TS3276 hi after updating to Mountain Lion, it becomes difficult to quit Mail, always have to Force Quit. And while Mail is on standby, the fan keeps on running full power, the laptop is hot. Why is this happening?

hi after updating to Mountain Lion, it becomes difficult to quit Mail, always have to Force Quit. And while Mail is on standby, the fan keeps on running full power, the laptop is hot. Why is this happening?

If your computer was hot it wasn't asleep - it either didn't go to sleep or it work up after you put it to sleep. I've seen both things happen. First, read this article and follow the instructions.
1) For the next few days/weeks pay attention to the blinking light on the front of your computer when you close the lid. Don't put the computer into your backpack/case until it begins to blink. Wait a minute or so after it starts to blink to make sure it doesn't stop blinking - the signal it woke back up.
2) having followed the above instructions, if you take the computer out and it is hot again or if you take it out and discover it has powered down (you'll know this because when it starts up the battery will be drained and you'll see a progress bar over a ghostly display that will eventually become normal) immediately start the Console program and perform a search on 'sleep' and then 'wake'. This should bring up all the recent log files about sleep state changes (going to sleep and waking up). You should see one for when you put the computer to sleep and put it away and the next one should be just after you got it out. You'll find at least one though that shouldn't be there. That will tell you when the computer work up (when it shouldn't have) and might give a clue as to why.
One of the whys could be a magnet that is making the computer think the lid has been opened.

Similar Messages

  • I have gone  into Lightroom and I get a message " Develop Module is Disabled" "Please renew your membership to reactivate Develop module" why is this happening?

    I have gone into Lightroom and I get a message " Develop Module is Disabled" "Please renew your membership to reactivate Develop module" why is this happening?

    https://helpx.adobe.com/lightroom/kb/unable-launch-lightroom-55.html

  • Line 6 tone port gx doesn't work properly after updating to mountain lion, i'm hearing artefacts, how is that possible?

    i am using logic 9 and line 6 toneport gx for recording my guitar. on the previous version of OSx everything worked perfect, but now, after updating to mountain lion, i hear noise after i play something. the settings were: input: toneport, output: coreaudio, 44100, buffer 512. now they are the same and i have noise. i've installed the latest drivers for toneport and changed the buffer settings. when the buffer is large, i can play some seconds without the noise but it appears after 15-20 seconds. and when the buffer is small it appears faster. i assume it has to do something with the buffer size but i don't know for sure. any ideas?

    I have the same problem after updating to ML. It's unusuable for recording until it gets sorted out.
    I think it's a problem at the Line 6 end. They are aware of it, and are working on some patch/fix to address the strange artifact sounds, so hopefully it will be ready soon.
    See link - http://line6.com/support/thread/86574

  • After updating to mountain lion, icloud password has not been accepted by system preferences

    After updating to mountain lion my icloud password in the system preferences has not been accepted anymore. I already changed the password. Also the new one is not accepted by the system preferences. On iPhone and online everything is fine. Any idea?

    I just got off the phone with Apple Support. They say they are having problems with iCloud and this issue should be resolved in 3-4 hours. We'll see......

  • After updating to Mountain lion I am having trouble printing to my wifi Epson printer

    After updating to Mountain Lion I am having trouble printing on my wifi Epson Workforce 645. I keep getting an error message and my computer is set in the system prefrences to that printer

    What is the error message?
    Try resetting the printer queues:
    http://support.apple.com/kb/PH11143
    This update also clears your "computer name" in Syst Prefs > Sharing, and entering a computer name solves network print issues for many.

  • After updating to mountain lion on my mac pro I am unable to connect my g-raid

    After updating to mountain lion on my mac pro I am unable to connect my g-raid 1T external hard drive using the firewire connection? I have 4 places to plug the firewire into, none work. All ports used to work with Snow leopard?

    Try this:
    Boot into Safe Mode then restart normally.
    Repair the Hard Drive and Permissions - Lion/Mountain Lion
    Boot to the Recovery HD:
    Restart the computer and after the chime press and hold down the COMMAND and R keys until the menu screen appears. Alternatively, restart the computer and after the chime press and hold down the OPTION key until the boot manager screen appears. Select the Recovery HD and click on the downward pointing arrow button.
    Repair
    When the recovery menu appears select Disk Utility. After DU loads select your hard drive entry (mfgr.'s ID and drive size) from the the left side list.  In the DU status area you will see an entry for the S.M.A.R.T. status of the hard drive.  If it does not say "Verified" then the hard drive is failing or failed. (SMART status is not reported on external Firewire or USB drives.) If the drive is "Verified" then select your OS X volume from the list on the left (sub-entry below the drive entry,) click on the First Aid tab, then click on the Repair Disk button. If DU reports any errors that have been fixed, then re-run Repair Disk until no errors are reported. If no errors are reported then click on the Repair Permissions button. When the process is completed, then quit DU and return to the main menu. Select Restart from the Apple menu.
    If this does not work to fix the problem, then:
    Reinstalling Lion/Mountain Lion Without Erasing the Drive
    Boot to the Recovery HD: Restart the computer and after the chime press and hold down the COMMAND and R keys until the menu screen appears. Alternatively, restart the computer and after the chime press and hold down the OPTION key until the boot manager screen appears. Select the Recovery HD and click on the downward pointing arrow button.
    Repair the Hard Drive and Permissions: Upon startup select Disk Utility from the main menu. Repair the Hard Drive and Permissions as follows.
    When the recovery menu appears select Disk Utility. After DU loads select your hard drive entry (mfgr.'s ID and drive size) from the the left side list.  In the DU status area you will see an entry for the S.M.A.R.T. status of the hard drive.  If it does not say "Verified" then the hard drive is failing or failed. (SMART status is not reported on external Firewire or USB drives.) If the drive is "Verified" then select your OS X volume from the list on the left (sub-entry below the drive entry,) click on the First Aid tab, then click on the Repair Disk button. If DU reports any errors that have been fixed, then re-run Repair Disk until no errors are reported. If no errors are reported click on the Repair Permissions button. Wait until the operation completes, then quit DU and return to the main menu.
    Reinstall Lion/Mountain Lion: Select Reinstall Lion/Mountain Lion and click on the Continue button.
    Note: You will need an active Internet connection. I suggest using Ethernet if possible because it is three times faster than wireless.

  • After updating to Mountain Lion, Mail has lost the RSS feeds, the colored marked mails folder, and the notes

    After updating to Mountain Lion, Mail has lost the RSS feeds, the colored marked mails folder, and the notes. Where are they?

    why did they erase something usefull and easy to use?

  • After updating to mountain lion, my Safari e-mail thru AT

    After updating to mountain lion, my Safari e-mail thru AT&T, doesn't show the select all button at the top of the e-mail list, it is there in Chrome and Firefox. Is this a problem with AT&T's site or are others experiencing this same problem. Also my contacts list has change it's look and you can't select multiple contacts.

    Hmmmm,
    Thread 0 Crashed:: Dispatch queue: com.apple.main-thread
    0   com.apple.phonenumbers   
    0x00007fff8e0300cb 0x7fff8e02e000 + 8395
    1   com.apple.phonenumbers   
    0x00007fff8e02f50b 0x7fff8e02e000 + 5387
    2   com.apple.phonenumbers   
    0x00007fff8e02f87d PNIsValidPhoneNumberForCountry + 112
    Any ideas on your end on this phone number for Country???

  • Option in MAIL to "Add to iPhoto" isn't working after updating to Mountain Lion. Anybody else with this problem or sulution?

    Option in MAIL to "Add to iPhoto" isn't working after updating to Mountain Lion. Anybody else with this problem or sulution?

    A brief search. Or even glancing at the "more like this" list to the right will show that this is a known problem and there is no current solution. Workaround includ saving to the desktop and importing from there or opening in Quick Look and adding to iPhoto from there
    LN

  • When my 6 year old daughter plays the free games that I have downloaded for her IPAD and IPOD, I am now getting upgrade charges on these free games to my AMEX Card. WHy is this happening and how do I get my AMEX card off of the IPAD and IPOD?

    When my 6 year old daughter plays the free games that I have downloaded for her IPAD and IPOD, I am now getting upgrade charges on these free games to my AMEX Card. Why is this happening and how do I get my AMEX card off of the IPAD and IPOD?

    She is making in app purchases. Probably not knowing what that means to your monthly credit card bill. Use the Settings app to enable restrictions and turn on restrictions for iTunes, App Store and in app purchases, mabe some others too. The restrictions will be set with a passcode to prevent your daughter from changing them.
    Settings > General > Restrictions

  • My ipod touch 4 has recently started shuffling all the time even though I don't ask it to.  Why has this happened and how can I stop it?

    My ipod touch 4 has recently started shuffling all the time even though I don't ask it to.  Why has this happened and how can I stop it?

    Music automatically shuffling This discussion thread may help you.

  • Apple TV icon is not showing on macbook pro after update to Mountain lion

    I wanted to try Mirroring from my macbook pro to my tv using the new airplay update from Mountain lion but the icon is not showing after the update.

    Welcome to the Apple Community.
    AirPlay Mirroring requires a second-generation Apple TV or later, OS X 10.8 or better and is supported on the following Mac models: iMac (Mid 2011 or newer), Mac mini (Mid 2011 or newer), MacBook Air (Mid 2011 or newer), and MacBook Pro (Early 2011 or newer). It also requires the computer to be using wi-fi.

  • Mouse and keyboard problem after updating to Mountain Lion

    Hi!
    This is the strangest problem I got on a Mac for 20 years...
    I work on a Macpro 3,1. I upgraded my 10.7.5 os to 10.8.5 (needed it to use GTX 680 card).
    The upgrade went fine and then... The mouse and the keyboard don't react.
    After resetting the SMC they began to react but the mouse is deadly erratic and the keyboard repeats few time each key (impossible to write), for instance I hit n and got nnnnnn.
    Resetting PRam does not help. Redoing the os update did not help.
    This is really bad cause I can't use my Mac at all right now. I think I'll do a Fresh lion install and move my data back to it before I find something for that Mountain.
    Its a real pain, does someone have an idea?
    Thank you,
    Milosz

    Hi!
    For those interested, I found the solution reading others forums.
    Here it is:
    I had to remove my optional old apple airport card (atheros a/b/g) and everything works fine now.
    Hopefully I don't wifi on that Mac, otherwise I would need to buy another one. Which one? I don't know.
    Too bad Mountain Lion isn't supporting anymore that apple card…
    Have a nice day

  • Macbook pro freeces after sleep (after update to mountain lion)

    hi,
    i got a annoying problem (because it kills one of the macbooks biggest features):
    since i updated to mountain lion, the macbook won't come back from sleep mode.
    so if i reopen it, the apple-logo appears with a loading bar underneath. when reaching the last bar of the loading bar, nothing happens any more - i have to restart.
    i already tried this SMC-reset, but this did not help. bluetooth is not turned on (which i figured out could be a problem).
    any ideas?
    thx, rainer

    These machines were never meant to be "laptops."  Not since the late 1990s were Macs truly "laptops" in terms of their heat.      As long as nothing else is out of the ordinary, and you aren't being asked in four languages to shut down the machine, just keep it on a cool well ventilated surface that is not made out of felt or cotten, and you should be fine.  There numerous pads for notebooks that can cool it down with or without fans.  Don't get the iCurve, as the rubber on it can lose its adhesiveness.

  • Volume not working after update to mountain lion?  cannot figure out how to fix

    update to mountain lion today, now cannot listen to itunes, no volume on facetime etc . . . cannot figure out what problem is
    Thanks

    Hi Al,
    Long shot, but...
    Open Audio Midi Setup in Applications>Utilities, see the input & output options & KHz setting there, some things will change it for their own use, then not set it back.

Maybe you are looking for