Restart WF after Error

Question

Hi All,
I have a Scenario where my WF ends up in Error after performing 5 Steps, at the 6th Step it gives Error.
Now my requirement is that, i have found the cause of Error and Rectified it. I want to Re-Start the WF from the same 6th Step where it ended up in Error.
I dnt want to re-Start the Whole WF again. I want to restart the WF from that particular Step Type only.
Please give ur suggestions in this regard.
Regards,
Kanika

Answer 1

Hi
As you want Re-Start the WF from the same 6th Step where it ended up in Error.
That step may be in 2 status
1. Error
then use Fm SAP_WAPI_ADM_WORKFLOW_RESTART . just pass the WI_ID of  the error task -6 step WI_ID , and yr WF wil start fm that step.
2. In prosess
then use Fm 'SAP_WAPI_ADM_WORKFLOW_RESUME. just pass the WI_ID of  the error task-6 step WI_ID , and yr WF wil start fm that step.
But for this , the error need to be resolved 1st .
3. If your WF is in error , means parent WI_ID is in error .
then read using SWW_WI_CONTAINER_READ ,pass the parent WI_ID  to this Fm.
get all the  wi_container to t_wi_container .
then using SWW_WI_START_SIMPLE  restart the WF .
You hav to pass.
creator : sy-uname
  task : WF templet no.
wi_id : parent WI_ID that  is in error
wi_container :t_wi_container .
this will restart the WF .
thanks
Kakoli.
Edited by: kakoli debroy on Jul 13, 2009 8:04 AM