My nano just quit and wont come back on. No evidence of it charging. Nothing. ????

My ipod nano just stopped working. No evidence of it charging and computer is not recognizing it at all.

Please press on the sleep/wake button while simultaenously holding down on the home button. (sleep wake button is the little rectangler button on the top of the device.
If this does not resolve the issue read this article:
http://support.apple.com/kb/HT1766
good luck!

Similar Messages

  • HT1414 MY I PAD JUST QUIT AND  WONT COME ON

    Went to log in to my ipad i had nothing, how do you know if the battery went bad? just a little over a year old!

    Thank you but i had to hold down the home button and on/off for 10 sec and it came back. Its called a hard start i guess.

  • My ipod touch just froze and wont come back to life...

    Sometimes it freezes during the use of an app, but then i just hold the button on the top left and it goes to the black screen, then the apple icon appears and then its all good. But now it's just black and no matter what I do, it won't change from the black screen. It connects to iTunes, and it charges because you hear that click that happens when it starts to charge but the black screen continues to appear. It's glowing, so it's not dead. What can I do? Should I go to an Apple Store, have them look at it. Should I restore it, and if I do, will it keep all my songs in iTunes?

    try holding down both the home button and the hold button. if that doesn't help try to restore the ipod touch. as long as your songs and everything are in the itunes library your songs should be fine.

  • Trying to download 3.6 13 due to updat reminder, several attempts just keep working but never completes, just quit and reminder comes back same issue for weeks now.

    update reminder pops up, click update and then the contact server then download in progress but never completes. must quit to get out or it will spin for hours. using mac osx 10.5 with 3.6 12 with no real issues.

    Go to www.mozilla.com and click on the big green button to download and install the newest version manually.

  • HT4623 my iphone just shut down and wont come back on

    my iphone just shut down and wont come back on what could be the problem

    Connect iPhone to Wall Charger for 10 minutes, it my turn ON itself. If still OFF, then keep on charger and Reset, hold both home and power buttons until the iPhone begins to start, this can take about 20 seconds time holding both buttons while on charger.

  • My ipod has just turned off and wont come back on

    my ipod has just turned off and wont come back on but i know it had a good amount of battery left and if i plug it into my computer or docking station nothing happens please help...

    Try:                                               
    - iOS: Not responding or does not turn on           
    - Also try DFU mode after try recovery mode
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
    - If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
    - Try another cable                     
    - Try on another computer                                                       
    - If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
    Apple Retail Store - Genius Bar                                     

  • TS3694 my iphone keeps turning its self of and wont come back on

    my iphone keeps turning its self of and wont come back on

    Plug it into a wall outlet, let it charge for half an hour and then reboot by holding both the power and home buttons until the apple logo appears, ignore the red slider if that appears.

  • My iphone 4s has just gone off and wont come back on can it be reset ?

    my iphone 4s is 1 day old i was playing draw something on it, it had 96% battery on it but it just went off now it wont come back on. even my computer is not detecting it when i plug it in to that. any ideas why and can it be reset like my ipod can?

    Thank you i did do this but didn't hold it long enough, then i just paniced and thought it was broken. thank you very much.

  • My phone went to a black screen and wont come back on, how do i fix it?

    At first, out of know where, it went to a white screen with a blach apple. Then Iplugged my phone into my computer and reset my phone and my home button or lock button wont work. Now its just on a black screen and wont turn back on. How do i fix this probkem with my phone?

    mckenzie8 wrote:
    my home button or lock button wont work.
    Won't work or are Broken ?

  • IPhone 4S switched itself off and wont come back on. Please help?

    Hi,
    My iPhone 4S has started switching itself off randomly over the last week but would then switch itself back on several minutes later by itself. However, last night it switched itself off and no matter what ive tried it wont come back on. Ive tried the home+power button, connected to itunes and not, connected to itunes with the home button pressed. I rang the Geek Squad as I have insurance and they could suggest anything more. Im loathed to take it back to the shop as all the sales assistant will do is send it off, give me a rubbish temporary phone/brick and it will take ages to come back. I would be grateful if anyone can help please?

    Hi, my phone eventually came back to life of its own accord the next day but with virtually no battery life even though I'd given it a full charge. After it came back on I plugged it in to be recharged but the back became very warm whilst the power drained quicker than usual after I unplugged it.
    I took it to the Apple store later that day and thankfully the phone switched itself off again right in front of one of the Genius assistants. He couldn't diagnose the problem and so gave me a brand new handset straight away. Credit to Apple there and I'm so glad I didn't take it back to the car phone warehouse where I bought it from. They would have sent it away for tests for weeks.
    I've had no problems with my new handset to date.

  • My ipad just went blank and wont come back on, any help??

    My IPad went blank and will not come back on.  Is there a reset button or procedure??

    Try resetting your iPad by pressing the home and sleep buttons until you see the Apple logo, ignoring the slider. Takes about 5-15 secs of button holding and you won't lose any data or settings.

  • HT1688 my iphone just completey shut off, and wont come back on, even when connected to the charger

    my iphone completely turned off and will not come back on, even when connected to the charger. how can i turn it back on?

    Hello ozzy9294,
    Thanks for using Apple Support Communities.
    For more information on this, take a look at:
    iPhone: Hardware troubleshooting
    http://support.apple.com/kb/TS2802
    Display has no backlight or dark screen
    Toggle the ringer switch to see if the unit vibrates. If it does, it could be that iPhone is getting power, but is not displaying any image.
    Try turning iPhone off and then on again.
    While connected to the iPhone charger, try to reset the iPhone.
    If the low-battery screen appears, charge the iPhone.
    Best of luck,
    Mario

  • Trunks between 2950s stop working and wont come back

    I've seen this happen on 2 different 'pairs' of 2950s, so it's time to investigate. The scenareo:
    simple trunk (no vlan definitions) between 2 2950s. 1 switch looses power, when power is restored, the switch that didn't lose power doesn't pass any traffic. The interface is up (link and administrativly up) the logs don't show anything other than the interface went down and came back up. here's a sample port:
    interface FastEthernet0/23
    description new Feed from phone room switch
    switchport mode trunk
    no ip address
    I'm not using spanning-tree, there aren't any redunant paths. Its worked fine for months (until a ups failure), I set up a new port on the switch and swing the cable and it comes up. Any ideas?
    thanks!

    Hello,
    I know this is an old post... but I am posting here in case this is viewed by anyone with a possible solution.
    Our organization has multiple locations configured the same way:
    (x2) cross connected 2950 switches in trunk mode, configured the follwing way per each interface (fa0/19):
    interface FastEthernet0/19
    no ip address
    duplex full
    speed 100
    no cdp enable
    spanning-tree portfast
    Our problem is similar to the one explained in this initial post. The switches are auto-trunked via port #19.
    Let's call one switch "A" and one switch "B"
    Whenever power is removed from one of the switches (Switch A), and it has completed a restart, the opposite switch (Switch B ..the one which was not powered off) will not return to a "Trunked" state. When you run the "show int status" command, it shows that the port is "connected". Even though the switch which was initially restarted returns to "Trunked" mode.
    We have seen this with a few of our 2950's across the infrastructure.
    The bottom line is that restarting one of the switches causes the other to lose the trunked state. The only was to correct the issue is to restart the opposite switch as well.
    The IOS version is 12.1 (9) EA1d .. I know it's old, however we cannot upgrade it at this time due to policies within the organization.
    Could anybody shed some light on this?
    Thanks in advance..

  • Wireless Connection went away and wont come back!

    For months now I have had no problems with my wireless. Then all of a sudden a few days ago I was on my laptop and my xbox 360 at the same time (both wireless like I always do) and they both lost internet connection. Both laptops and xbox 360 in the house get an Excellent signal from my router but none of them will get an internet connection. The wireless light is lit up but it is just solid and not flashing like it was transfering data. I restored factory defaults, reset the router, everything that normally worked to fix it in the past isnt working for me now. Oh and im wired connected to it now and its perfect. 
    Anyone please help!
    Router: Linksys E1000
    ISP: Comcast

    The info from the status page when I go to 192.168.1.1
    Connection Type: Automatic Configuration - DHCP
    Internet IP Address: 76.22.50.75
    Subnet Mask: 255.255.254.0
    Default Gateway: 76.22.50.1
    DNS1: 68.87.69.150
    DNS2: 68.87.85.102
    MTU: 1500
    DHCP Lease Time: 3 Days 8 Hour 48 Min 26 Sec  

  • Iphone 4 just turned off and wont come back on

    Was on the phone in my car on the handsfree, then all of a sudden got disconnected. looked at my iphone 4 and it switched off. got home and tried charging it up and nothing happened, then tried plugging it into my pc to do a restore or see if i get any life and nothing !
    got no phone now and because you have to have a micro sim you have to de activate your regular size sim. so now got no sim to put into a normal phone.
    please help someone ! aaaaahhhh !!

    Hey guys,
    I was with my friend who had the same problem with his iPhone 4 today and as I was researching the problem I tried all the tricks and nothing seemed to work.
    Until I came across some info that suggested the problem was with a proximity sensor.
    Basically his phone was on(when someone called it would ring on their end instead of going straight to voicemail), but not respond tto touch or anything.
    So I held the power button and slid my finger across the screen as if to "switch" it off even though the screen was blank and waited before holding the button again to turn it back on.
    Once I did this it booted back up as if nothing happened.
    Hope this is the same problem, good luck.
    -nortron

Maybe you are looking for

  • Files always download as "attachment.ashx" instead of the file name and file type that they actually are.

    Since I have installed the new version of Firefox (version 8.0), every single file I download is downloaded as "attachment.ashx" and won't open. I have to change the name as well as the file type in order to open the document. This happens regardless

  • Keyboard Doesn't work!!!

    Hi, I have recently upgraded from Logic Express 7 to Logic Studio 8. I have a very modest set up that includes an Alesis io|2 which i use as both as audio and midi connectivity. The Yamaha keyboard i use is quite archaic and was made before usb was e

  • 2LIS_03_BX    Marker

    I have received many help to understand inventory management. One very helpfull indication was "How to handle inventory management scenarios in BW". I have one question about the marker. As I understood, after executing all the steps of 2LIS_03_BX th

  • What vga cable for macair

    What vga cable should I buy for macbookair?

  • RoboHelp V8 - TOC not showing in left hand pane

    Using RoboHelp for HTML version 8, I am publishing to my local hard drive. In the source files, I can see a table of contents, but when the output is generated, the TOC doesn't appear. We have used RoboHelp for many many years and the TOC and Index a