Whats all needed to remove to change the lower RAM?

I ordered a 256 Meg low profile ram chip for my lombard. I was gonna pop it in the top slot but i figure might as well do the bottom one. I know u have to use a credit card or soemthing plastic and flat to raise the processer board and remove the lower RAM and put the new one in and i guess put the 64 MEG chip in the top slot for now. Some instructions i seen online require removing the model, PRAM battery and hardrive in order to do this. Whats is needed exactly? These instructions were from pbfixit.com. I dont see why the modem is needed but maybe i am not seeing something. I could just put it in the top slot but eventually i will have to do the bottom so might as well now.

The PowerBook FixIt guides are a little elaborate, all you will need to do is lift the processor card after lifting the keyboard, removing the upper metal shield and the screws holding the card down (if it has the plastic tab still attached pull it while GENTLY levering with a plastic item). Install the RAM and then refit the processor card pressing down FIRMLY on the connector area. Finally install the top RAM.
Make sure you ground yourself by touching the 'Book's metal frame before starting and don't do the upgrade while stood on carpet or sat in a chair that has an artificial covering if you can help it.
I believe the Lombard only has a small heatsink so you shouldn't need to remove it before removing the processor card and I've never had to remove any of the other parts to fit lower RAM..

Similar Messages

  • Need BAPI name to change the PO data in SRM.

    HI All,
    Need BAPI name to change the PO data in SRM.
    The BAPI_PO_CHANGE is not available in SRM.
    If there is no BAPI to change PO in SRM, what is the alternate solution?
    Regards,
    A.I.Rajesh.

    hello,
    try using FM BBP_PD_PO_UPDATE.
    regards.

  • How to remove and change the color of Java cup and border

    Hi to all,
    How to remove and change the color of Java cup and border.
    Thanks in advance
    khiz_eng

    This is just an Image. You would need to create your own image and call setIconImage(Image) on your JFrame.

  • HT5312 what do i need to do to change the email address for when i try to reset my password for my account?

    what do i need to do to change the email address for when i try to reset my password for my account?

    Welcome to the Apple Community.
    Start here, change your country if necessary and go to manage your account.

  • I need to remove myself as the primary administrator for a CC acount and assign to another administrator. How should I proceed?

    I need to remove myself as the primary administrator for a CC acount and assign to another administrator. How should I proceed?

    adobe forums, only to discover Adobe doesn't allow a primary admin to ever leave. This is rather silly as people leave workplaces, they don't stay for life. An answer in a different forum on this site said one must cancel their adobe account, then start a new one. Though... Adobe doesn't allow a person to cancel their adobe account. It all must be done via Adobe customer service, which has proved non existent. There is no email address to email a request, there is a chat option which claims 24/7 chat however this functionality doesn't seem to work on my new Lenovo computer, current IE explorer running Windows 8.
    Adobe - you really need to sort this out. I have left the work place where I was the Team Administrator some months ago now and now I need to be removed from that workplace account completely. Currently, I still have full access to it, which is not good from a security point of view because if I were a disgruntled ex-employee I could play havoc with my workplaces subscription and access their confidential files stored in the cloud.
    Looking through the Forum, there is a great deal of conversation on this exact point. I'd suggest you answer this one, then create a sticky so people don't keep creating new threads and then see about resolving the issue so that Primary Admins can change in future, and be removed when they leave the workplace.
    Thanks
    Geoff

  • Precautions i need to take when changing the Character set

    Hi,
    ORACLE VERSION: 10G Release 1 (10.1.0.3.0)
    I am going to change my database's characterset from AL32UTF8 to WE8MSWIN1252 character set and AL16UTF16 NCHAR character set. So i have few questions for you.
    1. What is the difference between Character Set and National Character set? Do i have to set both?
    2. What are precautions that i need to take while changing the characterset?
    3. What are JOB_QUEUE_PROCESSES and AQ_TM_PROCESSES parameters in Plain English? Why do i have to set these parameters to 0 as mentioned in this post below.
    Storing Chinese in Oracle Database

    1) The database character set controls (and specifies) the character set of CHAR & VARCHAR2 columns. The national character set controls the character set of NCHAR & NVARCHAR2 columns.
    2) Please make sure that you read the section of the Globalization manual that discusses character set migration. In particular, going from UTF-8 to Windows-1252 is going to require a bit more work since the latter is a subset (and not a strict binary subset) of the former.
    Justin

  • %HA_EM-3-LOG: NAC-RADIUS-FAIL-OPEN-DEAD: All RADIUS servers are dead changing the nac-enforcement ACL to permit all

    We just implemented ISE 802.1x in couple of our  Cisco 4507 switches  and we are seeing the following error in the log.
    %HA_EM-3-LOG: NAC-RADIUS-FAIL-OPEN-DEAD: All RADIUS servers are dead changing the nac-enforcement ACL to permit all
    I paste it in the Cisco error message decoder and came back with not found.
    Thanks...

    Jimmy,
    Srory for the late reply but it turned out to be we needed to add the missing auth data vlan command on the switch. After that the error went away.
    Thanks for you input I do appreciate it.
    Jack.

  • What role needs to be assigned to the user to access existing custom OData services?

    Hi all,
    What role needs to be assigned to the user to access existing custom OData services?
    With SAP ALL its working. But cannot assign that to all users. Whats the specific role for this?
    I tried with /IWFND/RT_GW_USER. But it says the role does not exist.
    Thank you,
    Achu

    Hi,
    As usual you need to build a role by yourself based on your requirements. In case of Odata services there are two different TADIR services that needs to be added. One corresponds to authorization to execute logic on backend server and the other one to access service on front end server. You can get specific services by tracing one call using ST01. For Fiori apps from SAP you get role templates. You can use them for inspiration.
    Cheers

  • Months ago I opened an account at Argentina store. Recently I moved back to my born country, Brazil. How I need to proceed to change the country from Argentina to Brazil, keeping my ID, password and not lose my purchased content?

    Months ago I opened an account at Argentina store. Recently I moved back to my born country, Brazil. How I need to proceed to change the country from Argentina to Brazil, keeping my ID, password and not lose my purchased content? I share the content with my iPhone4, my iPad2 and all sync with my MacPro

    Also see http://support.apple.com/kb/TS3998

  • My ipad2 is asking old id password, when i go to forget password link for that id then I am not getting any mail to reset the same. Please help how can i remove or change the old id.

    my ipad2 is asking old id password, when i go to forget password link for that id then I am not getting any mail to reset the same. Please help how can i remove or change the old id.

    You cannot remove or change the old ID. This is Find My iPhone Activation Lock. You need to recover the credentials for the Apple ID originally used to activate the iPad.
    Check your spam and junk folders.

  • Photoshop is using the cc Hangul version  What happens if I want to change the English version?

    Photoshop is using the cc Hangul version
    What happens if I want to change the English version?

    What happens if we decide to stay in the program after 12 months? Will we keep getting charged monthly or will we eventually not be asked to pay for it if we've, let's say, cumulatively "paid up" for the softwares?
    You never stop paying for subscription software. You will keep getting charged monthly. It's not a hire purchase agreement where you own the software after paying a set amount for an agreed time period. Neither is it a lease where you pay a residual amount to own the software at the end.
    You will keep paying the monthly fee for as long as you want to use the software. If you want to use the software forever then you keep paying forever.
    On the plus side, you get all updates and upgrades for free as part of your membership.
    When you stop paying the monthly fee, you lose the use of the software.

  • Lots of existing threads, but no consistent answer - what settings need to be applied to the 2012 (new) Airport Express for it to work at hotels with an ethernet only connection?  Any answers specific to Japan would be helpful.

    Lots of existing threads, but no consistent answer - what settings need to be applied to the 2012 (new) Airport Express for it to work at hotels with an ethernet only connection?  Any answers specific to Japan would be helpful.  I would prefer not to take my old Dell laptop and just be able to use my Ipad 2 via the wireless connection that the Airport Express creates.  However, I can configure the Airport Express at home prior to leaving if that is the best thing to do.

    I have a very similar problem with my AE! My MacBook, MacBook Pro & iPod Touch (1st Generation) all get a GREAT signal from our AE. BUT, our iPod Touch (2nd Generation) and new iPad (WiFi) get terrible signal strength unless we're right next to the AE!! Tech support at Apple is of no help! I'm ready to sell them all! This all started when we got the last OS update for iPod Touch/iPhone/iPad. So it must be a software issue not a hardware one..
    Any ideas?

  • How to remove or change the color of hair in a beard? [was:does anyone know]

    how to remove or change the color of hair in a beard

    There are many ways to do that and there are many free tutorials on the web for doing that in Photoshop.

  • I lost an Iphone 5 and got a new one on the next day by mail but it still doesn't work, what I need to do to activate the phone?

    I lost an Iphone 5 and got a new one on the next day by mail but it still doesn't work, what I need to do to activate the phone?

        Let's ensure we get this new device up and running, 123Vika. I know the importance of having a functional device. I have some great news you can activate the device directly from My Verizon. Take a look; http://vz.to/1gdvahs
    YosefT_VZW
    Follow us on Twitter @VZWSupport

  • HT201209 Have redeemed a $20 iTunes gift card and at top shows $20 but when I go to purchase anything it is asking to use credut card? CAn anybody tell me what I need to do to make the cost come off my gift card redeemtion and not my credit card??

    Have redeemed a $20 iTunes gift card and at top shows $20 but when I go to purchase anything it is asking to use credut card? CAn anybody tell me what I need to do to make the cost come off my gift card redeemtion and not my credit card??

    Hi Kim ...
    Might not just be the security code > iTunes Store: My credit card's security code or zip code does not match my bank's records
    Apple "verifies" your billing credentials with every transaction.
    what does my debit card have to do with my having a redeemed ITunes card
    If the total purchase price of the media including any applicable taxes or fees exceeds the balance of the redeemed card, then the difference is charged to your debit or credit card account.
    iTUNES STORE - TERMS AND CONDITIONS  <  re taxes and fees
    You don't have to have a credit or debit account setup >  Create an iTunes App Store account without a credit card

Maybe you are looking for

  • Can we do data slicing in apex.

    Hello, I've got very interesting requirement, but m unable to figure out the solution. I have a table in which data is stored in such a way as shown in figure(1) below. In Apex report I have to show it like as in Figure(2). Please help if anybody has

  • Help Embeded flash only works locally.

    Please could someone help me. I am new to flash and have created my first flash video, a simple set of fading photos for my website front page. I am using Flash, Dreamweaver and Fireworks all CS3, The webpage can be found at http://www.wildennerdale.

  • Where did my playlists Go?

    I had created some playlists which I now have on my standard Ipod. I just purchased a new 3rd gen Nano and noticed that the playlists that were on my syncing laptop are there, in iTunes in name, but the contents are not. The entire set of playlists t

  • Problems with psi and irssi.

    I installed Arch few hours ago. I packmaned psi, but it can't fint such a lib: [vrok@ankh vrok]$ psi psi: error while loading shared libraries: libXss.so.1: cannot open shared object file: No such file or directory I've got XFree86 4.3, straight from

  • Cleaning up Old systems or marking obsolete after upgrade

    Hello there, We have 80+ systems in our landscape.  We have SAP R3 4.7 Enterprise to ECC 6.0 installations.  We have BW systems.  We have PI systems.... We just went through an upgrade of our oldest system that was 4.6C.  We had manually placed these