Possible to control/block access to the internet while using itunes,etc?

Parental control. I would like to require a password for access to Safari, etc, to control computer privileges - while keeping itunes, Pages, iphoto,etc open. I want to listen to my playlist without opening internet access to the kids. It must be possible!

Hi jarileys, and a warm welcome to the forums!
Did you set up Managed Accounts in System Preferences>Accounts for them?

Similar Messages

Is there any way to block access to the internet? Allowing only calls and texts?

I want to be able to block access to the internet on LG Revere 3 and just allow phone calls and texts. Is this possible?

Never mind...I got Verizon to put a data block on the line

How do I setup my Time Capsule (3rd Generation) to be accessed from the internet while I'm traveling?

How do I setup my Time Capsule (3rd Generation) to be accessed from the internet while I'm traveling? It is installed on my home network behind my TWC broadband router.

Ok.. since the TWC modem is also a router.. all configuration takes place on this box.. NONE whatsoever takes place on the TC.
There is no airport utility 7.7.3 but there is a firmware of that number for the latest AC model TC..
Is it tall like this.
Then it is Gen5.
otherwise it will have a firmware.. 7.6.4 or earlier and the airport utility must be 6.3 or earlier.
Open the Airport utility and give us a screenshot of the summary page.
That will also help us determine that you have the TC, which version and how it is setup.
You might want to press the edit and also give us the Internet and Network tab as they should be set correctly as well.
I have created a DDNS through DYN.com although I am not sure how to implement this into the TC.
You do not do anything in the TC.. set it up in the Ubee router.
Port forward 548 to the TC in the Ubee router.
And make sure the TC has a static IP in the Ubee router.
Overall if you find this too hard I strongly recommend you buy a product designed for remote access .. eg WD MyCloud.. they are cheap and easy peasy to setup for remote access.. by PC or Mac and since it is built outside of Apple you not bound up in Apple limitations built into all their equipment to prevent you using it the way you want.. rather than apple want you too.. eg BTMM and iCloud being the only way apple provide for access to the TC and only when it is the main router of the network.
You are fighting hard because Apple made this hard.. not easy.

I can not connect to the internet while using my ipad I get a message saying Safari could not open the page because the server stopped responding need help thank you

I CAN NOT CONNECT TO THE INTERNET WHILE USING MY IPAD I KEEP GETTING A MESSAGE SAYING SAFARI COULD NOT OPEN THE PAGE BECAUSE THE SERVER STOPPED RESPONDING PLEASE HELP THANK YOU

Try the following:
1. Turn router off for 30 seconds and on again
2. Settings>General>Reset>Reset Network Settings
3. Reset iPad; hold the Sleep and Home button down until you see the Apple Logo

TS1398 I can't connect to the internet while using wi fi on my iphone 4S.

I can't connect to the internet while using wi fi on my iphone 4S. I can connect on my computer and on my IPad but not with my iphone. I have tried everything. Once or twice it did connect but then disconnected immediately. I have tried everything.

LeeinSunnyIsles wrote:
I can't connect to the internet while using wi fi on my iphone 4S. I can connect on my computer and on my IPad but not with my iphone. I have tried everything. Once or twice it did connect but then disconnected immediately. I have tried everything.
If you have truly tried "everything" then there is no hope of it ever working again. However, have you tried rebooting your router?
Have you tried Settings/General/Reset - Reset network settings?

IPhone 4s with ios 6 shows full wifi signal but can't access to the internet while other idevice can

Hi everyone,
I updated my iphone 4s to ios 6 a few months ago and there was no problem until I change my sim card to other carriers last two days. This second sim card is the same sim card that I used it earlier this year with no problem. But the problem I face is when my iphone goes to sleep mode I realised that I can't receive any push notification from imessage, Whatsapp, and Line. When the phone is awake the wifi signal is back and I have to go to each application in order to get the message. I have tried the following methods but it didn't work: reset all network settings, restore as new iphone, push home and power button together, switch off my iphone, turn on airplane mode, and even change my router. At the moment I have restored my iphone as new for the 5th times.
Now the problem is worsen, after the phone is sleep for about 5 minutes and when I awake my iphone it shows the wifi signal. But I can't access to the internet at all. It shows no working internet on Whatsapp. Safari can't load any web page, the weather app can't update temperature etc. I have to switch off and switch on wifi in setting menu so that I can use the internet. And when I leave my iphone four about 5 - 10 minuetes then the problem start again. While I can't access to the internet on my iphone 4s, I used my dad's iphone 4s with ios 5.0.1 and it works just fine with the internet. My laptop can also access to the internet with the same wifi network but not my iphone.
Does anybody know what's going on with my iphone 4s? Is it the bug from IOS 6 or my iphone is broken? Please help me.
Thank you.

Any update will cause problems for a few users. And those users will rush here and post "the sky is falling" stories about their experience. The 99.99% of people who have no problems after an update won't bother to post here; indeed, most of them don't even know ASC exists. FWIW, I had no problems with iOS 7 on my 4S. Your problem is most likely not related to iOS 6, but you should probably update anyway. For addressing the battery issue see this outstanding article: http://www.overthought.org/blog/2014/the-ultimate-guide-to-solving-ios-battery-d rain

Firewall Config - Block access to the internet

What command would I use to block all internal access from a LAN, from reaching the internet?
Thanks

Hi
Well there are a number of ways to do it. One way -
local LAN 192.168.1.0/24
remote LAN 172.16.5.0/24
access-list acl_inside permit ip 192.168.1.0 255.255.255.0 172.16.5.0 255.255.255.0
access-list acl_inside deny ip 192.168.1.0 255.255.255.0 any
access-group acl_inside in interface inside
Couple of things to be aware of.
1) There is an explicit deny at the end of the access-list so if you have other networks you want to allow access to/from you need to include them in your access-list.
2) I'm assuming this is a pix firewall - is this the case ?
HTH
Jon

Hello,I wonder if it's possible to set up another wireless connection for using on airplay. My airplay works but I can't get on the internet while using it.

Hello,I would like to know if this is possible.

Well, first of this isn't making sense. I would fix the problem, instead of just trying to skirt around it, and still end up with the same problem.

Set up Wi-Fi correctly on iPad with Netgear Router WNR 2000 but it won't allow access to the internet?

I have a Netgear WNR 2000 wireless router and I have set up my iPad 2 to recieve the Wi-Fi Network correctly as it says I am connected to this network and the signal strenght is fine but when I try to access the internet through Safari, iTunes, etc. it says I am not connected to the internet. Is it possible there is some conflict between the iPad and this router?

Despite the WiFi sign you may not really be connected to your WiFi network.
Your router may not have given your iPad a valid IP address when the iPad requested it. To check on this go to Settings > Wifi > your network name and touch the ">" to the right to see the network details. If the IP address shown starts with 169 or is blank then your router didn't provide an IP address and you won't be able to access the Internet.
Sometimes the fix for this can be as simple as restarting your router (remove power for 30 seconds and restart). Next, reset network settings on your iPad (Settings > General > Reset > Reset network settings) and then attempt to connect. In other cases it might be necessary to update the router's firmware with the latest from the manufacturer's support web pages. There have been several firmware updates to the Netgear WNR 2000 router. You can get the latest firmware here:
http://support.netgear.com
If you need more help please give more details on your network, i.e., your router version, the wifi security being used (WEP, WPA, WPA2), MAC filtering enabled, etc.
Also test your iPad on some other networks. If it has problems connecting there it might have a hardware problem.

I installed dreamweaver on Windows. After installing it, it blocks my access to the internet. Solution? I discarded it and it was okay, but I need both dreamweaver and internet acces.

I installed dreamweaver on Windows. After installing it, it blocks my access to the internet. Solution? I discarded it and it was okay, but I need both dreamweaver and internet acces.

See iPhone DFU mode explained, and how to enter DFU mode.

Is it possible to edit a VIs block diagramm via the Internet (online programming) ?

Hi folks,
is there a way to alter the block diagram via the internet?
eg: i have a PC with Labview installed in my Lab and i want to alter a vi on this PC with my laptop at home (with installed runtime).
thx & kind regards,
mike

http://www.uvnc.com/features/index.html
This VNC client/server package includes an embedded JavaViewer so that you could control the other PC via an internet browser.
ALSO depending on your end purpose you could send someone a small executable to allow you to control their PC versus trying to get full VNC Server to work on their side.
Matt Holt
Certified LabVIEW Architect

I have accidentally blocked Firefox's access to the internet, how do I unblock it?

Earlier I saw a popup while I was browsing that said that Firefox was trying to access my internet, and at the time this seemed suspicious. I don't know why, but I pressed "block" which, in return, blocked my entire access of the internet through Firefox. I tried reinstalling Firefox, and I also tried to do stuff with the firewall but I didn't understand what to do. How could I allow Firefox to access the internet again?

Remove all rules for Firefox from the permissions list in the firewall and let your firewall ask again for permission to get full unrestricted access to internet for Firefox and the plugin-container process and the updater process.
See:
* https://support.mozilla.com/kb/Server+not+found
* https://support.mozilla.com/kb/Firewalls

How do I Set up a LAN with no access to the Internet?

I have a Solaris 10 (08/07) [No longer can acess the internet]
full install on one system, and Solaris 10 Developer Edition (09/07) on another system. Each has been auto-configured upon installation, and have reached the Internet, and registered at Sun Microsystems, from behind a router and cable modem.
I want to create a Local Area Network, using a 4 port Netgear Ethernet Hub, model EN104tp, Each of the Solaris 10 systems, a Windows XP Pro system, and a Windows Media Edition LapTop. +(Which I want to have additional admin control, and access to the Server, from!)+
My problem is this!
1) Do I have to change any files to eliminate, the access to the internet from the two Solaris machines via router and cable modem? If so which, and, how do I? +(I intend for the LAN to be isolated from the internet)+
2) What are the step by step, to set up a LAN?
I can't seem to find that info anywhere. Maybe I am looking in all the wrong places...
I appreciate and Thank You in advance for any help...

The only difference between LAN and Internet is the size.
Depends on how you define LAN -- it may be multiple subnets glued with routers or just one big or small subnet with bridges, switches and/or hubs or simply a crossed UTP-cable..
If you don't have routers then you won't need a /etc/defaultrouter (rm -f /etc/defaultrouter; /usr/sbin/route -fn)
You should use RFC-1918 addresses; i.e. chunks with a suitable mask of your choice as parts or whole of 10./8 (10.0.0.0 - 10.255.255.255), 172.16/12 (172.16.0.0 - 172.31.255.255) and/or 192.168/16 (192.168.0.0 - 192.168.255.255). Example 10.0.0.0/255.255.255.0 for a (256-2=)254-node subnet; 10.20.30.40/255.255.255.252 would suite a crossed-cable subnet perfectly.
A DHCP-server would be nice for PC's. Solaris can do that (/usr/sadm/admin/bin/dhcpmgr).

HT4410 I have just installed Windows 7 64-bit full version Home Premium using Bootcamp and cannot get access to the internet. I installed on a Macbook Air Mid 2012 with Mountain Lion. Are there some drivers that are missing from the Windows 7

Dear Apple. I have just installed Windows 7 64-bit full version Home Premium using Bootcamp and cannot get access to the internet. I installed on a Macbook Air Mid 2012 with Mountain Lion. Are there some drivers that are missing from the Windows 7 bootcamp install download from Apple

It is a Total Misconception that the Support files are installed when you are installing Windows, even if the USB drive that holds them is inserted in the system when doing the Windows install.
You must always Run the Setup.exe files from the support files or run the drivers individually once Windows has finished installing and booted to the desktop.
Also you really need to run the Boot Camp Control Panel Applet and check for updates as not all the newest drivers for full function of all the hardware is included with the original support download. That download is basically a generic version to get the system working and without doing the updates not everything will work properly.

Can Firefox ask for a password to allow access to the internet?

I need to control access to the internet in this workplace and require a password for access. Does Firefox have any way of doing that?

No it doesn't.

Possible to control/block access to the internet while using itunes,etc?

Similar Messages

Maybe you are looking for