Not getting Service interface in receiver side

Hi,
I am working on a newly configured PI server.
Here, I am working on a synchronous SOAP to RFC scenario from third party to ISU.
From the Display WSDL option of ID I have created a wsdl file and testing the scenario by importing wsdl file into SOAP UI. When I am sending some request from SOAP UI , I am getting proper response message ; that's mean interface is working fine and properly hitting the RFC in ISU.
I can see the message in SXMB_MONI of my PI server . But I am not getting the message in SXMB_MONI of ISU server . Even in SXMB_MONI of ISU I am not getting the inbound service interface also .
What can be the possible reason . As I am working on a totally new server should I do any configuration in the server to get the SI in receiver side.
Please help.
Thanks in advance.

Hi,
Please check if Sync logging is enable in ISU. refer the below blog
XI: I cannot see some of my messages in the SXMB_MONI
regareds,
Harish

Similar Messages

Solution Manager does not get service definitions from SAP in self diagnosi

Hi,
In our production solution manager transaction solution_manager, self diagnosis we are getting a warning message on our development solution manager.
Solution Manager XXX does not get service definitions from SAP.
The production Solution Manager is the master in SDCCN for the test Solution Manager. In the test Solution Manager, the scheduled task REFRESH SERVICE DEFINITIONS has task System ID of O01. It is pointed to RFC destination SDCC_OSS, not the production Solution Manager system.
It gives the same warning if I point the task to the production Solution Manager system.
Has anyone seen this before? Any ideas?
Best regards,
Russ

Hi,
i guess have you activated SDCCN from your solution manager system too?
if not please activate. since that setup helps solman retrive the service definitions used in SDCCN from SAP (SAPOSS).so this ultimately allows you to set solution manager system as Master, so all the satellite system get the service definition from solman and do not need a direct SAPOSS connection.
and Please check this Note 1143775 - SAP service content update
the wiki for trouble shoot ["EarlyWatch Alert is Red Flagged - how to resolve" |http://wiki.sdn.sap.com/wiki/pages/viewpage.action?pageId=228262728]
please check.
Thanks,
Jansi

After 04 months of purchase of iphone 5 the lock button is too hard. At times its not working at all. The phone has been purchased in USA now I'm not getting service in India. After all whats the point in spending so much amount without any service.

After 04 months of purchase of iphone 5 the lock button is too hard. At times its not working at all. The phone has been purchased in USA now I'm not getting service in India. After all whats the point in spending so much amount without any service.

The warranty says that Apple may restrict service of an iPhone to the country of sale, and any reliable salesperson will tell you that if you tell them that you plan to use the iPhone in another country. Such service restrictions are common with cellphones and are by no means limited to Apple's phones.
Sorry, but if your iPhone requires service, you will need to send it to someone you know in the US who can get it serviced and then send it back to you.
Regards.

Service is not getting Service ID in OSGI Bundle hence not starting ?

Hi ,
I am getting an unusual issue while deployement of service . I am using following syntax to write :
@Service(value=SomeService.class)
@Component(enabled=true,immediate = true, metatype = true, label = "Some Service")
Its not getting started and not getting service id as well.
Please help.

My OSGI-INF folder is not generating at all in the bundle.
How are you generating the bundle? maven? Is it a new one and never worked or does it stopped working suddenly?
Can you post the whole code?

I just activated my iphone 4s but i am not getting service

just activated 5 mins ago and is not getting service. have plugged it into the computer and restarted it.

The find my iphone app has nothing to do with finding that iphone. The find my iphone app allows you to find your other idevices from your iphone.
The find my iphone feature ( which allows your iphone to be found) is an icloud feature that you would have set up on the iphone itself.
If you did not do this, then you cannot track your iphone at all.

Not getting service in Reno

Is anyone else having a problem with not getting service in Reno, NV on their phones???

kennlisa,
Sorry that your service hasn't been up to par lately! Have you ever had issues there? What kind of problems are you having? What devices are you using?
Let us know!
Katie H
VZW Support
Follow us on Twitter @VZWSupport

Alerts not getting triggered for invalid receiver receiver

Hello,
My scenario is IDoc to HTTP.I have defined alert rules for my scenario.
I have condition mentioned in receiver determination.Depending on vendor number data is sent to corresponding receiver.
But when i send IDoc is sent with invalid vendor number,it is failing in XI system with error as :No receiver could be determined but not alert is being thrown or triggered.
Same situation is working in Dev and quality but not in production.
I ahve checked the alert rules thorughly in all the 3 environments and they are all perfe

does the error"RCVR_DETERMINATION.NO_RECEIVER_CASE_ASYNC" gets triggered only when reciever service is not
mentioned in alert rule condition?
This error gets triggered when no receiver matching with the mentioned Condition is found.....the Condition in Receiver Determination OR if no receiver service exists.
I hope you have created a rule in Alert Rule section of RWB and have unchecked the Suppress Multiple Alerts options.
When you get the above error in SXMB_MONI you should get an alert
Regards,
Abhishek.

Ipad not getting service in certain areas

I have an ipad with 3g support, all of the sudden it has stopped working in the gym where i used to have no problem. It shows i am connected but nothing is happening (even when i enable 3g) it works elsewhere, any suggestions?

shoegirl123 wrote:
my cell phone does not work in the gym (iphone) but i figured the 3g would overcome
The 3G used by the iPad is the same as on the iPhone. So, if you don't get service on the phone, you shouldn't expect to get it on the iPad. It may not even (probably isn't as there are lots of legal issues involved in jamming) be anything the gym management is doing. Some structures, especially those with thick concrete walls, lots of metal, wiring in the walls, block cell reception. It's a limitation of the technology.

Verizon iPad not getting serviced/replaced in india

I randomly made choice of Verizon while purchasing iPad from apple online store while I was in US last month, as choice was immaterial to me as I had to use it in India.
Later on after few days of use it's screen started to blink every at interval of 10s, when I took it to service center the people refused to replace it saying its gsm + CDMA model and they can't replace it in india.
This is very bad on part of apple as it was not mentioned any where on apple online store about such issue. It only mentioned that iPad will work with local sim but not what will happen if there is some hardware issue.

The warranty on the iPad says that service may be restricted to the country of original sale, and that is indeed the case with models that are specific to the CDMA US carriers, Verizon and Sprint. Those models can only be serviced in the US.
Your choices are to send the iPad back to someone you know in the US to take or send it to Apple for service, or call Apple customer relations in the US at 1-800-767-2775 (you will have to use one of the several methods, such as using Skype, for calling a US 800 number from outside of the country) and discussing the matter with them. Posing a complaint here will do you no good, since the only people who will respond are we your fellow users.
Regards.

Can not get back into my bios side. PN is 470040-148 Compaq Evo N410C.

PN is 470040-148 Compaq Evo N410C. On the bios side I changed my boot options and device options to boot off the cd-rom only because on lost my password. a friend mailed me a password finder cd which I used in my external cd-rom. I now can get into windows but only by hitting ctrl&delete. I hit the f10 key when prompted but nothing happens. I hit f2 to change the language and nothing happens is there an option other than these that will allow me to get to the bios side please help I'm trying to get the laptop ready for my young daughter.
I think I diabled my hard drive as well!!

Malkymder wrote:
Glad to hear it is a step forward ...
can you try with another Display manager like lightdm see if that works ?
I might try that, though now that I finally have my PC back I have some other work that takes priority for a few days. :-)
Malkymder wrote:And yes xorg.conf should be replaced with /etc/xorg.conf.d/20-nvidia.conf instead
I'm using `nvidia-xconfig` to generate that file (I haven't had to tinker with it manually for years now).
The tool generates this 'deprecated' file. Should I just move its exact content to the new location?

HT201328 My iPhone 5 will not get service on tmobile it was working fine till I erased all content n settings now it doesn't work at all

My iPhone 5 6.1.4 will not pick up tmobile service after I reset network settings. Now I'm unable to use my phone

Connect in recovery mode and restore as new device, explained in theses articles:
http://support.apple.com/kb/HT4137
Recovery mode:
http://support.apple.com/kb/HT1808

Idoc and message type not getting replicated in the receiver system

Hi
i have created a Z Idoc and didtributed the mode from system A ....I can see the distribution model in system B
However i cannot see the custom zidoc / message type in sys B.. Do i need to create the zidoc again in sys B

Hi Tarang,
at least ou need the required partner agreements and you should have a processing function for inbound IDoc. To implement this, the full definition of IDoc including Segment definition should be present in receiving system.
Just look at standard IDocs and do as they do.
Regards,
Clemens

TS3406 My phone some times not get service and some times can't make call

My phone some shows no service or I can make a call in a minutes it will cut off and says call failure

iPhone: Troubleshooting activation issues
http://support.apple.com/kb/TS3424

Paid for service... but not getting service

so i had an old number that was about to expire from a 3 month subscription, before it expired i purchased another number for 3 months just because i wanted a new number and let my old one go... well less then a week has passed and it did in fact charge me but now my service isn't on anymore is there something i missed or should i cancel their payment at my bank?

hi there, I have paid GBP 105.43 for 12 months services but why it still reduce my credit after i paid this service? I would like to use unlimited world immediately after i paid rather than my pay as you go.
could you please advise me as soon as possible?
thank you

Not getting message option while receiving calls on lock screen

Have even inserted the image of the problem for better understanding. Here i am not able to see the message option. This is a snap during an incoming call when the iphone is locked.

anyone?

Not getting Service interface in receiver side

Similar Messages

Maybe you are looking for