Wireless 3dTactic Rage - beeping sounds and cannot turn off . . .

For some weird reason i cannot turn off my headset anymore.
It doesn't work.
When i try, it simply looses connection with pc and reconnects. At least i'm guessing that's what's happening.
The USB transmitter is swithching between blinking and fixed light.
I've tried re-pairing it a few times now, that stops the connect/disconnect issue but i still can't turn off the power. . .
Unlike many others who are experiencing problems, i have NOT attempted to install any firmware updates, so i'm at a loss at what is happening here.
Any suggestions?

josephd wrote:
How come wireless synchronization says not available on my Curve 8310?
Please open a new thead for your issue...this thread is closed.
Occam's Razor nearly always applies when troubleshooting technology issues!
If anyone has been helpful to you, please show your appreciation by clicking the button inside of their post. Please click here and read, along with the threads to which it links, for helpful information to guide you as you proceed. I always recommend that you treat your BlackBerry like any other computing device, including using a regular backup schedule...click here for an article with instructions.
Join our BBM Channels
BSCF General Channel
PIN: C0001B7B4 Display/Scan Bar Code
Knowledge Base Updates
PIN: C0005A9AA Display/Scan Bar Code

Similar Messages

I have a imac g3 dv se, snow and after about 10minutes of it booting it makes a popping sound and the turns off, then it wont turn back on for another 5-10 minutes

i have a imac g3 dv se,500mhz, snow and after about 10minutes of it booting it makes a popping sound and the turns off, then it wont turn back on for another 5-10 minutes any suggestions?

Actually sounds like classic symptoms of a failing PAV (power-analog-video) on that model. Historically that's the weak spot in the G3 iMacs.
The lack of active cooling in the G3 iMac puts a lot of heat stress on this board and they eventually fail from overheating. Right now the board is still working as long as it's cool--it only fails when temps inside the computer rise.
About the only way to preserve the computer's life is to mount a 120mm fan directly on the case where the handle is--that's the exhaust port. The fan has to be positioned to PULL air out through that vent. It's an ugly solution to the eye but it has been done around here more than you would think.
Also make certain the bottom of the computer is not blocked. It the computer is sitting on a tablecloth or placemat, or there are loose papers on the desk under the case, it cannot get enough air into the bottom-mounted air intakes. Make/find some blocks to set the iMac a minimum of one inch (2.5CM) from the desk and move anything that can be "inhaled" from under the computer.
Even with such measures, the PAV board will eventually fail and be unrecoverable. It's a good time to start saving for a newer computer.

Mac Book Pro starts up to white screen then makes a sound and dies, turning off

Hello, my macbook pro is new, bought in August 2011. Just recently my battery died prematurely after only 118 cycles. However, the hard drive also had to be replaced as it wasn't for some reason working with the battery. Now, my computer even though the battery works and I've passed all my documents to the new hard drive is having problems when it starts up. It makes the typical apple sound when it turns on and it goes to the white apple screen and unexpectedly dies off (turns off). It makes a sound as if everything is starting off then a dying sound when it turns off. Sometimes I try it again and it turns off or it can also turn on randomly and fully boot. Holding the shift, control and alt key while it is connected to the battery until the charge changed color works but it is not a permanent solution as this problem has continued for a week. It occured a couple of days after replacing the hard drive and battery at the genius bar. Any help?

It is better to take it back to the genius bar.
Your MBP is under warranty and let them fix it for you.
Nobody here can help you with hardware problems.
Best.

I can not quit open or my Yahoo mail and cannot turn off my computer

I cannot open or quit my yahoo mail and therefore cannot turn off my computer. What can I do?

OS X: How to quit an unresponsive application using Force Quit

Genuis for apps set up and cannot turn off to access store to purchase

Just received an Ipad as a gift and turned on the apps genius now cannot access store or turn off genius, any suggestions as I tried going into my settings to turn off but cannot seem to do it

Hi Shauna1127,
The steps below will show you how to turn the Genius feature off for your iPad.
Genius for iPod and iPhone
You can turn off Genius for Apps from the Account page in the App Store. To get to the Account page, Tap on the Featured pane at the bottom of the screen. Scroll to the bottom of the App Store screen and tap the button with your account name on it. Once you turn off Genius for Apps, the App Store will no longer send information about the apps on your device to Apple. If you used Genius for Apps on more than one device, you must turn off Genius for Apps from each device.
Hope this helps!
- Judy

I have an old internet address on my phone and cannot turn off find my phone to delete the icloud or setup new address how could i correct this

How do i delete my icloud account off an iphone as i cannot remember my password for the account and it wont let me turn off the find my phone

Unfortunately, you need the the password to turn off "Find My iPhone". I suggest to visit the following website to reset the password of your old Apple ID, so that you can turn of Find My iPhone.
https://appleid.apple.com

On and off and cannot turn off to restart iPAD air

Goes from Apple logo to start screen and back to logo, tried turning off by holding on-off switch, and home button and on-off switch
Nothing happens it just goes from Apple logo to Start screen with time
Help is needed
Thanks
Ipad air
7.1 Version

First of all, did you perform the reset correctly? Like this?
Reset the iPad by holding down on the sleep and home buttons at the same time for about 10-15 seconds until the Apple Logo appears - ignore the red slider if it appears on the screen - let go of the buttons. Let the iPad start up.
If you did it correctly and the same thing is happening, it's time to restore the iPad.
Use iTunes to restore your iOS device to factory settings
Pay attention to the last part of the article that talks about using recovery mode in order to restore. I think that might be the way that you will need to go.

HT1414 my iPad is disabled and cannot turn off find my iPad

I forgot my password and now my iPad is disabled after multiple attempts....I went to restore my iPad in iTunes and it says I need to turn off my "find my iPad" app....What do I do?

Force iPad into Recovery Mode. Follow step 1 to 5 very closely.
http://support.apple.com/kb/HT1808
Note: You may have to repeat the above a few times.

Cannot turn off passcode after ios8 upgrade - iPad mini

Upgraded iPad mini to ios8 and cannot turn off the passcode. In settings, I can turn it off but it tells me that I need to set a passcode within 60 minutes. It then counts down and requires me to set a passcode once 60 minutes are up. Also does not let me change duration of passcode (from immediately to 4 hours for example). Any thoughts on how to turn it off? Thanks.

is this your iPad or one administered by someone else...for example if I use an iPad from work our IT policy dictates that I must use a passcode and I am not allowed to turn it off.
If it's yours, just a shot in the dark, do you have restrictions enabled? If so, go in and disable them then see if that will allow you to turn off the passcode lock.

Turn off the sound for a while, and cannot turn it on (louder) anymore

I have a Java application which plays sound (beep). After I turn off the sound using sound control key (lower) on the key board for a while, I will not bring the sound back using the sound control key (louder).
Whenever this happened, my application's CPU usage is above 100%. I am not sure the sound issue caused by my application or by Intel computer itself. I don't have this problem with PowerPC computer.
Ajia

That is the sound that all IOS devices make when you swipe to Unlock and turn them off using the Power button. Is that what you are referring to?
Cheers,
GB

Cannot turn off airport on Imac and PowerBook

I cannot turn off airport on iMac 17" intel (late 2006) and G4 powerbook. One common thing is:
I got rid off .plist files (airport related) on both machines prior to putting new AE in to mix. I set up AE and not only I cannot establish wireless on both machines I cannot turn airport on both as well. Old G4 iMac (3rd machine that was not altered) works.
What did I get rid off?
iMac gives me this:
AirPort Card Information:
Wireless Card Type: AirPort Extreme (0x14E4, 0x87)
Wireless Card Locale: USA
Wireless Card Firmware Version: Broadcom BCM43xx 1.0 (4.170.46.9)
Current Wireless Network: AirPort is currently turned off
While Network pref. and icon in menus says airport is on. (Same with powerbook)
Any suggestions?
Just to ad to confusion. This is replacement AE. First one after firmware upgrade (7.3.2) started to misbehave (very weak signal, mostly). I did downgrade to 7.3.1 but after couple of days I went for factory one (firmware that is), and here I am.

…after waking both computers from sleep situation is reversed. Airport is off and I cannot turn it on. After restart I am back to Airport on (not able to connect, while showing networks to join) and not able to turn off.

EMac won't start and 3 beep sound and light flash

My eMac suddenly got problem these days.
Last night, eMac can boot and login. Suddenly, the monitor cant display property. Then, i enforced to power off. Later, trying restart it. eMac cannot start up and breeze 3 beep sound and flash power light.
I checked support forum. It claimed that "3 beep - no good banks". Actually, i dont understand what it is. What i can i do??

KY18,
Welcome to the Apple Discussions!
The three beeps mentioned in Power On Self-Test Beep Definition means that during the startup test of RAM, the Mac detected that there are DIMMs physically in one or both sockets, but that neither DIMM is functioning electrically.
It's unlikely but possible that one RAM DIMM may have suddenly failed catastropicaly, far more unlikey if you have two DIMMs installed. A more plausible scenario, considering your mention of display problems, would be if the eMac were plugged directly into a wall outlet, or into a low-cost surge protector whose MOV hardware had degraded and failed (the status LEDs on low-end surge protectors are essentially worthless). If there was a power surge while you were using the computer, that could have blown out the RAM (and potentially damaged other hardware as well). Surch brownouts or surges are usually evident in the effect on room lights, clocks, and other elctronic devices plugged into the power outlets.
As a longshot, you can try pulling the RAM DIMMs and then reseating them in the slots, making certain that the thumb clips holding the DIMMs have snapped fully into place after reseating them. Check the RAM installation instructions at eMac - Do-It-Yourself.

I got a new wireless connection for my mac and cannot figure out how to delete the last connection service I had. Everytime I shut the computer, the network goes back to the other one. I cannot find the file ANYWHERE

got a new wireless connection for my mac and cannot figure out how to delete the last connection service I had. Everytime I shut the computer, the network goes back to the other one. I cannot find the file ANYWHERE

Under Network Preferences, select the WiFi
click on "Advanced..." button
Select the network you want to delete from the list and click on "-"
Click "Ok"
Click "Apply"
Well done ;-)
You may also want to delete the wireless key from Keychain.
Open Keychain, seach for the old wifi network name, slect it and click delete

I am updating software on my ipad and it has frozen .cannot turn off/reboot What can I do ?

I am updating my software on ipad and it has frozen...90% updated. I cannot turn off or reboot ! what can I do ?

Update frozen
1. Reset iPad
Hold the Sleep/Wake and Home button down (together) until you see the Apple Logo
2. If the above doesn't work, force iPad into Recovery Mode
http://support.apple.com/kb/ht1808
Note: Make sure battery is above 50%

Mac air giving a beeping sound and is not starting

I was working in the morning and kept it in sleep before i went to bath. After that when i again wanted to start my mac air its giving out a beeping sound and nothing else is working. Mac is not starting up

Did you do a complete shutdown? If so, and it's not starting up at all (no chime, dark screen) then it has died. Please make a Genius Appointment and take it in for service.
Intel-based Mac Power On Self Test RAM error beeps
MacBook Air- Computer starts up with 9 beeps (won't boot into OS X)
Power On Self-Test Beep Definition - Part 2

Wireless 3dTactic Rage - beeping sounds and cannot turn off . . .

Similar Messages

Maybe you are looking for