order to so that. Right now I have a pretty useless 32GB ipod touch cos I cant get the thing to turn on! I can only get the apple logo for like maybe 20 seconds and it goes away. Ive charged it for days on a wall charger, on the computer usb charger, and on a speaker charger. Nothing works.
-
I have got a 13 inch MacBook Pro and it got stuck in a loop so I switched it off by holding the power button down and now when I switch it on the apple logo appears then I get a blank slot at the bottom of the screen then the circle appears and rotates and then it switches off again, I have tried starting it again with the system disc that came with it when it was new but it makes no difference. Is there a sequence that I can use to force it to start.
Sorry. We can't help you. It's no longer an iPhone. Apple won't touch it.
Take it to whoever replaced the screen and see if they can help you.
iPhones are not user servicable and Apple does not sell iPhone parts at all. I'd be surprised if you were actually able to back it up at this point. It sounds like it's completely borked. -
My iPod touch got restarted and frozen on the apple logo screen after I erased all content and settings. And it got restarted and frozen again every 5-10 mins until low battery. It also doesn't recognize by iTunes. Did any one has the same problem? And how did you solve it? Thank you.
Try here:
iOS: Not responding or does not turn on -
i spilled a pop on my ipod and it froze up. the screen was loced on the battery symbol sign and i forced a shut down. It tunred off and wont turn on. Later a white screen popped up and after the apple logo popped up and dissapeared. I have tried to connect it to my computer and it said that the iphone(itunes read it as such) was in recovery mode. How do I get this thing to work again?
Leave the iPod off and place it in a container with dry rice to absorb moisture. Let it thoroughly dry.
Realistically, the chances of it working correctly again are slim, especially if the pop was sugared. -
my ipod won't respond to me or my laptop. it has been flashing the apple logo for an hour maybe. some one please help. i really don't want to lose my baby.
Try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar -
My ipad2 has suddenly decided not to connect to the internet either through Safari or email. My WiFi signal is strong and all other devices in my house are connecting ok. I have tried pressing the home and off buttons together to get the Apple Logo but this has not changed anything, still cannot connect. "Safari cannot open the page because your ipad is not connected to the internet"
I have done this and no difference
I have just realised what has caused the problem.
Yesterday I fitted an additional Homeplug with built in wireless N adapter ( I alreday have another type fitted from my main router position) The wireless system to my ipad is obviously "confused" . Having now removed the second homeplug and reset my ipad all is now ok -
Trying to update to iOS 8 and the phone keeps showing the Apple logo, then dimming after a number of minutes then showing it again.
Hello cgb1508,
Thanks for using Apple Support Communities.
From your post I understand that your iPhone will not boot past the Apple logo. To troubleshoot this issue please follow the steps in the support article below.
iOS: Not responding or does not turn on
Take care,
Alex H. -
My ipod touch 3rd generation shut off when the battery died. When i tried to charge it but it would not charge and it wasn't recognized by my laptop. This happened once before and it charged after sitting for a day. So I tried it again but it didn't work. I don't know if it is still covered, I got it last july as a replacement for one that broke. Help!! Please!!
Try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- Try another cable
- Try on another computer
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar -
My iphone4 has the correct Apple ID in the information settings section and asks me to login to my ID most of the time but when I try to update my apps, it asks me to login with an ID that isn't mine. I deleted the wrong ID from my itunes but it still won't let me login with my own ID to update apps. How do I get my iphone on the same page?
How did you obtain these apps? All apps are DRM protected & tied forever to the account used to originally obtain them. They cannot be transferred to another Apple ID(account), nor can they be updated using any Apple ID other than the one that was used to originally obtain them.
-
Left fan in my MBP makes some weired noise when shutting down
Hi, my model is 2.4 Late 2008, few days ago the left side of my mbp dropped on the table because I forgot to take out the headphone when I stood up.. Now every times I turn off the computer, the left fan makes noises that sound like the fan is touching to the cover (when the fan slows down). What should I do now?
Thank you very much.Welcome to the Apple Support Communities
Take the computer to an Apple Store so they'll repair the Mac -
hi im stck with my i pad and i cant access it through i tunes because i have a passcode on it can anyone help me?
If a reset doesn't work, try and force iPad into Recovery Mode:
1. Turn off iPad. Press and hold the Sleep/Wake button for a few seconds until the red slider appears, slide to turn off.
2. Connect USB cable to computer
3. Press and hold the Home button down and connect the docking end of cable to iPad
4. Continue holding the Home button until you see the "Connect To iTune" screen
5. Release the Home button
6. Open iTune (make sure you have the newest version of iTune)
7. You should see "iTunes has detected an iPad in recovery mode"
8. Use iTune to restore iPad
Note: You need to be patient and repeat the above many times to recover your iPad -
How is a 4S iphone reset when it is stuck on a picture of a blue music circle, the word iTunes under it, and a cable pointing to the circle.
It's trying to tell you to plug it into your computer running iTunes. It's in recovery mode and needs to be restored.
Maybe you are looking for
-
How do I connect dual link dvi to hdmi so I can use my TV as a monitor?
I have tried to google this for some time and have gotten nothing but conflicting responses. I have a 15" macbook pro with a dual link dvi port. I want to connect it to the hdmi port on my HDTV. What do I need to make that happen? Is there actuall
-
T510 entry not present on particular date
Hi all, I have created paysacle type , pay Scale Are , Pay Scale Group and it level and has assigned it in PA30 for infotype 0008 along with the country grouping . But i am getting an error saying ' No table Entry inTable T510 for the Key county grou
-
Solaris 10: Remote Display of JDS rel 3 and CDE over Xwindows
On an Ultra 5 running Solaris 10, I want to start a session of either Java Desktop System Release 3 or CDE and display it on another system running an Xwindows server (running on a Windows box, but I don't think that matters). I also don't want to ad
-
Hello Can we extract data from BC sets (Business Configuration sets) into the SAP BW. Thanks in advance Regards Shiva
-
Two NWDI systemes in one landscape
Hi all, I was wondering if it is possible to have two NWDI systems in one landscape (sharing same SLD) and do track forwarding between these two NWDI systems? The reason I want to do this is that I want to move the NWDI system to another platform. To