Error when run Process Chain via BPC NW

Question

Hi Gurus,
I am implementing SAP BPC 7.5 NW in a customer and I´m facing the following error when try to run a process chain via Data Manager: "Failed to analyze instruction ,TAB,%TAB% ".
Here is the scenario: we created a process chain that will be able to capture values recorded in a BPC application, load them into an DSO (make some transformations there) and finally send those transformed values to an specific table at ECC. This process will be started after some simulations at BPC and, when the user ends its simulation, start this process chain via BPC; this process chain is named as PC_ECC.
We made a  copy of /CPMB/DEFAULT_FORMULAS and named it PC_FORMULA and, before step /CPMB/CLEAR, I assigned my process chain PC_ECC.
So, at Data Manager, I add this process chain (PC_FORMULA) and in Advanced button, I put this statement:
INFO(%EQU%,=)
INFO(%TAB%,;)
TASK(PC_FORMULA,TAB,%TAB%)
TASK(PC_FORMULA,EQU,%EQU%)
TASK(PC_FORMULA,SUSER,%USER%)
TASK(PC_FORMULA,SAPPSET,%APPSET%)
TASK(PC_FORMULA,SAPP,%APP%)
//TASK(PC_FORMULA,LOGICFILENAME,DEFAULT.LGF)
//TASK(PC_FORMULA,REPLACEPARAM,TESTE3%EQU%%TESTE3%%TAB%ASARENT%EQU%%ASARENT%%TAB%SOURCE%EQU%%SOURCE%%TAB%TARGET%EQU%%TARGET%)
As we do not have any script logic to be executed, we commented the two last statements.
When we run this package via DM, it gives us the message error:  "Failed to analyze instruction ,TAB,%TAB% "
Looking through SDN forum we found two posts similar to this issues:
But the suggestion to supress the statement TASK(PC_FORMULA,TAB,%TAB%) do not work; when we comment this statement, the message error gives us the message:"Failed to analyze instruction ,EQU,%EQU% "; when we comment the statement TASK(PC_FORMULA,EQU,%EQU%) and the previous (with TAB). the DM gives us the message: TASK(PC_FORMULA,SUSER,%SUSER%) and so on, until nothing has left to comment.
Anyone of you view or has some similar case of error?
Thanks in advance to you all
Best Regards
Adriano

Answer 1

Hi Rich,
Thanks for your answer.
I checked the parameter at my process chain and it has a variant (/CPMB/DEFAULT_FORMULAS_LOGIC) with the parameters:
TAB
SUSER
SELECTION
SAPPSET
REPLACEPARAM
MEMBERSELECTION
LOGICFILENAME
EQU
So, when I put in the task PC_FORMULA, TAB, %TAB%, it will be able to be recognized by the task...and the other parameters too. And when I take one of them off the task instructions, the system complains.
Any other suggestion?
Once again, thanks..a.nd best regards
Adriano