I have Power Mac G5 1.8 single. I have a problem with ethernet port, before it was working with the internet, but now i shows it is connected even the cable is disconnected. I'm running Leopard 10.5. any help
I have Power Mac G5 1.8 single. I have a problem with ethernet port, before it was working with the internet, but now i shows it is connected even the cable is disconnected. I'm running Leopard 10.5. any help
Reset the PRAM.
http://support.apple.com/kb/HT1379
If that fails, reset the PMU.
Scroll down the following page and click the G5 link for instructions:
http://support.apple.com/kb/ht1939
Similar Messages
-
Hi, I'm working on an Imac, yesterday email was working fine, now nothing is happening. It says that I need a password to check details - this I can't remember, it doesn't seem to be the same as the one I use to log on to mail through browser (talktalk) - message says can connect to internet but error with port settings etc which need verifying. Talktalk unable to help further - but as I can't get past password page I am very stuck. Any one help as to how to find out password.... have tried to make a new account but that doesn't seem to wrok either. Am wondering if fault is with computer. Thanks.
imac 10.10.1TalkTalk E-mail Setup See post by Csound1
-
I have bought the wireless keyboard for my iPad. I was working for a day but now the power light won't stay on and as such won't connect to the iPad. I have changed the batteries but still no difference.
Not knowing which wireless keyboard you bought, it is difficult to be specific. but ...
it is quite normal for the keyboard's power light not to stay on - it is a way of conserving battery power.
Try this:
turn you keyboard off
on your iPad go to Settings > Bluetooth
if your keyboard is listed under Devices, then touch the little blue i to its right and choose Forget this Device
now reset your iPad: hold both the Home and Power buttons down for about 10 seconds until the Apple logo appears, let go promptly when the Apple logo appears and wait another 30 seconds for your iPad to turn itself on
After your iPad is back on again go back to Settings > Bluetooth
now turn your keyboard back on and see if it appeard under Now Discoverable
if it doesn't read your keyboard guide to figure out how to put it into Discovery mode
touch the listing for your keyboard under Now Discoverable, it should now appear under Devices
touch the listing for you keyboard under Devices, and choose to pair with it. -
I was given a new phone because of a technical problem with my other. Everything was replaced because of iCloud but now it is telling me I do not have enough storage room on this phone to perform a back-up. Can I fix this?!
Why don't you call Apple tech support thru your provider. They will be able to help you in short order.
PS - If you want help here you need to provide a little more information i.e. how much memory does your iPhone -4- have and how much free memory do you have after restoring from the cloud? -
hello i hav an ipad mini and i was in the middle of the ios 8 update and i held the sleep and home button at the same time to cancel the update and now it wants me to connect to itunes i dont no how to do that can someone pleaze help me?
RECOVERY MODE
1. Turn off iPad
2. Turn on computer and launch iTunes (make sure you have the latest version of iTune)
3. Plug USB cable into computer's USB port
4. Hold Home button down and plug the other end of cable into docking port.
DO NOT RELEASE BUTTON until you see picture of iTunes and plug
5. Release Home button.
ON COMPUTER
6. iTunes has detected iPad in recovery mode. You must restore this iPad before it can be used with iTunes.
7. Select "Restore iPad"...
Note:
1. Data will be lost if you do not have backup
2. You must follow step 1 to step 4 VERY CLOSELY.
3. Repeat the process if necessary. -
I have to reenter my Wifi password every time I restart my Ipod touch. It used to retain the password but now it drops out when I turn the Ipod off. Any suggestions?
Try:
ipod touch wont remember wifi password: Apple Support Communities
Also, have you looked at the previous discussions listed on the right side of this page under the heading "More Like This"? -
i have a problem when i am connecting my mbpr to a monitor , the internet is going very slow when i connect to the monitor plz help me if i buy a vga to minidisplay it will help??
dovdov2,
are you saying that when you connect your MacBook Pro to a monitor, your Internet connection slows down, but when you disconnect the monitor, it speeds up again, and that this is reproducible from one day to another?
Does this happen both under OS X and under Windows 7, or only under one of them?
How are you currently connecting your MacBook Pro to your monitor? -
I HAVE WI FI MY IPAD USUALLY LETS ME CHECK MY EMAIL. BUT NOW IT KEEPS TELLING ME CONNECTION TO THE SERVER CANNOT BE FOUND
1. Turn router off for 30 seconds and on again
2. Settings>General>Reset>Reset Network Settings -
hey, i attempted to download mac os 10.7 so my itues would work and now my safari wont work, is there anyway i can go back to an older verison just so i can have internet as when i go to click on safari it comes up with an error saying 'you need to download mac os version 10.7 for safari to work' i really need the internet as i have GCSE's in 17 days can anyone help me get my safari back please.
Beginning with Firefox 4, Macs must have an Intel x86 processor ('''''which you have''''') '''''<u>and</u>''''' OSX 10.5 or higher ('''''which you do NOT have''''').
*System Requirements: [https://www.mozilla.org/en-US/firefox/4.0/system-requirements/index.html Firefox 4] [https://www.mozilla.org/en-US/firefox/5.0/system-requirements/index.html Firefox 5] [https://www.mozilla.org/en-US/firefox/6.0/system-requirements/index.html Firefox 6] [https://www.mozilla.org/en-US/firefox/7.0/system-requirements/index.html Firefox 7] [https://www.mozilla.org/en-US/firefox/8.0/system-requirements/index.html Firefox 8] [https://www.mozilla.org/en-US/firefox/9.0/system-requirements/index.html Firefox 9] [https://www.mozilla.org/en-US/firefox/10.0/system-requirements/ Firefox 10]
'''''The good news''''' is that Firefox 3.6.x still supports OSX 10.4 and Macs with the PPC Mac or Intel architecture. '''''The bad news''''' is that support for the Firefox 3.6.x series is likely to end in the first half of 2012.
*System requirements: [https://www.mozilla.org/en-US/firefox/3.6/system-requirements/index.html Firefox 3.6.x]
*Download Firefox 3.6.x: https://www.mozilla.org/en-US/firefox/all-older.html
*Also see --> http://support.mozilla.com/en-US/kb/Installing+Firefox+on+Mac
Updating your OSX to 10.5 or newer will allow you to use Firefox 10.
*Also see news about latest OSX version --> http://www.tuaw.com/2012/02/16/mountain-lion-drops-support-for-several-older-mac-models/
'''If this reply solves your problem, please click "Solved It" next to this reply when <u>signed-in</u> to the forum.''' -
Help - my FaceTime was working, but now isn't connecting. It goes through all the motions, but doesn't connect. Can anyone help?
FaceTime for Mac: Troubleshooting FaceTime
-
can momebody tell me what to do to get connected to the internet?i just got an Ipad2 16gb,i have a strong WIFI signal.two other computer working in the house.
If you have what appears to be a strong signal, but it reports no Internet, then your router is not giving your iPad a connection and the iPad is self assigning an IP which falsely reports a strong signal. Go to Settings/Wi-Fi and tap the arrow to the right of the LAN to which your iPad says that it is connected. If the IP is 169... then you are not getting an IP from your router. Try resetting the router, updating the firmware or restoring it to factory settings. Some older routers do not like newer machines.
-
My WiFi will stay connected for some time but then when it goes to sleep or randomly it will turn itself off. I used to have to restart the computer a few times but now its telling me WIFI:No hardware installed Please help
My WiFi will stay connected for some time but then when it goes to sleep or randomly it will turn itself off. I used to have to restart the computer a few times but now its telling me WIFI:No hardware installed Please help
-
When I log into Pogo it will not let me play on-line games. Oops, something is not right...
Java Not Found or Not Working
Explanation:
This error means Java (one of the technologies built into most browsers) is not working correctly on your browser.
You must have Java installed on your computer in order to run Pogo games, and it must be functioning properly. Either you don't have Java installed yet, or the Web browser you're currently using doesn't support Java or you have Java (or Javascript) disabled in your browser.
How to Fix the Problem:
Java is a free download that is required to play Pogo games. Not all computers come with Java pre-installed.
If you haven't played Pogo games before and are getting this error, you probably just need to install Java on your computer.
For instructions on installing Java for your operating system and browser click here.
If you believe Java might be installed but disabled for your browser, please be sure to enable the plugin for your browser. If you need help, click here.
If you already have Java installed and it is not disabled, your Java may be out-of-date or is no longer working. In that case, your Java might need to be upgraded or reinstalled. If you need help, click here.
I have done what they say but I still cannot get on-line like I was able to about a week ago.
Do you have any suggestions?This has been fixed in Firefox 3.6.15, use the "Check for updates" option in the Help menu to install it.
-
The Wi Fi is on, but the app doesn't even show up onthe device. On my computer in purchased, it shows it's downloaded. Now what?
The requirements for that app state that you need a 3rd-generation or 4th-generation iPod touch, with iOS 4.2 or later. Is what what you have?
-
HELP
Exactly how are you trying to update? OTA (over the air) via the device? If so, instead try to update by connecting the device to your syncing PC with the latest version of iTunes installed.
http://www.apple.com/itunes/download/
Maybe you are looking for
-
Hi Fnrds, When in execute the MB5B Report for one of my finished products , i get some variations . In the Stock type tab i have two options : a) Storage Loc/batch stock b) Valuated Stock . When i execute( Current month ) this repot with option A a
-
Pricing Conditions and how the pricing date is determined
Hi all, Small question, i ahve some pricing conditions that use the Serives Rendered date and others that use the Pricing Date from an order, how is the condition decided on what date it uses? Hope i have expplained this ok, if not and you need more
-
I am using 10.2.0.1 database instance and wrote a SQL query which involves several tables but I had made sure all columns in where clause has got proper indexes. The query is fairly simple does not use any function etc. in where clause but inner join
-
SNMP Trap on AP Max associations reached
Hi all, I want to be able to send snmp traps to my NMS alerting our NOC to when we reach our configured max-associations on an ap. We currently use both 1130 AG and 1140-2N in autonomous mode, no controller. I have found a debug command "debug dot1
-
Inventory Management :Delta IP of BF runs with selection from Init IP of BF
I have an init IP for BF DS which i ran with selection on posting date. I have another IP for delta for BF without any selection criteria. But, when i run the delta IP, it runs with the selection on posting date, the same value that i used for init.