Shutting down after booting for 10 seconds

Okay I just bought a new motherboard and CPU and I'll boot up the computer and 10 seconds later it will shut down.  The network card's green light will still be on but the computer won't boot up when I press the power button.  I have to unplug the power cord and plug it back in before it will turn back on.
This is what I have running:
MS-6570 ATX Mainboard K7N2 Delta Series
AMD Athlon XP+ 2600
30gig HDD
Lite-on DVD-ROM
CDRW (don't know the make)
512 DDR2100 266 RAM
Geforce 3 Ti 500
350W Power Supply
Now I'll boot it up with everything plugged in and it shuts down.  I ran it only with the HDD, DVD-ROM and vid card in it, shuts down.
I would really like to know whats going on here!

when i set J10 to safe mode it runs fine at 1100mhz.  when i set it to user mode it reboots after a few seconds.
wanting to run at 200mhz FSB, how do i fix this so it doesn't reboot?

Similar Messages

  • Mac shuts down after boot. Is it the logic board?

    mac shuts down after boot. Doesn't go beyond gray screen with apple.  Is it the logic board?
    I do not have the start up disks to safe boot or check the hardware.
    Any ideas what the problem is or is it junk?  It is 8 years old.

      Shutdown your machine.  Hold down the shift key.  Poweron.  Wait awhile Wait awhile while you harddrive
    is being checked.
        http://support.apple.com/kb/ht1455
    I'd let the machine sit for awhile in open firmware & see if it stays alive.  Do a few prints.
    Sometimes if volumes don't appear in Startup Manager (what you get when you hold down the Option key at startup), you need to reset the Mac's PRAM, NVRAM, and Open Firmware. Shut down the Mac, then power it up, and before the screen lights up, quickly hold down the Command, Option, P, and R keys, until the Mac has chimed twice more after the powerup chime. Then, before the screen lights up, hold down Command-Option-O-F until the Open Firmware screen appears. Then enter these lines, pressing Return after each one:
    reset-nvram
    set-defaults
    reset-all
    "The reset-all command should restart your Mac. If so, you have successfully reset the Open Firmware settings."
    http://support.apple.com/kb/TS1812?viewlocale=en_US
    How to eject a cd from the internal cd drive:
    eject cd
    List of devices:
    devalias
    Restore Tiger 10.4 & Leopard 10.5  DVDs are available from Apple by calling 800-767-2775 as of January 20, 2013.
    https://discussions.apple.com/thread/4720126?tstart=0

  • Photoshop CS6 shut down after using for 5mins; no image can be display on canvas.

    Photoshop CS6 shut down after using for 5mins; no image can display on canvas.

    Thanks for your help.  Actually the problem was solved when turning off the GPU.   In the mean time, I would like to upgrade my Video Card, too.  My existing vedio card detials are as below.  May I seek your advice on any good method other than replace it.

  • I-Mac shuts down after sitting for a while, why and how can it be fixed?

    i Mac shuts down when left for a time in sleep mode. Am I missing something or is this supposed to happen?
    It has never happened while anyone is using the computer but that may just be because it often sits over night without use.
    Am using a logitech Wave USB keyboard and mouse because my wife likes it.

    OK reset the SMC > http://support.apple.com/kb/HT3964
    1. Shut down the computer.
    2. Unplug the computer's power cord.
    3. Press and hold the power button for 5 seconds.
    4. Release the power button.
    5. Attach the computers power cable.
    6. Press the power button to turn on the computer.
    and check all of the power connections.
    The iMac's are sensitive to power issues (sag or momentary outage) while in sleep mode. If in the Energy Saver preference "Start up automatically after a power failure" is unchecked (as it should be) then you could/would/should find the iMac off after a power problem.

  • Several Apps seem to just mysteriously shut down after using for a while. Same with Safari, I will be using Safari and it shuts down. Face book too. I've reset and shut down my iPad 3 and restart it, but it stills shuts down. What to do?

    Several Apps seem to mysteriously shut down after using them for a while. Face Book shuts down , netflix, Safari, and other Apps. They work fine for a short while, or a long while, and then shut down and it brings me to my regular desktop screen. I've tried restarting by completely shutting down the IPad until I see the apple pic and turned it back on, but the shutdowns of apps continue. Anyone else have this issue? It generally started shortly after downloading and installing IOS 7......

    Hi jennyoutwest,
    Welcome to the Support Communities!
    The following articles will provide some troubleshooting steps for your iPhone.
    iPhone, iPad, iPod touch: Turning off and on (restarting) and resetting
    http://support.apple.com/kb/HT1430
    If that does not resolve the issue, refer to page 146 in the iPhone User Guide to Reset All Settings:
    iPhone User Guide for iOS 7
    manuals.info.apple.com/MANUALS/1000/MA1565/en_US/iphone_user_guide.pdf
    The final troubleshooting step would be to restore your device:
    iTunes: Restoring iOS software
    http://support.apple.com/kb/ht1414
    Restoring your device will delete all data and content, including songs, videos, contacts, photos, and calendar information, and will restore all settings to their factory condition. Before restoring:
    Verify that you are using the latest version of iTunes.
    Back up your device.
    Transfer and sync content to your computer.
    Cheers,
    - Judy

  • ICal for iPad 2 shuts down after 1 or 2 seconds

    When I start iCal on my iPad 2 it shuts down almost immediately.  I have tried to restore my iPad 2 but that hasn't helped.  Any ideas?

    Same thing is happening to me, I have already tried to shut down the application from the multitasking, turn off and on the ipad, reset settings, erase all accounts and nothing...have you had any luck so far??

  • MBP shuts down after booting from a disc

    How is everyone doing? I hope okay with their macs!
    Well, if I boot from my MacBook Pro Install discs, the computer boots off of the discs.
    But if I try booting off any media that I burned, the computer shuts down automatically.
    What I do:
    Put in the disc (I tried both DiskWarrior and Drive Genius 2),
    hold down the C key,
    the apple logo displays,
    the discs starts to spin louder (like if it were to start reading it),
    then the computer restarts after showing the spinning wheel for about half a second.
    I thought that maybe it had to do with me adding a firmware password as requested by Orbicule's Undercover... so I removed the firmware password and I still got the same results.
    Does anyone know why this is happening [to me]?
    Any replies or comments are thanked in advance.

    I found out why... its because I have the new macbook pro with the penryn processor.
    Penryn processor's fault.
    End of story.

  • P55-GD80 Shuts down after 15 to 20 seconds

    I'm just putting together a new system
    Motherboard P55-GD80
    PSU Corsair 750
    CPU I7-860
    GSKILL 8GB (4 x 2GB)
    The motherboard will POST correctly but after a few seconds it just shuts down. I barely have time to enter the BIOS but not enough time to save any changes. If I don't enter the BIOS then my Windows 7 Setup starts running but after a few second the whole thing shuts down.
    I was trying with all memory modules at first then read a post in the forum to try to boot with one stick first. I did that. I removed all but one, the first black closest to the CPU. I got the same exact behavior. The LED codes are all correct.

    The CPU has a Thermal Protection Feature that will cause the processor to automatically shut down, if the temperature reaches a certain point.  However, the temperature values that are of importance here are the Core Temperature values which are not shown in BIOS.  What you see in BIOS is the "general" CPU Temperature which is usually around 15-25°C lower than the CPU's core temperatures (depending on sensor calibration).
    If you get 66°C in BIOS, right after startup, this indicates that you do in fact have an overheating problem.  It seems that your processor is overheating rapidly after the system starts causing a thermal shutdown after 15-20 seconds. 
    Of course, this is only a hypothesis.  To verify/falsify it, please take of the heatsink, clean the contact surfaces of the heatsink and the processor, apply a proper amount of new/fresh thermal paste (not too less and most  certainly not too much) and then reseat the Heatsink.
    Test and see what happens after that.

  • Lenovo3000 N100 shuts down after boot

    I have Lenovo300 N100. Have been using it for 6 years. Now it has a problem. It shuts down automatically after boot. It stays on for about a minute or two and then powers off automatically. One strange thing is, If I start it after a long delay (4-5 days) it boots and stays on for a longer time (15-20 min) before auto power off. But more I use it, quicker it powers off. Any help. Avinash

    Hi  Avidesh
    Welcome to the community
    Since your system is powering on after few minutes after it is powered on . It seems to me that the Heat Sink Fan might have accumulated some dust and it is not able to properly cool down the system , that is the reason the system is powering Off after so me time . I  would recommend to have the heatsink fan cleaned properly
    You may Please refer to HMM user manual how to open the heatsink fan and then can clean same .
    http://support.lenovo.com/en_US/research/hints-or-tips/detail.page?LegacyDocID=MIGR-63486
    If you are not comfortable doing the servicing of your own , please visit the nearest service center for assistance
    Hope This Helps
    Cheers!!!

  • EOS rebel T3i: why is video recording suddenly shutting down after just a few seconds?

    I have made dozens of movies with this card. Suddenlly the camera automatically shuts down video recording after just a few seconds. I've made dozens of movies with this card. Reformatted card. Still happens.

    Sounds like a bad memory card. Have you tried another card? 
    Mike Sowsun
    S110, SL1, 5D Mk III

  • Macbook Pro shuts down after booting up

    I'm a new Macbook Pro owner running OS X.5. After booting up my computer "unexpectedly" quits and I need to hold power button and reboot. Sometimes it does this twice before finally operating normally. Any suggestions?
    Macbook Novice

    Either:
    a) Boot up in Safe Mode (hold down shift key at startup) to force checks and repairs
    or
    b) Boot holding down Apple/S (single user Mode) and don't let go until you see scrolling text.
    When that stops and you see a root#: prompt enter
    fsck -fy
    Let it run through all the checks and repairs.
    If it fails first time, at any time, or finds and fixes a fault - run the command again and keep doing so (some fixes can take several passes) until it says "Appears to be OK" then enter
    reboot

  • IMac 2010 27" shuts down after boot

    iMac was running fine and then I went to it and thought it went to sleep, but it was actually off.
    Odd.
    I reboot, it boots up (Lion) and everything is fine, and then a few minutes later, it shuts off. Try to boot agian, get the chime, and it shuts off.
    Now, whenever I boot it gets to the desktop and shuts off, if I try again right after it will hit the chime and shut off. The longer I leave it unplugged, the longer that it stays alive.
    Very odd.
    Anyone ever seen something like this? I have put in a new power supply, taken out and put in different RAM (as well as single sticks, one at a time), I have even switched logic boards (that was daunting). Since I have no warranty, I have nothing to lose...but it seems like a heat issue if you ask me, since the longer it is unplugged, the longer it runs (never going over 5-6 minutes).
    I have pulled out the i5 CPU and reapplied the thermal paste, so I don't think it's that either.
    All of the connections inside seem fine, the only thing out of the back is the USB keyboard. I have done the PRAM and SMC resets.
    Thoughts?

    Have you tried booting into the Recovery HD, selecting Disk Utility>Macintosh HD>Repair Disk to see if any repairs are needed.? If anything gets fixed/altered click on repair disk again until you get a clean pass. Restart as normal from the Apple menu. To do this, restart holding down Command + r (more details here: http://support.apple.com/kb/HT4718 ).

  • MacBook Pro shuts down after booting

    My MacBook Pro doesn't boot. It simply restart after the Apple logo and a few seconds of pinwheel.
    I can start it target mode, but I can't boot with a CD nor any other volume. It keeps on restarting.
    Any idea ?

    Hi B,
    You can't even startup in Single User?
    If you are getting the splash screen some starting is being done, press COMMAND+V after Power button and see if you can read something that would give a clue about the issue.
    If Single User is possible get the syslog report posted here.
    Good luck.

  • Mac Pro Shuts Down After Boot.

    Hey guys I have a 2008 Mac Pro. I went to turn it on today and It started like normal up to the Apple logo screen then shuts off. I've looked around on here for a while and cannot find any posts that have the same problem that I am having. Any ideas????

    Have you done any maintance on your mac pro lately?
    It might be clogged with dust and Cooling compound is likely dry as old bubbelgum.
    Try to check your internals of the mac if its clean, disassemble the heatsinks, both on northbridge, CPU and, GPU. Also remove the PSU cage to look for dust at/inside the PSU, if so disassemble the PSU and get it clean. Don't just stick a vacuum cleaner at the back.
    check this guide how to disassemble the CPU heatsinks
    http://www.youtube.com/watch?v=xOF435jCg8E
    If it don't help, call apple support or go to your nearest Apple store for repair service.

  • HD Video Cam Model #: VF0580 Shuts down after 3 seconds of recording

    My Vado HD Cam will automatically shut down after recording for 3 seconds. I have purchased and installed new battery and updated firm ware but it still happens.
    Any advice?

    Willizzz,
    Sorry, does the Vado HD Cam shuts down only when it's recording or does it turns off right after you turn it on?

Maybe you are looking for