HT4623 my iphone lights up with the apple icon then says ios'6 then says connect to i tunes but phone wont start uo
my iphone lights up with the apple icon then says ios6 then says connect to i tunes but can not get passed that
iTunes: Restoring iOS software - http://support.apple.com/kb/ht1414.
iPhone Troubleshooting Assistant - http://www.apple.com/support/iphone/troubleshooting/.
Similar Messages
-
HT4623 My iphone is frozen with the apple icon and progress bar at 5% cannot update
My iphone4 is frozen with the apple icon and progress bar at 5% cannot update
Same issues here.
iPhone 5 was fine until I restarted the device... now the screen flickers on and off (with the white Apple logo
and frozen progress bar overlayed on the screen).
When I try to restore, I get a "-1" error.
Well I just looked over at the screen, and everything is now fine. No flickering, no logo... the screen looks normal.
Hmmm... -
Hello,
Do you know what I can do when my Iphone is blocked with the apple appearing ?
I cannot enter into the phone and I don't know what to do ?
Thank you for your help
AMGSOBasics from the manual are restart, reset, and restore.
Have you tried these? -
I was trying to update my iPhone but now it is frozen on the black screen with the apple icon. It won't do anything. Any suggestions?
Is your iphone hacked/jailbroken?
-
My iphone 5 died so I plugged it back in to charge and it will not turn on. It will turn to the screen with the apple logo and black screen then turn off again. Any suggestions?
I leave it charging until it gets back to full, usually it turns on after a little bit of time after plugging it in, but all its doing is going to the apple logo screen and going blank again.
-
in the middle of my last update it stopped updating in the because of an unknown source, and now my screen on my iphone is frozen with the apple logo and a loading bar. Help??
Unknown "source"? Do you mean unknown "error" followed by a number?
http://support.apple.com/kb/TS3221
Follow the instructions in the article. When you connect your phone again, you may have to press both the home and sleep/wake buttons until the Apple logo reappears, then continue pressing the home button until iTunes detects the phone in recovery mode. -
If I connect my ipohone 5 to an iphone 4 dock with the apple adapte will it still stably on the adapter with no back support?
I use an iPhone 4 dock but have super glued a piece of (elegant) plastic to support
the iP5 . It will wave around in wind a bit without support putting strain on the
.lightning socket
I have also adapted an iPad dock which does have a lip at rear -
Hello, I can't turn my iphone 4s on, it just broke down and now there's just the black screen with the apple logo on it. So I connected it to itunes and tried to restore it, but than always the errors 1603 & 1611 appeared! please help me!!
You may have a faulty USB cable. Try another.
Make sure you are following the instructions in this procedure to the letter. Here they are, with emphasis on some easily overlooked requirements:
Disconnect the USB cable from the iPhone, but leave the other end of the cable connected to your computer's USB port.
Turn off the device: Press and hold the Sleep/Wake button for a few seconds until the red slider appears, then slide the slider. Wait for the device to turn off.If you cannot turn off the device using the slider, press and hold the Sleep/Wake and Home buttons at the same time. When the device turns off, release only the Sleep/Wake button.
Continue pressing and holding the Home button while you reconnect the USB cable to the device. The device should turn on.Note: If you see the "low battery" screen, let the device charge for at least ten minutes to ensure that the battery has some charge, and then start with step 2 again.
Continue holding the Home button until you see the "Connect to iTunes" screen. When this screen appears (iTunes icon and USB connector) release the Home button.
If necessary, open iTunes. You should see the "recovery mode" alert ("iTunes has detected a phone in recovery mode").
Use iTunes to restore the iPhone.
If you do not see the "Connect to iTunes" screen, try these steps again. If you see the "Connect to iTunes" screen but the device does not appear in iTunes, see this article and its related links.
Select the device in iTunes and choose "restore from backup".
If you still can't get it to work, you have done all you can and only Apple will be able to help. -
My iphone won't turn back on after it fell off the charger. When I plug it back into the charger, the screen with the apple icon pops up and it buzzes and just keeps repeating the same two steps. What can I do? Help!
Try these steps: http://support.apple.com/kb/ts3281
-
I "Erased all content and settings" and now my iTunes does not recognize my iPhone when I plug it in. Plus my iPhone is stuck with the apple symbol on it and wont do anything. what did I do? How do I get my phone to work again?
Reset, hold both Home and Power buttons until the iPhone begins to restart. Usually takes about 10 seconds time. If still problem. Open iTunes on computer. Connect iPhone to computer with USB Cable. Hold both Home and Power buttons until iTunes recognizes iPhone in Recovery Mode. Usually takes about 20 seconds of holding both buttons. Restore the Firmware.
-
ive had my iphone 5 for just over a year now.. its all of a sudden decided to shut down on me.. ive tried everything to get it switched back on again but nothings working, when i connect the charger it jst flashes with the apple icon.. anyone help?
Did you try a reset, hold the power button and home button until you see the apple then let go? Did you try to restore as new in iTunes on your computer?
-
my iphone lock activate iphone, sign in with the apple Id that used to set up phone , i dont's have.
http://support.apple.com/kb/TS4515
-
My iphone 4 is just showing a black screen with the apple icon. how do i get it to work?
my iphone 4 is just showing a black screen with the apple icon. how do i get it to work?
First, try resetting the phone - press both the home and sleep/wake buttons until the Apple logo reappears.
-
My phone started acting up and I noticed my text messages were not being sent. So I turned my iphone off. My iphone 4s turned off properly but when I went to put it back the apple icon came on and then an image I have never seen before of a UBS pointiing towards the word itunes in a circle. And the phone no longer goes beyond this message. I try to turn it off and on again and same message over and over. If I hit the any button on the phone nothing happens. Does anyone know what this means or seen this itunes messaging ? meltdown? Please help.
Hello Raja,
Thank you so much for your response. I had these photos backed up on iCloud but, had I not, its good to have an alternate solution as the one you suggested. Actually, I went to the Apple store today and yes, you are absolutely correct Restoring in iTunes will result in permanent loss of photos unless backed up somewhere such as iCloud or other solution. Well, what they did was restore the phone in itunes ( I did not have iTunes downloaded to my computer which is why it did not work when I went to do it myself, I needed to go to the iTunes site and go to the download iTunes button because my windows based HP laptop does not come with itunes already downloaded). This retoration process took a while and I was forced to upgrade to the latest 7.1 iOS software which I was not too happy about -sometimes you like the way things work now :-) Anyhow, they said this restoration request happens as a result of a software update (which I was NOT in progress of an update or doing an update) or sometimes when you remove the power cable too quickly from the iphone (which I do not recall doing this either but...). Since I had backed up on iCloud all of the photos were downloaded back on my iphone 4s. Best of all was that my phone was back up and runnning and there was NO CHARGE at the apple store for this service of restoring my phone. Well, I just wanted to share the results and I appreciate all the responses and support I received. Thank you kindly. -
my new ipad 2 turnes to black screen with the apple icon in the middle while using it or if i just left it locked for a while, it just hanged and i have to restart it?! so why this is happening ?! is there is a productio error or something i can do to prevent doing this ?!
Appreciate responding as soon as possible.No, it's definitely not normal. Your User's Guide recommends a series of troubleshooting steps to go through when your iPad is misbehaving: As you're already in effect doing the first of the main steps, a Restart of your iPad, and that's not curing it, move on to the next .. a Reset.
To do this, press and hold both the Home and the Sleep/Wake buttons for about 10-12 seconds, until the display blanks and the red Power Off slider appears. Continue holding the buttons until the slider disappears, replaced by the black screen and white Apple logo.
This shows your iPad is starting to reboot. Release the buttons and allow the process to continue until the Lock screen appears again, then slide the slider to complete the process.
Maybe you are looking for
-
How to calculate total bandwidth utilization of a circuit if i have In and Out data rate? Is there any formula?
-
Issue Screen Scrolling Very Jumpy - How can it be improved?
I have setup 3 MS Windows Server 2012 R2 Remote Desktop Servers, connecting to Wyse C10LE terminals. When scrolling in documents the display screen does not do so clearly. I've tried reducing the encryption level and security settings but still no
-
Error RPE-01008 and RPE-01003 if i execute a process flow
Hi, if i execute a process flow, once the process flow worked fine. If i execute at another time the process flow didn't work with the following error messages: RPE-01008: Wiederherstellung dieser Anforderung ist in Bearbeitung. RPE-01003: Die Anford
-
Show vertical scrollbar when 1D array only shows one element
When showing only one element of one dimensional array, only the horizontal scrollbar can be displayed. The vertical scrollbar visible option is greyed out. Even using property nodes does not make it visible. I have an array of clusters with many
-
I recently purchased iLife '06 and installed it on my Powerbook. It hasn't been perfect but the biggest problem was upgrading my photos for iPhoto. It says: "The photo library needs to be upgraded to work with this version of iPhoto." click upgrade..