Apple Logo coming up and then disappearing. Won't turn on
My iTouch refuses to turn on. Instead, the apple logo appears and stays for about a minute before shutting off and restarting itself. Help!
Had exacatly same problem, pluged it in to the computer (laptop had broke so had to install itunes on this computer then connect!!) wouldnt appeat until restarted it for ages, then it came up on itunes saying found ipod in recovery mode and had to restore it, still doing that will tell you of success soon hopefully
Similar Messages
-
After I slide to power off my iphone 3GS it would not turn on again.Only the apple logo comes on and then it is off. If I connect to the power the apple logo comes
and then it comes on . I have just used itunes to restore my iphone. How can I make my iphone work again?Keep using it untill it powers off, then charge it to full to re-calibrate the battery.
If problem persist, maybe your battery needs to be replaced. -
My iPod Touch shows the Apple logo splash screen and then turns off.
When I turn my iPod Touch on, the Apple logo is shown and then it turns off. After a few seconds, it shows up again. It continues to do this non-stop. Is there anything I can do? Any help would be greatly Appriciated
Let the battery fully drain. It may take awhile. After charging for at least an hour. If the iPod does not cycle on and off any more try:
iOS: Not responding or does not turn on
Otherwise it appears you have a hardware problem and an appointment at the genius Bar of an Apple store is in order. -
Problems installing OS
I have an iMac 21.5 (mid-2010) and I'm trying to install a new hard drive. When I choose the installation disk the Apple logo comes up and it stops there. Then the mouse and keyboard goes dead. I'm trying to install 10.6. Any help would be appreciated. ThanksSince you have a new hard drive, there is nothing on it, so you need to boot from an external source (and probably format the hard drive before installing an OS). Are you booting from the 10.6 install disk? Better yet - do you have a bootable backup clone or at least a Time Machine backup?
-
My Mac only shows Apple logo at start and then suddenly off
Dear all,
I am freaking out right now. I tried to turn on my iMac. It firstly showed the Apple logo on grey screen. Loading logo appeared below and then suddenly my iMac was off. Any idea what happened?
WahyuNo, but it sounds like a hardware issue or perhaps a bad hard drive.
If you boot in verbose mode (hold down command-V at boot) do you see some words that indicate where in the process it's failing? -
I clicked on the software update, acted like it was updating, and now it just has a blue/turqois screen. I have tried to reset it by holding down the on/off button
and home button at same time, and the apple logo shows up and them goes back to the same screen. Please help...Try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iPod fully off, let the battery fully drain. After charging for an least an hour try the above again.
- If still not successful that indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar -
My new iphone 4s would not discover bluetooth. I called apple, and the guy was great!!! He told me to hold the top button and the home button together and do not let go until the apple logo came up, this would do a hard reset. Then when it reboots, you turn on your bluetooth in paring mode, and then turn on the bluetooth on your iphone 4s and it will find your bluetooth device. Simple, yet it works!!! Hope this helps those of you having the same problem I was having trying to connect your bluetooth.
My new iphone 4s would not discover bluetooth. I called apple, and the guy was great!!! He told me to hold the top button and the home button together and do not let go until the apple logo came up, this would do a hard reset. Then when it reboots, you turn on your bluetooth in paring mode, and then turn on the bluetooth on your iphone 4s and it will find your bluetooth device. Simple, yet it works!!! Hope this helps those of you having the same problem I was having trying to connect your bluetooth.
-
i cannot get my ipad to respond. The apple logo appears and then a white line with a locked box and the end and Itunes logo. That is it. pushing my respond button does nothing.
YOU ARE IN RECOVERY MODE
1. Turn off iPad
2. Turn on computer and launch iTunes (make sure you have the latest version of iTune)
3. Plug USB cable into computer's USB port
4. Hold Home button down and plug the other end of cable into docking port.
DO NOT RELEASE BUTTON until you see picture of iTunes and plug
5. Release Home button.
ON COMPUTER
6. iTunes has detected iPad in recovery mode. You must restore this iPad before it can be used with iTunes.
7. Select "Restore iPad"...
Note:
1. Data will be lost if you do not have backup
2. You must follow step 1 to step 4 VERY CLOSELY.
3. Repeat the process if necessary. -
just updated my phone and now it doesn't work at all. apple logo queeps coming on and off on my sceern.
Was your phone jailbroken or hacked to unlock it before you updated?
-
I was updating to ios7 and my iPad froze. I tried the restart sequence but nothing.
Keep us updated with what happens after letting the battery fully drain.
If it still remains stuck at the Apple logo, try manually placing and connecting the device to iTunes in disk mode.
Putting iPod into Disk Mode
B-rock -
Please help me! - My Apple Care ran out and my macbook won't turn on
Hi!
My macbook refuses to turn on. It started with the fans not functioning properly, and then the display kept on turning black. Now it won't turn on at all. Every time I press the power button it boots up, and I can hear the fan and the corner light goes up but it shuts down after a few seconds. I took the battery out but that did not work. My Apple Care just ran out so I would rather not take it to the Genius Bar.
Thanks!Mariposalatina,
Normally you can get your files back if you take it to a good enough technician to know how to not touch the files to repair such a situation. If the machine is over 4 years old, the most common reason for the above symptom is a dead PRAM battery or capacitor.
Maybetomorrow,
At very minimum call around to find out if there is a technician in your area who will fix that battery or capacitor without touching your data, or at least will extract the hard drive so you can put it in an external hard drive case and attach to a newer computer. -
My iphone 3GS is stuck on the apple logo which keeps flashing? It won't turn on??
My iphone 3G
Put phone into DFU mode (turn off and hold home and power for 10 seconds, keep holding home until connect screen appears), then restore.
-
just updated my iPhone 4s to ios6, now my phone won't turn back on. The apple logo comes on and sits then shuts off. Then comes back on and just sits.I have held down the home button and on/off switch several times to reset, but same problem persists.
Place iPhone on Wall Charger for at least 10 minutes. Then keep on charger and Reset, hold both home and power buttons until the iPhone begins to start, this can take about 20 seconds of holding both buttons while on charger. If still problem, open iTunes 10.7 on computer, connect iPhone to computer with USB Cable, hold both home and power buttons for about 20 seconds until iTunes recognizes iPhone in Recovery Mode, then click Restore button of iTunes. If still problem, try DFU Mode Restore, here are the steps. Open iTunes on computer. Connect iPhone to computer with USB cable. Hold both Home and Power buttons, after exactly 10 seconds release the Power Button, keep holding the Home button until iTunes recognizes iPhone in Recovery Mode, usually about 20 seconds time. If the iPhone screen is black, blank this is DFU Mode. Click the Restore button of iTunes. DFU Mode can be difficult to enter sometimes, just keep trying. DFU Mode is a black, blank screen with iTunes saying Recovery Mode. If still problem and there is Warranty or AppleCare make Genius reservation and take to Apple for resolution.
-
I have a iphone3GS. It could not be boot up. When i press the sleep/wake button, the apple logo appear and then disappear. The password login screen didnt' come on. When i tried to connect my phone to the itune on my laptop, there isnt this button that i can sync my phone with the laptop.
Sounds like your iPhones software may be corrupt. Try placing the iPhone into recovery mode. To do this, follow the steps in this article:
http://support.apple.com/kb/HT1808
Hope this helps
- Greg -
My little brother stole my iPod touch and when I got it back I tried to turn it on and it goes to the apple logo, which its usual, then it gets stuck on a Playboy bunny logo and won't go away.
connect it in recovery mode, then restore from your backup.
Maybe you are looking for
-
Calendar Display Attributes have no effect
Application Express 3.0.1.00.08 I am having problems with the following attributes: Begin at Start of Interval Item Containing Start Date Item Containing End Date This is how you can reproduce my problems: Create page -> New page -> Calendar -> SQL C
-
Error in HRPAD31 ( Short dump Analysis )
Hi friends, When i am changing the existing qualification or adding new qualification it is showing this error in short dump Pls advise me if there is some relationship i am missing in 031 ? here is the description of short dump Runtime Error DBIF_R
-
My Library Won't Display Prior Mp3s
Can someone help me figure out how to display my old mp3s in my my Library so that I can transfer them to my new Nano? My Library is only showing new disks that I have downloaded - they are showing up as .m4As. This is very frustrating.
-
Hi all. I am very very new to Flash, been thinking about usig it for all of a day! I have to come up with a website and the general idea is that a lot of 3D is to be used. Although I have been heavily involved in 3D for 14 years now, web development
-
Generating n:m relationships
Hi all, i have two tables linked via an intersection table, a typical n:m thing. I'd like to generate a form displaying this relationship, like there's the data of the one table in the first block, and all records of the second table - that match the