I turned on my iphone this am and the screen display is larger than the phone and I can't resize it. How can I make it smaller?

The screen display on my iPhone won't resize. How can I make it smaller?

You have Zoom on... double tap with three fingers to turn it off.   Go into Settings > General > Accessibility to disable it.
See p. 243... http://manuals.info.apple.com/en_US/iPhone_iOS4_User_Guide.pdf

Similar Messages

  • I was holding my i phone in my hand for a while and suddenly the screen is very large...what do i do??? how do i reboot???

    I was holding my iphone in my hand for a while and suddenly the screen is gi-normous...what do I do??? how do I reboot???

    to reboot you hold the power on/off button and the large home button together until you see the little apple logo.
    However if you take three fingers together you can tap the screen back to its former size.
    See article below.
    My iPhone Icons Are Large. What's Happening?
    Good Luck

  • I have an iphone 4 and it has tiny spots on the screen that is brighter than the screen's brightness

    The title says it all!
    is there a way to fix this problem?

    Those are probably stuck pixels and if so are a defect in the screen. If that is indeed the case, it's not something a user can fix. Call Apple Support or make an appointment at an Apple Store and discuss theproblem with them.
    Regards.

  • I have created a .m4v file from iPhoto and would like to share it with someone else knowing that the file is quiet large (86 Mo), i used to share file with mobileme, how Can I do that with iCloud ? or another way....

    In iphoto, I have create a diaporama which I exported to itunes as a m4v file. I would like to share this file with someone but it is too big to send it via email (84 Mo). This file is now in my films in itunes. Is there a way to share it via icloud.
    I used to share files using mobileme which I cannot use anymore.
    Thanks for your help,
    Eric

    How recently did you switch?  If it's less than 60 days, then Verizon simply reinstates your previous account.  The fact that you were on the EDGE plan and mailed the devices back, and they apparently are somewhere in the system, could cause complications, and it might just work out that you just go back on the same plan and they set you up with the same devices.  I'm not sure how it will go - but since you are still being billed for the devices... 

  • How to create a map that is larger than the game in width and height?

    hi,
    i wounder how i can create a map(not the design) that is larger than the game in width and height, part of it will appear in the main page and anther part you can move to it after you press the arrow symbol, but the map is just one image so i want put it in line and out line the game page, and the out line part includes buttons and symbols the player can use, but it will be in line and the other part will be out line when you press the left arrow or the down arrow, how i can do that?
    and is that possible to animate it so when the player press the arrow, will give it action to start the animation in one sec, i know how to animate it if that possible but i don't know which code i will use for the mouse click with the arrow symbol, and how to use the same code in the same symbol to start anther animation depending on which part of the map is on?

    I don't know a lot about mask and masked layers and how to work with the normal layers beside i will use some 3D graphics but not in the background, i will explain all this to you to be more clearly.
    first i am using action script 3.0
    close ex,
    you have 2d map"image"  900*300 pixel.
    this image contains some 2d symbols when you click will go to anther normal map (anther normal layer) so they must appear.
    your game 320*320 px, and the place the map will show on 300*300, and there's basics objects will be in most pages including the page that show the map so i don't know a lot about how this will work with mask layers.
    so you can only see the left side of the map image and what it contains, while there's two arrows one to the left and one to the right there's three cases here,
    first when it show the left side(start from x:0 to x:300), the left arrow will not active when you press and the right arrow will start an animation that make the map image move to the mid side in one sec when you press.
    in mid side (start from x:301 to x:600) the same left arrow will active when you press to send you back to the left side while the same right arrow will be active to send you not to the mid side but to the right side,
    when moved to the right side the same left arrow will be active to send you to the mid and the right will not active when you press and depending on that,
    first how to make the large image appear with the three sides in the same place without effecting the other objects "like disappearing them" ?
    and the codes i need in the same left or right arrow symbol to make different actions with the same symbol when clicked depending on which part of the map is on.

  • HT5622 We have two iphones with the same Apple ID. Since I installed iOS this morning I have started receiving all my sons texts and when I send him a text it is delivered to both of us. How can I remove my phone from the joint Apple ID and remove myself

    My son and I both have iphones with the same Apple ID. Since I installed iOS this morning I have started receiving all my sons texts and when I send him a text it is delivered to both of us. How can I remove my phone from the joint Apple ID and remove myself from finding out what he is up to during Freshers week!

    You have to use a different Apple ID for your son.
    Read this note:
    iOS 5 & iCloud Tips: Sharing an Apple ID With Your Family
    still valid for ios 7

  • I cant seem to download and install the latest iphone software update. I have tried since the release and have been unsuccessful on more than 7 occasions and lost all the data on the process. Anyone have that problem an how do I fix this problem?

    I cant seem to download and install the latest iphone software update. I have tried since the release and have been unsuccessful on more than 7 occasions and lost all the data on the process. Anyone have that problem an how do I fix this problem?

    Hi
    Thanks but I have tried doing the above - when I said 7 times I was modest, its more like 15 times.
    And I am referring to the 5.1 software update. I dont have wifi so I guess I will have to try that seeing that my husband also has the same problem - he has also tried downloading several times. It always times out en says that the connection is lost but yet there are always an internet connection and a decent signal once it stopped. Think it said error 32052 or something!
    I am disappointed because the update includes inprovement on the battery life - did you guys notice any difference?

  • My britness on my iphone 5 was on 100 % and I turn my screen off and after ten min I turn it back on and the screen was on 0% while the britness line on settings was on 100% is it an IOS 6 bug or is my iphone borking???

    My britness on my iphone 5 was on 100 % and I turn my screen off and after  10min i turn it back on and the screen was on 0% while the britness line on settings was on 100% is it an IOS 6 bug or is my iphone broking???

    I've seen that happen sometimes. For me, pressing the lock button to lock it, and then pressing the home button to get to the lock screen reverts it back. If that doesn't work, just move your brightness slider lower and then higher again.

  • Every time I swap between my SIM cards with the iPhone all the messages that we're sent whenever the SIM card was not in my phone never show! is there anyway I can stop this and still get the massages?

    every time I swap between my SIM cards with the iPhone all the messages that we're sent whenever the SIM card was not in my phone never show! is there anyway I can stop this and still get the massages?

    Hello SeamusFitz,
    Thank you for using Apple Support Communities!
    In order to get your messages to show up on your other phone, you would need to have a backup of the phone with the messages, and then restore the new phone from that backup.
    According to article iTunes: About iOS backups found here http://support.apple.com/kb/HT4946 iTunes will backup your Messages.
    iTunes will back up the following information
    Messages (iMessage and carrier SMS or MMS pictures and videos).
    This will help you backup and restore your device:
    iOS: How to back up and restore your content
    http://support.apple.com/kb/HT1766
    All the very best,
    Sterling

  • HT1414 My iPhone4 (iOS 6) does not sync with iTunes. The message displayed suggests to return the iPhone to factory settings (which I cannot do). This happened after the iPhone was upgraded to iOS6 and performed one sync. Any ideas?

    My iPhone4 (iOS 6) does not sync with iTunes. The message displayed suggests to return the iPhone to factory settings (which I cannot do). This happened after the iPhone was upgraded to iOS6 and performed one sync. Any ideas?

    Lilasil wrote:
    The message displayed suggests to return the iPhone to factory settings (which I cannot do).
    Why not?

  • I recently updated a friends iPhone 3 to I cloud , however some contacts have disappeared. These seem to be the ones that were added onto her phone and not her sim. As I have done a sim import. This is the first time she has ever done a back up and sync.

    I recently updated a friends iPhone 3 to I cloud , however some contacts have disappeared. These seem to be the ones that were added onto her phone and not her sim. As I have done a sim import. This is the first time she has ever done a back up and sync.

    This information will explain it:
                 http://support.apple.com/kb/HT1495
    Hope this helps

  • The screen on my ipad mini went black and it won't turn back on. how can this be fixed?

    The screen on my ipad mini went black, and now it isn't responding or turning on at all.  What can I do?

    Reset iPad
    Hold down the Sleep/Wake button and the Home button at the same time for at least ten seconds, until the Apple logo appears
    Note: Data will not be affected.

  • I have a music library on an iMac and I got a new iPhone and a new MacBook Pro and I want some of the songs from the iMac library to be on my phone and my MacBook Pro and I have a new Apple ID on my phone and my Mac book pro

    I have a music library on an iMac and I got a new iPhone and a new MacBook Pro and I want some of the songs from the iMac library to be on my phone and my MacBook Pro and I have a new Apple ID on my phone and my Mac book pro, is this possible if so how do I do it?

    Providing specifics on all the ways to do this will take more time than I am willing to spend here these days.  You can do some of this with Home Sharing.  You can transfer the entire library from one computer to another, If you do that you can delete what you don't want from the transferred library.
    Quick answer if you use iTunes' default preferences settings: Copy the entire iTunes folder (and in doing so all its subfolders and files) intact to the other drive. Open iTunes and immediately hold down the option (alt) key (shift on Windows) so you get a prompt to select a library, then guide it to the 'iTunes Library.itl' file in the moved iTunes folder. If you put the copied iTunes folder in the default location of Macintosh HD > Users > *User Name* > Music then you don't even need to start with the option key held down, iTunes will automatically look for it there. (Make sure there isn't anything already in the iTunes folder there that you want to keep since you will be replacing it with the one you are moving.)
    You do not want to use a new AppleID.  Change the  AppleID on the new phone to the old ID.  Purchases made with one AppleID cannot be transferred to a different one and it will be a royal pain to manage two Apple IDs.
    Change iTunes Store account on an iOS device - Log out of your current account with Settings.app > Store (Settings > iTunes & App Stores on iOS 6) > tap on your AppleID. Log in with a different account. Note, turning on automatic downloads or re-download past purchases may tie the device to that account for 90 days - http://support.apple.com/kb/HT4627 https://discussions.apple.com/message/18484935 - "In order to change your Apple ID or password for your iCloud account on your iOS device, you need to delete the account from your iOS device first, then add it back using your updated details. (Settings > iCloud, scroll down and hit "Delete Account") When you delete your account, all the data that is synced with iCloud will also be deleted from the device (but not from iCloud), but will be synced back to your device when you login again."

  • IPhone 5 created a backup larger than the phones capacity (16GB) and now I can't get anything back onto my phone after Restoring it!

    I had a few storage issues to start with, I basically deleted everything in my phone (media, messages, notes, calanders, apps etc) and my phone still said it was at capacity. The more I deleted the less I could put on there. So I took it the the Apple Store where the manager told me to do a Restore. I did this, then was unable to put the backup straight back onto my phone as it said there was not enough free space (it was empty!), I then called Apple Support who instructed me on how to view the size of the backup and it turned out to be 16.32GB (.32GB larger than the iPhones's capacity) but were unable to give me any useful tips! I downloaded a backup extractor but have no idea how to use it! Please help me

    why should I do that?

  • HT4623 why my iphone are not responding after i update the latest ios? and the screen displaying itunes icon

    why my iphone are not responding after i update the latest ios? and the screen displaying itunes icon

    You are in Recovery Mode. Follow the instructions below to recover your iPad.
    1. Disconnect the USB cable from the device, but leave the other end of the cable connected to your computer's USB port.
    2. Turn off the device: Press and hold the Sleep/Wake button for a few seconds until the red slider appears, then slide the slider. Wait for the device to turn off.
    If you cannot turn off the device using the slider, press and hold the Sleep/Wake and Home buttons at the same time. When the device turns off, release the Sleep/Wake and Home buttons.
    3. While pressing and holding the Home button, reconnect the USB cable to the device. The device should turn on.
    4. Continue holding the Home button until you see the "Connect to iTunes" screen. When this screen appears, release the Home button.
    5. iTunes should alert you that it has detected a device in recovery mode. Click OK, and then click Restore to restore the device.
    Note: You need to be patient and repeat the above many times to recover your iPad. Data will be lost.

Maybe you are looking for