My iphone won't turn on at all and when i connect it to a charger the apple sign just flashes on and off but does not turn on?
I've tried charging it overnight and it still will not turn on, when connected to the charger the apple sign just goes on and off but does not do anything, i've tried resetting it and this also does not work, but then once taken off the charger it doesn't even say the sign for charging it just does nothing
Turn your phone off and connect your cable to the computer, but not the device just yet. Start up iTunes. Now, hold down the home button on your phone and plug it in to the cable - don't let go of the button until iTunes tells you it's detected a phone in recovery mode. Now you can restore to factory settings.
Similar Messages
-
plz help
Issues booting are genenerally symptomatic with a corrupted operating system. I've seen this issue a lot recently with folks who have tried (unsuccessfully) to install the preview of iOS 7. If this is the case, once you get this issue resolved, I recommend you stick with iOS 6 until the new version is officialy released. If not then it just might be run of the mill corruption. Either way, you'll need to perform a DFU restore of the device. Check this video out: http://www.youtube.com/watch?v=ofpinyGlQ8I for instructions on how to do this. It will delete everything, but this is likely the only option you have at this point. If you have issues doing this or if a DFU restore does not resolve your issue you should head to the Apple Store Genius Bar with an appointment (call, or go to apple.com/retail) and they will assist you!
-
Lastnight I was just playing away on my iPod and next thing it just went off, it was fully charged and everything. Now it won't come back on and when I plug it into the wall the apple logo just keeps flashing on and off. I have tried to reset it by pressing the on and off button and home button but nothing. How can I get it working again.
Try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- Try another cable
- Try on another computer
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar -
I cant get my iphone to turn on. The apple logo goes on and off intermittently. Avery small line of words stating error'unclean shutdown. It ssms like it is frozen or locked. Is there something I can do to restore my phone screen? I recently updated to IOS 6.
What happens when you try to restore?
-
My laptop won't turn on. It's been hours and all it's showing is a white screen with the apple sign and the loading circle. I've tried turning it on and off, nothing's working. Please help!
Will it boot up in safe mode?
http://support.apple.com/kb/ph11212
or can you enter single-user mode?
https://support.apple.com/kb/ht1492
What version of OSX are you running? -
My iphone 5 suddenly died and won't turn back on even after doing the recovery procedure. Even when I put it on charge the apple sign appears for 5-7 seconds and even after that it won't turn on. Help?!?!
DFU mode an try to restore to iOS6.1.4 it will wipe out the whole device if it works but than youll kno if its a software issue if it works or ahardware issue if it dont work
-
my iphone wont turn on but when i plug it in to charge the apple logo comes on and turns back off after a few seconds i dont know what to do i need help
Hello warhogs17,
After reviewing your post, it sounds like the iPhone will not turn on past the Apple logo. I would recommend that you read this article, it may be able to help the issue.
If your iPhone, iPad, or iPod touch doesn't respond or doesn't turn on - Apple Support
Thanks for using Apple Support Communities.
Have a nice day,
Mario -
About 30 minutes ago, I was adding some music to the ipod Nano. Everything was working fine. Now, the ipod will not turn on at all. When I connect it to the laptop with the USB, the computer does not even recognize it. The screen has a fant image of the plug on it and it says connected. I followed the procedures for disconnecting it when I was finished with it earlier. Any idea what is going on here???
ThanksIt probably needs to be reset. The procedure is different for different Nano models: http://www.apple.com/support/ipodnano/assistant/itunes/
-
ipod wont turn on all i see is the apple sign then my ipod shuts off again, how to fix it?
Connect it to itunes, and see if itunes recoginizes it.
If not, then hold home and the power button to do a soft reset.
If not, then you will need to go into recovery mode.
To get into recovery mode you need to Hold Power + Home at the same time. After it goes blank, continue holding the home button while releasing your finger from the Power Button.
You should be able to do it. Otherwise, you may need to send your Ipod in for repair.
NOTE - Using recovery on your Ipod will erase all data and reset all settings. -
My ipod touch wont turn on at all even when i connect it to my computer
So my ipod touch wont turn on at all even when i connect it to my computer! it was working fine then outta no where it wouldnt wanna turn back on. i tryed resetting but it doesn't do anything. Also when i put it on the charger it seems to get pretty hot...is the normal? help please...
There are two different causes of this, either it has been overheated, or the iPod just crashed. If it crashed, there is one simple step to fixing it. Letting the battery die. Do not connect to a charger port, or the device may get overheated, and need to be replaced. Once it dies, it normally will show the icon, that is needs to be charged. Once you charge it back up, it should go back to normal. If this doesn't help, then contact apple to the nearest store about getting a replacement.
-
sorry can anyone help me...? my iphone is not starting and when i want to start it after the apple icon it appear that connect to itunes and when i connect it just there is one option and it says that restore your iphone.when i restore it says cant restore... please help me...
See Here...
iOS: Not responding or does not turn on
Try this First...
Press and Hold the Sleep/Wake Button and the Home Button at the Same Time...
Wait for the Apple logo to Appear...
Usually takes about 15 - 20 Seconds... ( But can take Longer...)
Release the Buttons...
http://support.apple.com/kb/ht1430 -
My iphone 4, the apple logo just blank on and off.
You may have to let the battery fully drain
Try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar -
i pressed update on my iphone4 and now the apple icon just comes on and off every 10 secs and i cant turn on my phone. please help me..
Hello dagobertofromelsalvador,
Thanks for using Apple Support Communities.
For more information on this, take a look at:
iOS: Unable to update or restore
http://support.apple.com/kb/HT1808
Best of luck,
Mario -
Apple iPAD 2. Needs password to unlock iPAD; however there is a permanent keyboard displayed on the screen that does not respond to touch. iPAD switches on with button but does not turn off using it at moment. Can you help please?
Try a reboot by holding both the power and home buttons until the apple logo appears, ignore the red slider if that appears. See if that clears the glitch.
-
I restored my Iphone 3G using the settings on my phone to remove photos and contacts, however since then my phone remians sitting on the apple sign on start up and has been like this for days, have tried plugging it into my itunes but not recognised can anyone help
See this:
iPhone and iPod touch: Unable to restore
Maybe you are looking for
-
no one can ever answer my question. how can i message an actual adobe person? so frustrating.
-
Overprint bar chart (web template 3.x)
Hello All, I would like to over print 2 bar charts (==> 2 series) in my web template. Currently Serie 1 is displayed by bar in right and Serie 2 by bar in left. I try to get a solution to display Serie 1 behind Serie 2. How can I get this overprint ?
-
LOV Decode value returned by Pre-populate Adapter
Hi, I have a lot of UDFs of type LOV, in particular System LOV( that point to custom Lookup Field definitions). My problem is to get and return not the Lookup Decode value and not the Lookup Code Key (default OIM behavior) by a Pre-populate adapter.
-
Importing BAPI_PO_CREATE1 from 46c system fails
Hello, I imported BAPI "BAPI_PO_CREATE1" from a 46c system in a webdynpro project and after import i build the project. It gives following error. <b><b>[ddgen] [Error] Structure com.sap.example.create.types.Bapimepoitemx is not generated [ddge
-
Is there a Diadem script or command to determine the maximum lag of cross correlated data?
I am analyzing multiple data sets and ultimately need to plot and align 3 similar curves based on the the maximum cross correlation lag. Is there a function that will do this in Diadem or has anyone written a script to do so? I am new to Diadem and