Why my ipad 2 can not recognize the vga cable with the new ios 8
When i connect my vga cable to my ipad´s cable port the ipad gives me a pop up telling me that the accesory may not be supported, this started happening when i installed ios , when i used to have ios 7 ii had no problems at all. is there a solution to it, if there is, what can i do to solve it?
Try connecting to iTunes (computer) and Check for Update.
Similar Messages
-
Why will my iPad 2 not recognize any iPod cables? I have tried two different cables in both the wall and in my laptop, but it will not register that it is receiving power, nor will the laptop recognize that they are connected.
Crizzo is right, the best way to charge is with the included power block. That said, the USB cords are interchangable as far as an of us know. (just not power bricks, iPhone and iPod bricks put out 5W of power, the iPad wants 10W and will always say 'not charging' if plugged into less power than it requires even though it will charge, just very slowly)
If you have tried to charge your iPad - with the iPad charger - with multiple cables and multiple computers and get no joy then it's time to head to the apple store and have them check it out. The 30 pin USB port can go bad - mine did - and it's a manufacturer's defect (unless there's any sort of obvious damage) and should be covered under the warranty; -
Why my ipad can not update the ios7.1.1
why my ipad can not update the ios 7.1.1
Hello there, crivera350.
The following Knowledge Base article offers up some great steps for if you are unable to update your iOS device:
If you can't update or restore your iOS device
http://support.apple.com/kb/ht1808
Recovery mode erases your device and restores it, which should resolve the issue. If you previously synced with iTunes or iCloud, you may be able to restore from your backup after recovery.
Turn off your device. If you can't turn it off, press and hold the Sleep/Wake and Home buttons at the same time and wait a few seconds for it to turn off.
Plug the device's USB cable into your computer only.
Hold down the device's Home button as you connect the USB cable to it.
When you see the Connect to iTunes screen, release the Home button. If you don't see this screen, try steps 1 through 3 one more time.
iTunes should open and display a message such as: "iTunes has detected an iPhone in recovery mode. You must restore this iPhone before it can be used with iTunes."
Use iTunes to restore your device.
If you don't see your device in iTunes, follow these steps for Mac or these for Windows.
Thanks for reaching out to Apple Support Communities.
Cheers,
Pedro. -
I can not join my Apple extreme with the Apple express. I shows a conflict in the network! I've tried everything. How can they join on the same network?
It says that my DHCP has to be changed! How? to what?
It is 802.11g.express. but is set to default by the computer (Macbook Air).
The other is 802.11n. (express)
Extreme is 802.11.g. Is the Main Airport.
It is on ethernet & wep 128 security. -
I can not sync my iPhone 4s with the iTunes wifi sync due to an error saying it will resume when mobile restore floater 7 is available??
I am having the same issue except mine was Floater-4. Anyone knows the answer, please reply. Thanks!
-
My iPad does not show me iTunes Radio with the new iOS 7 update
My iPad does not show me iTunes Radio with the new iOS 7 update
Hi, Abhishek642.
Thank you for visiting Apple Support Communities.
If you are a U.S. customer try forcing all applications to close and power cycle the device.
iOS: Force an app to close
http://support.apple.com/kb/ht5137
If the issue persists, try signing our of the iTunes & App Store on the device and signing back in.
iOS: Changing the signed-in iTunes Store Apple ID account
http://support.apple.com/kb/HT1311
For more information on iTunes Radio and it's availability, see the article below.
About iTunes Radio
http://support.apple.com/kb/HT5848
Cheers,
Jason H. -
Has anyone seen this issue before?
Possibly. Do you have other devices and will they connect?
One possible thing that it could be is that the USB port on your iPad has gone bad. It happened to mine. Couldn't sync, could barely charge (it said 'not charging' even when plugged into the wall)
I'd take it to the apple store, see if they can replicate it, and if they can, then they can diagnose it. Just back it up before you go, in case they do exchange it. -
My bank website has been bookmarked for years and now I receive an error page when attempting to access the site.
Works on my Win 7 Pro 64 bit system, running FF 3.6.15
I do not recommend bookmarking any financial web sites. Manually type the address carefully is the best security practice. Never store passwords on your system unless they are encrypted with a strong password. Or you are telling the "bad guys" way too much if your system becomes compromised.
FF settings: Tools, Options, Privacy Tab, Exception Button, add
http://www.frederickcountybank.com
web address and click Allow Button, ALSO check for any BLOCK settings. Click
close button, ok button and Test the results.
Check your security software settings, you may be blocking at that level, firewall and FF add-ons. -
I can not send a sms message with my iphone4S ios 5.1
I can send as mms and call but I can not send sms
So you did not read about iMessage before you bought the iPad? If you did, you would know that you can only text other iOS 5 users.
http://www.apple.com/ios/features.html#imessage says:
iMessage
iPad and iPod touch join the conversation.
With iMessage, we’ve created a new messaging service for all iOS 5 users. You can send unlimited text messages via Wi-Fi or 3G from your iPad, iPhone, or iPod touch to anyone with one of those devices. iMessage is built into the Messages app, so you can send text, photos, videos, locations, and contacts. Keep everyone in the loop with group messaging. Track your messages with delivery receipts and optional read receipts, see when someone’s typing, and enjoy secure encryption for text messages. Even start a conversation on one of your iOS devices and pick up where you left off on another. -
Why my ipad can not backup or upgrade?
when i upgrade my ipad, there is a windown pop out said "there is a mistake blabla, ", the same thing happened when i try to backup. i already try to reset my ipad and do it over again, not works.
The content of the error message that you are getting could be important for the resolution of your problem. I highly doubt that it was "blabla". Why don't you take the time to actually type what the error message was and post it here.
-
Can I connect dual vga monitors with the HP Pavilion p6724y
I'm looking at purchasing the HP Pavilion p6724y and currently have 2 vga monitors I'd like to use. Is this possiable?
Hi Stacey ,
Welcome to forum..
You need to get a video card with 2 VGA port .,, and install it on the computer to attach both monitor,,,
You can check local computer store for video card with 2 VGA port..
Click on the Kudos sign on left to say Thanks... -
I have a full subscription for creative cloud, Could not get XI to install, thought it was a conflict with 9 that was on my machine. Un-installed them both on accident. Now the Cloud says I have it, but in truth I do not. How can i re-install it. Use it a lot in the proofing stages of projects.
Hi DebFAlden21 ,
Thank you for posting on the Adobe Forums, you can download Acrobat from the URL mentioned below.
You can install the trial and once you sign in, it would be a licensed version.
https://www.acrobat.com/free-trial-download.html?trackingid=KLBBQ
Thanks,
Vikrantt Singh -
I always use Keynote for presentations and would like to use the Universal Dock to put the Iphone and move slides. Someone got something?
Have you tried this without the universal dock?
-
Blinking white light HDMI graphic on TV... That's it, nothing else. What can I do?
The ATV is telling you it needs to be plugged into your computer and restored through iTunes.
Here is the Apple support page.
Hope this helps.
PJRS -
My printer is Samsung SCX-3405 HW that is airprint compatible.
But my iPhone & iPad can not recognize it.!
Help me please. What's wrong?!
Thank youI've just installed this printer and enabled - everything is working on airprint with my iPad2, iPad Air, Macbook and Mac Mini.
The trick was to connect to the printer's wireless network directly (the direct connect box must be clicked when you're setting up with a USB connection) first. The next time I tried to find the airprint printer, it was there.
There is a password associated to the printer's direct connect network as well (setup utility gives you this). I'm guessing that once it's in the keychain for the device, it can find it and connect to it.
Anyway - this should solve the mystery. It's all installed and working. I didn't have to do a firmware upgrade (not available except as a windows.exe file), but I did install the latest driver off of the support community. I couldn't get the scanner to work until the driver was up to date.
I'm running OSX 10.9, printer is Samsung SCX-3405FW, iPad software is latest on both iPads.
Maybe you are looking for
-
How to Reference a Slice from a Hotspot in a Add Behavior
I want to create a command that does the following ;: the user selects several items and runs a command that will copy that selection to another frame (prompt for frame number), create a slice around that selection, hide that content on frame 1, inse
-
I copied the places.sqlite folder from a crashed drive (FF 3.6.15, Windows XP) to the new computer (FF 4.01 Windows 7) per instructions, to appdata/roaming/moz/fire/profiles etc. There are also JSON/bookmark backup files on the old drive's directory,
-
Why are my placed images in Illustrator dimmed?
I just got a fresh install of Illustrator CC and every time I place a raster image into my document, it appears dim or very light. When I go to export the image, the PNG file displays the image correctly.
-
Login prompt appearing when opening Excel Files - SharePoint 2010 SP1 - Office 2007
hi, i have 2 sites on the same server, 1 at Port 80 and 1 at port 8300 https://contoso.com https://contoso.com:8300 Both are under same AD and credentials. But when users on 8300 port site, tries to open office files such as Word or Excel. In read on
-
Who to unlock an i pod tuch when not remembering pass code
how to unlock an i pod tuch when not remembering the pass code does any body know???????