Remote panel doesn't work

Question

I am using 2011 SP1 version of LabVIEW, toolkits and add-ons. I am trying to make the following remote panel opening VI work.
This used to work well on LabVIEW 8.5 but now I get an Error 7 from the last Invoke Node of the second loop. The top loop works fine. HPAC Main.vi is running as a startup VI on the RT target (PXI-8106). I can open its front panel using this VI. But the second loop can't open ST_viewer 1.vi. File names and paths are all correct. For building HPAC.rtexe, on the Source Files tab, HPAC Main.vi was chosen as a startup VI while ST_viewer 1.vi was put in the Always Included box. The VI server of the PXI is using TCP/IP port 3363. The PXI is directly connected to this host PC by an Ethernet cable.
I also made a very simple project (attached file named ServerTest), deployed its rtext to the PXI and ran it as startup. After rebooting, I tried to open the remote front panel of main.vi and sub.vi on the PXI using access.vi. I get the following errors at the Invoke Nodes.
For trying to open main.vi > Error 1352: Requested VI is not loaded into memory on the Server Computer
Fro trying to open sub.vi > Error 7: File not found......
As suggested in the article, Real-Time System Manager seems useful but I can't find it. Tools > Real-Time Module > and then I can't find the system manager. I only see Project Wizard, Configure Time-triggered Network and Execution Trace Toolkit. Does 2011 version have something else?
Any help will be appreciated!
Attachments:
HPAC Executable.vi ‏33 KB
ServerTest.zip ‏215 KB

Answer 1

Thank you, JaymeW. I found the VI States tab in the Distributed System Manager. And yes, all the steps in that article were already done.
If I set sub.vi as a startup VI on the PXI along with main.vi, then I can open it using the same method that opens main.vi. However, if I put sub.vi in Always Included box on Source Files tab and use the VI server to open it, I get errors.
On the VI States monitor, I see main.vi running as a startup VI on top level when I turn on the PXI. Then, I run access.vi and open main.vi successfully. When I click the sub.vi open button, sub.vi appears on the monitor with Run Top Level status but I get error messages.
At the first attempt to call the remote front panel of sub.vi, I get:
LabVIEW: Resource not found.
An error occurred loading VI 'lvfpp0.vi'.
LabVIEW load error code 3: Could not load front panel.
From the second call, I get:
Error 1000 occured at Invoke Node in access.vi
Possible reason(s):
LabVIEW: The VI is not in a state compatible with this operation.
Method Name: Run VI.
Could you take a look at the attached simple project and suggest a solution? Thank you!
Attachments:
ServerTest2.zip ‏218 KB