Ink System failed on C5180 All-in-One printer without fax

I have had the C5180 printer for about 2 years and I am getting the 0xc05d1381 error. I changed out all ink cartridges and I would like some help on solving this issue if possible. Thank you.

Hi
Try resetting the printer as described here
Kind Regards
Ciara
Although I am an HP employee, I am speaking for myself and not for HP.
Twitter: @Ciara_B_HP

Similar Messages

Power problem with my 4620 all in one printer / scanner / fax

Hi,
My problem is this. I have a 4620 all-in-one printer / scanner / fax. However, I have discovered this problem.
Scenario:
The printer hasn't been used for a day or two but is plugged in still with the light above the power cord on. I want to print a word doc or whatever. I click print. I obtain a message that the computer (via wifi) can't communicate with the printer. Pressing the Power on button on the printer interface doesn't work.
My solution, I have to disconnect the power supply from the printer, then reconnect and then press the Power On button.
This isn't normal I think. I don't think for one minute that I should have to go and disconnect and reconnect the power suppy for it to print etc.
Any ideas?
Thank you in advance!!

maybe here: http://discussions.apple.com/thread.jspa?messageID=11110856&#11110856 ?
found doing a quick search of the forum
all results here: http://discussions.apple.com/search.jspa?objID=c263&search=Go&q=laser+printer
JGG

How can I install my printer HP Photosmart Premium C310 e-All-in-One printer without CD?

I got it 2 weeks ago, but my laptop don't have CD-drive. When I go to Software & Driver downloads and write my type C310b it always open me for type C310a with note:If your operating system is not listed, HP does not have software or driver downloads available for this product in that operating system.
can someone help please? HP have very bad support.

You didnt state what operating system your using so I am unable to give you the direct download link. Here is the link to the 310b driver download page, you just need to select your operating system from the list:
Software & Driver Downloads - HP Photosmart Premium e-All-in-One Printer - C310b
Hope this helps!
Sean
-------------How do I give Kudos? | How do I mark a post as Solved? --------------------------------------------------------

Ink system failed photosmart c5180 error oxc18a0206

have done the following:
installed 5 new ink cartridges
performed printer diagnostics
reseated cables
direct connected to wall outlet
reinstalled software downloaded from hp
checked port setup (2 settings: virtual printer port & a DOT port)
unplugged and pressed help plus ok with simultaneous insert of power
have followed threads to http://h30434.www3.hp.com & others for c6180
now led displays welcome screen, however when I execute print command the ink system failure appears
only advice not tried, because I don't know what the writer is talking about, is "open plate vertex formater and EVOLVE cariage cable and power on when led shows error message
Is this problem fixable?
Thanks in advance for any help.

Hi
Have you already tried resetting the printer?
http://h10025.www1.hp.com/ewfrf/wc/document?docname=c00489814&cc=us&lc=en&dlc=en&product=1153481&tmp...
Although I am an HP employee, I am speaking for myself and not for HP.
Twitter: @Ciara_B_HP

C5180 All-in-one Printer Feeder Question

One of the four feeders on the paper tray came off, which makes the paper feed incorrectly. Is there a way to put the black clip back on the tray? Please help. I love my printer. Is this something that can be fixed or will I have to replace the printer?

Sure, uninstall the software and re-install from here.
There is also a patch for those who upgraded from Vista to 7, but it is not clear if this is just for those who left their HP software in place during the upgrade or if it would also apply to your situation.
Say thanks by clicking "Kudos" "thumbs up" in the post that helped you.
I am employed by HP

HP Officejet 4215 all-in-one printer, copier, fax and scanner

Before I installed Leopard, I had various options in my print menu available to me. For example, I could print a document or webpage in black and white (to save ink) that was originally in color. After installing Leopard, those printer options do not exist anymore. I have to print everything that has color in color. Some of the other options are missing too. I went on the HP website to see if I could upgrade to a new driver but there was none listed. Also the Scanner feature won't work anymore now that Leopard is on my system. Now they did mention that on their website saying I would have to go buy a stand alone scanner now if I wanted to scan anything as a result to having something to do with Leopard!
I was told that there were printer drivers on the Leopard install disc. I installed them and haven't notice any differences.

HP have [this pdf document|http://h41140.www4.hp.com/macconnect/pdf/Mac_OS_launchspecial.pdf] available online entitled "We're Ready for Leopard". This document specifically mentions (among others) the OfficeJet 4215 and gives helpful info on moving your HP device from 10.4 to 10.5. Does this help you?

Re: how do i install a hp psc 1410 all in one printer without the disk?

how to install?

lection wrote:
how to install?
Install what? If it is the PSC 1410 then what operating system? Do you have a 32 bit or 64 bit version? See my post here.
If a different printer model please start a new thread after reading this post and then provide some details. What printer model? What operating system? How is the printer connected - USB, wired LAN, Wireless LAN, bluetooth?
Bob Headrick, HP Expert
I am not an employee of HP, I am a volunteer posting here on my own time.
If your problem is solved please click the "Accept as Solution" button ------------V
If my answer was helpful please click the "Thumbs Up" to say "Thank You"--V

I am unable to scan using the hp office jet pro 8500 wireless all in one printer from an I-MAC

I have a new I-MAC OS Lion computer and an older HP Officejet Pro 8500 wireless all-in-one printer, scanner, fax, photo. I cannot scan, though I can print and I can fax. The error message says I must be connected to the network, and yet I am connected. The only diagnostic tool available is for MS systems only. Help???

Hi,
Make sure to use any scan method available for Lion.
If you have the HP Scan application installed, be aware that the used software version is not intended for Lion.
Please follow the steps below to find what scan methods may be used on the OS:
http://h10025.www1.hp.com/ewfrf/wc/document?docname=c01910186&lc=en&cc=us&dlc=en&product=3752459
If there is still any problem while trying to scan, also make sure to install the latest HP Printer Driver 2.9 by clicking the Apple icon and then Software Update.
Regards,
Shlomi
Say thanks by clicking the Kudos thumb up in the post.
If my post resolve your problem please mark it as an Accepted Solution

Best all in one printer??

I need ethernet all in one printer with fax, any suggestions. I am trying the Canon MX700 and cannot get the ethernet to work.

for some reason it all works now, before when I tried I was using a 192.168.... IP address, that was the same as displayed on the printer LCD. Now I have just reset the LAN on the printer and it gets a 169....address and it seems to work fine. I think my problem was I always thought a 169. address was not a valid address and didn't pursue it further.
Finally, has anyone attached this printer to a wireless network and got it to work?

"ink system failure" error with code oxc19e0023 on a HP Photosmart Premium All-in-One Printer - C309

"ink system failure" error with code oxc19e0023 on have a HP Photosmart Premium All-in-One Printer - C309g - Have done all the resets and reseated the ink also tried replacing ink with new HP carts..getting frustrated please help
This question was solved.
View Solution.

Have you tried the steps outlined in this article:
http://h10025.www1.hp.com/ewfrf/wc/document?docname=c03081973&cc=us&dlc=en&lc=en
If not give the steps a try and let us know if it helps.
Best of Luck!
You can say thanks by clicking the Kudos Star in my post. If my post resolves your problem, please mark it as Accepted Solution so others can benefit too.

HP Officejet J4550 All-in-one printer Unable to print pages/photos from system request !

I have an HP Officejet J4550 All-in-one printer that I had set p when I bought my new Acer system with Windows 7 installed and had no problem from the beginning to set-up the installation and have it running as My Default printer and has worked fine up until now ; when all of a sudden the system ;when I go to print a page/photo brings up the set-up - shows the printer as Default and then when I run PRINT...there is No page/photo printed out ? I have tried to run the Diagonistic software and shows the printer as Default and No problems and yet still delivers No Print out ? My system has had All up-dates automatically installed up till this point ...So I not being a Techie ,do not know what or where to look for help to resolve the issue next ? Anyone able to tell me what to look for to do or how to resolve the issue or do I need to just Un-install the printer and Re-set it up again ?? I have tried to look at all places on HP ;but it does not even show my older HP Officejet -J4550 - All-in One Printer ? Just keeps referring to HP Officejet -4550 ? Loooking for any answers ! Thank Yopu ,JS

Hi jspin3,
I'd like to help. For now, I would hold off on the uninstall and reinstall. Can you answer some questions?
Is the printer connected by USB, Ethernet or wireless?
Do you get any error messages?
Does a blank page come out or do no pages come out when you try to print from the computer?
If you put a document face down on the scanner glass, are you able to make a photocopy?
Can you estimate the ink levels, in percent full for each cartridge, by looking at the printer ink gauge? Click Here
If you print a Self Test Report, do all of the colors print?
Also, remember a click on the Kudos star to the left is a quick "Thanks" for a helpful post.
Please select the "Accept as Solution" button on the post that best answers your question.
I appreciate your input ! ___________________________________ _____
Thank You,
Rich
Expert

HP update HP Officejet 6500A Plus e-All-in-One Printer-E710n multi fails @ 96%Z

HP Officejet 6500A Plus e-All-in-One Printer - E710n
Windows Vista
HP is trying to update my HP Officejet 6500A Plus e-All-in-One Printer - E710n w/ "HPZSetup.exe & multi fails @ 96%
Errors:
HP-PhotoSmart All-In-One Series "Error" "wStub" "2229580"
Same message appeared multiple times with new numbers: 459624; 525134; 328216
I am on WIFI but system always shows me on USB. I thought maybe that was the problem so I connected by USB. No Help.
I assume this is an update?? HP is insistant and keeps sending me this update which alwaysends in FATAL ERROR at 96%
Next steps?? Thanks JLM_JR
This question was solved.
View Solution.

No Problem. Is everything working now or this tool only removed the HP software? If so, then try downloading the full feature software to see if this fails or not here. Please choose your correct operating system; Either 32 bit or 64 bit. I will be looking forward to hearing from you.
I worked on behalf of HP.

All in one printer won't print black ink - colour only

My all in one printer won't print in black right now - colour only - even though the black ink is new. It will print a couple of black ink pages and then reverts to colour. If I give it a rest it will print a couple more black pages and then again, in colour - I think something needs cleaning but I don't know what - any help is much appreciated! Val

Please read this post then provide some details. What printer model? What operating system? Is the black cartridge an original HP or a third party or refill/renamufactured cartridge? (The symptom is typical of a poorly refilled cartrdige....)
Bob Headrick, HP Expert
I am not an employee of HP, I am a volunteer posting here on my own time.
If your problem is solved please click the "Accept as Solution" button ------------V
If my answer was helpful please click the "Thumbs Up" to say "Thank You"--V

Photosmart C5180 all in one not copying and or printing

My Photosmart C5180 all in one-- will not print material from my computer. It will not copy either.
I did a print test from my computer's solution software and a nice picture of 2 pears came out fine
in living color. I did an extended self test diagnostic - 2 pages--and the headings (product information, etc)
printed out fine in black and blue ink---but the info under each heading printed really really light - not readable.
When I try to print from my computer I get a blank page. When I try to copy something it sounds like it
is printing, but the paper is blank. Thanks for the help.

Hello,
Please click HERE to access the steps that should resolve the issue . If issue still exists contact HP Tech Support for further assistance.
If you are in US , the toll free # is 1-800-474-6836 .
If you are not in US , then log on to www.hp.com , at bottom-left corner there is a world map icon, click on it and then select the region you belong to, which would then provide support options for you for that region.

Need help . Bought original HP 21b ink for F370 all in one printer , its not printing

Hi ,
Need help . Bought original HP 21b ink for F370 all in one printer , its not printing at all .Kindly mail at [Thank you for visiting the HP Support Forums. I am sorry to inform you that your post has needed some editing to remove personal information.]
. Thanks .

Hello @Bn23 , and welcome to the HP Forums, I hope you enjoy your experience!
I see you're running into print issues. I would love to try and help you, but I do need a little information first. I am linking a few HP Support documents below that will show you how to find which operating system you are using. Also, if you're using Windows, please include whether your operating system is 32-bit or 64-bit. With this information we can provide you with accurate information.
Mac OS X: How Do I Find Which Mac OS X Version Is on My Computer?
Which Windows operating system am I running?
Is the Windows Version on My Computer 32-bit or 64-bit?
Also, when you print, does a blank page come out, or does no paper feed through the printer? Is there any errors that come up?
Please let me know what you find. Thanks for posting on the HP Forums!
Please click “Accept as Solution " if you feel my post solved your issue, it will help others find the solution.
Click the “Kudos, Thumbs Up" on the right to say “Thanks" for helping!
Jamieson
I work on behalf of HP
"Remember, I'm pulling for you, we're all in this together!" - Red Green.

Ink System failed on C5180 All-in-One printer without fax

Similar Messages

Maybe you are looking for