I have a 5 month old Magic Mouse and I want to replace the batteries for the first time but the battery door will not release any suggestions?
The battery compartment door on my Magic Mouse appears to be jammed shut and will not open, the device is only 5 months old and this is the first time I have needed to open it to change the batteries. Are there any suggestions?
It could be you are approaching it incorrectly. It can be a tricky little gadget that actually works with minimal pressure.
Try turning over the mouse so the compartment panel faces you, optical sensor topmost. Then holding the mouse at each side but not on the panel itself, flick the small, black rectangular panel downwards. The top of the panel should spring out, though it may require you to manipulate it fully away from the mouse.
Once you have replaced the batteries, starting at the bottom reverse the procedure then clip into place. Remember to move the small switch next to the optical sensor upwards which should turn on the green light. Then click twice to connect.
Similar Messages
-
I have an iMac with a Magic Mouse, if I want to upgrade my iMac to the OS X Lion, will I have to buy a Magic Trackpad?
Expanding on what Barry said, Lion includes features specifically for trackpads, but it's by no means necessary to have one. A Magic Mouse will work just fine (as will any other mouse or trackball).
Regards. -
i have all my music on my old computer but the port broke on the old computer and i want to put my music on my new computer but the usb port is broken on the old computer
See:
Recovering your iTunes library from your iPod or iOS device: Apple Support Communities -
i have had my iphone 4s for less than 3 months and i always have it in a protective case, recently my bluetooth that i use daily will not stay connected, my alarm clock will not ring, any suggestions on whats going on??
Basic troubleshooting from the User's Guide is reset, restart, restore (first from backup then as new). Try each of these in order until the issue is resolved.
-
I have two different accounts with I-tunes and I want to link both purchases for my music to one account. How can I do this?
You are going to need to change the email address you use with your old ID. Once you have got access to your old account you will then log into both accounts at the same time on your Mac and transfer your data to a single account. We can do this later, but need you to get access to your old account first.
My Apple ID -
Hi, I have a mac book pro running mavericks and recently tried to connect to a 3rd gen apple tv but the airplay icon is not showing up in the top bar. I then tried my girlfriends laptop running mountain lion and it showed up straight away. Any suggestions?
How old is the MacBook Pro? AirPlay is only supported on 2011 and newer models, due to the requirements it has in hardware for graphics acceleration.
-
Premiere Elements 13 issue with the mouse on MAC OSX Yosemite 10.10.1
When I select a clip of video and move to a different place in my time line, Premiere Elements 13, will not release the clip from the mouse.
The clip follows my mouse movements and goes to other places in my time line.
I try to delete these extra insertions, but the mouse will not release the clip.
Action I’ve taken: I’ve re-installed Premiere Elements 13. Problem remains.
This issue has consumed too much of my time and does not go away. It ruins my video.
Help please.
ThanksI tried using the Guest Account on my Mac. In the Guest Account, Illustrator works perfect!
Then I started wondering what processes (tools/tweaks) I run by default on my account. Turned out the problem was called by a little background tool called RightZoom. RightZoom let's the green 'zoom' button always maximize your current window.
So thanks! Problem solved! -
I have pending app updates that will not update, any suggestions great fully received
I have pending app updates that will not update, any suggestions great fully received
Try This...
Close All Open Apps... Sign Out of the Account... Perform a Reset... Try again...
Reset ( No Data will be Lost )
Press and hold the Sleep/Wake button and the Home button at the same time for at least ten seconds, until the Apple logo appears. Release the Buttons.
http://support.apple.com/kb/ht1430 -
I have Windows 8.1 on my PC. Ever since downloading the latest version of i Tunes, it will not recognize any of my i Pods (3) and therefore am unable to sync any music from my i Tunes to the i Pods. I've tried all the obvious things like resarting the PC as well as the i Pods tried different patch cables but the i Tunes software will no longer recognize my i Pods. I have automatic sync selected, but I even tried to manually sync by clicking on devices under File but the sync icon is "grayed" out. When I look under Preferences and click on devices the serial numbers of my i Pods appear and are correct but again will not recognize the i Pod when plugged in to the PC. Bottom line I'm dead in the water....appreciate any suggestions....thanks
Hi 78causeway,
Thanks for visiting Apple Support Communities.
I recommend going through the troubleshooting steps in this article if your iPhone is not recognized by iTunes for Windows:
iOS: Device not recognized in iTunes for Windows
http://support.apple.com/kb/TS1538
Best,
Jeremy -
I've just discovered that different typefaces seem to have different auto-leading in Pages. I am used to default leading being 120% of point size (or some consistent rule), but it seems this is not so any more. The same text in 10pt Times New Roman, which I would expect to line up with 10pt Palatino, for example, doesn't. I've tried using the inspector, at least to get both faces to behave the same for given settings, but I haven't been able to. How much control does Pages allow for this type of settings, and are there any hidden secrets as to how to do so? Many thanks
Message was edited by: Just me thenIf you set the line spacing in the inspector to Exactly and 12 points for 10 point type, it will work the way you want.
-
Hai, I had been using my magic mouse almost two years now. I may not the cleanest user, i admit. But today, i found that my magic mouse looked like a boiled egg, it was yellowish spot on the inside, I don't know why, it works fine. But i'm just worry there had been some some electricity problem on the inside.
Thank you.I had this happen as well. after I replaced the batteries it went to acting strangely. Same thing on glossy surfaces only.
This happened once before, and I thought it was broken, and just like pepi70 I think I remember an accidental drop fixed it before, wondering if I should drop it again, I have already tried banging it lightly with my hand to no avail.
Maybe more people have had this problem but didn't think to try it on glossy surfaces. Very strange it only works on glossy...
Anyone find a good solution? -
I have just got an old ibook 4g and i want to know what os system i can run on it please
i have just got an old refurbed ibook 4g and was wondering if anyone out there would know what os system i can run on it pleased
Hello,
Depends on which version of the iBook G4 you own. If it greater than the 800Mhz model then you could install Mac OS X 10.5 (leopard) Otherwise it would be Mac OS X 10.4 (Tiger)
There are alterative PPC versions of Linux like Ubuntu that could also be installed as an OS
Best of Luck -
I have a macbook pro, and i want to transfer my hard drive from my macbook (500g), but the display drivers and such are different. How do i do this and is it possible?
The Macbook Pro has Mac OS X 10.4.11 (70g hard drive)
The Macbook has Mac OS X 10.6.8 (500g hard drive)The MacBook's hard drive lacks the necessary hardware drivers to boot the MacBook Pro even though it has a much newer OS on it; that's why simply moving it into the Pro doesn't work. Presumably you have a very old MB Pro, because only the very first MB Pro model (produced January to May 2006) was ever offered with an 80GB hard drive. Are you sure you want to move your big drive into such an old machine? The MacBook must be newer, because the first MacBook was introduced just as the first Pro model was discontinued.
-
I have a 2nd generation iPod that won't do anything but display the Apple logo for a brief second then an image of the cord suggesting it should be connected to iTunes. I tried to restore it via iTunes but I get an Error: 1611. It does nothing else. I tried turning off using both buttons...nothing. Any suggestions?
Error 1611: This error may indicate a hardware issue with your device. Follow the steps in this article. Alsoattempt to restore while connected with a known-good 30-pin Dock Connector cable, computer, and network to isolate this issue to the device. The MAC address being missing or the IMEI being the default value (00 499901 064000 0) can also confirm a hardware issue. Out-of-date or incorrectly configured proxy or security software, such as FoxyProxy, can cause error 1611. To troubleshoot third-party security software, follow these steps.
Above from:
http://support.apple.com/kb/TS3694#error1611
Note it could be a hardware problem -
Some of my HD movies will not play in WIndows 8.
This is for the Windows 8-8.1 users out there: If you have the Pro version of Windows 8 and just recently upgraded, Microsoft automatically includes a Virtual Machine package called Hyper-V client. It doesn't ask you if you want to install it, it just does.
This may also apply to Windows 7 users who may have inadvertently installed some version of Hyper-V on their computer.
The Hyper-V package installs a secondary video driver that breaks HDCP, which means you can't play HD movies even on a compliant system. You need to get rid of it. To do so:
Go to Control Panel
Programs and Features
Turn Windows Features on or Off
Uncheck "Hyper-V"
Reboot.
This applies to almost anything that requires HDCP, so if you're having trouble with Blu-Rays or Amazon Prime, that's likely the culprit.
Maybe you are looking for
-
Error reading in file data on second entry and save of the data
Hi, I'm trying to write a class that will save two integers and a string to a text file, which can later be searched. Both integers and the string are input by the user in the main class via the keyboard. The file is saved as follows, 100 1 901,111,o
-
Continious data range algorithm
I have in my database table 2 important date columns: StartDate (Not null) and EndDate(Allowed Null). I want to ensure that all records in the table would always create perfect contiues date ranges with no holes inside. Wor example there may not be r
-
How do I setup multiple users on 1 icloud
I am trying to figure out what the best setup is for the following: Myself: Ipad, Iphone 4s & ipod, apple tv Wife: iphone, ipod I am trying to have all our photos, music, etc be available on the cloud so that we have access to each others music and p
-
is there a way if apple can reset my ipod touch 2nd gen MC model back to 3.1.3? because iOS 4.2.1 is slow on my ipod and i cant deal with also i cannot afford a new ipod at the moment. also 3.1.3 was my default iOS when i first activated my ipod touc
-
hi, I wrote one source code in RFC which gives output as dynamic table. I want this dynamics table as output of RFC. In RFC, Table parameter does not support TYPE u2018ANYu2019 to define Table as Dynamic. During runtime, RFC Code supposed to identify