Data Loads Stuck in RSSELDONE

Question

Hi All,
We have a scenario in our Q system where we cannot see the data load request in RSMO. When we click on a request (which does not have a status light), it doesn't show anything on the right side pane and will eventually timeout after a while. Analyzing the short dump we found that the RSSELDONE table has a lot of entries and the selections in Infopackage is about 80000.
RSREQDONE doesnot have any status for these requests. The requests were created a week back and couple of days back the system was also bounced. But still we cannot see the request in RSMO to turn it to red. Further loads from the same data source also doesn't start or doesn't show "the load is requested" message.
We are considering the RSREQARCH_WRITE. But not sure if this would resolve the issue. Anyone faced a similar situation?
All helpful suggestions welcome.
Thank you,
Vijay

Answer 1

Hi,
Probably Ask your Basis to do Database statistics refresh with 80% of table RSSELDONE. This wiould enhance reading performance and reduce the time required to generate new request number.
- Your Basis team needs to look at this problem and search for some related OSS notes. They might need to manipulate some system parameters.
You can also look for the note 620361, which indicates :
Cause and preconditions
You have a data target with a large number of requests.
Since certain information of all requests is required in a data target
with the above-described actions, a relatively large number of entries
must be read and processed in different tables.
As a result, the processing times become longer and longer.
=========================
It also provides a solution to improve the data load performance.
you can delete db statistics of table RSSELDONE, RSLDTDONE, RSREQDONE  and try and load, you might be lucky.
Regards,
Bhargava