My phone keeps on turning itself on therefore interrupts the ongoing "iPhone Recovery Mode" in iTunes. This then makes me go back to square one: restore and wait 4 hours over and over again. What do I do to make it not get up again?

My phone keeps on turning itself on, therefore interrupts the ongoing "iPhone Recovery Mode" in iTunes. This then makes me go back to square one: restore and wait 4 hours over and over again. What do I do to make it not get up again?

There's a whole lot to read in your post, and frankly I have not read it all.
Having said that, this troubleshooting guide should help:
http://support.apple.com/kb/TS1538
In particular, pay attention to the mobile device support sections near the bottom, assuming you have already done the items above it.

Similar Messages

Maybe you are looking for

  • How to count number of documents in a page with Tabs

    We have a page with Tabs and sub tabs for each Tab. There is no limit for the Tabs and Sub Tabs. I mean a Tab can have several child tabs and each child tab can have n number of Sub Tabs. We have documents laoded on Tab level and sub Tab level also.

  • Problem installing Win7 64 bit on early 2008 iMac 2.66 GHz

    I have read posts elsewhere that, contrary to what Apple says, it is possible to install 64 bit Windows 7 on an early 2008 iMac 8,1. The problem I'm having is that I can't get the iMac to boot from the 64 bit Windows 7 install disc. The error I'm get

  • Summarised Expense report required

    There should be one to one relationship for 1 GL code & 1 section code i.e. it should not repeat for the same GL Code & Same section Code. Summarized expense amount is required.

  • In Prem. Elements 8, how can I zoom in on one face in a slide?

    I am putting together a slide show in PE 8.  I have a slide with multiple face and want to zoom in on one face.  I don't want to zoom in on all the slides so I don't think I want to use presets.  Is there a way to do it for one slide? I also have PSE

  • RF programming problems

    I have been working my way through a series of problems with bespoke programs written for the RF terminal and have one I cant crack. It appears that LT06 performed via BDC will not work when executed on the RF terminal. The same code used via normal