Configuring MDS 9222i and portchannels

Question

Trying to wrap my head around how a MDS 9222i is configured.  We have 2 of them and will be implementing FCIP.  I found a great document on FCIP and all of that and feel comfortable there.  However, connecting the MDS 9222i slightly confuses me.  I am assuming I can use all 4 of the 1Gbps copper ports.  Is this a correct assumption?  Can I use a portchannel/etherchannel configuration for this on the MDS?
Any help would surely be appreciated.  Thank you.

Answer 1

Ok, you guys were on the right track but anyone else who comes across this issue there are some things that were not clearly noted (or maybe I read over them) posted here:
http://www.cisco.com/en/US/docs/switches/datacenter/mds9000/sw/4_1/configuration/guides/cli_4_1/clibook.html
Basically, MGMT port is required to get access to the device.  From there, I set up the gig ports which require separate IPs for each one that I want to uplink and for each FCIP configuration.
interface GigabitEthernet1/1
  ip address 10.123.10.201 255.255.255.0
  switchport description Core Link connection
  no shutdown
interface GigabitEthernet1/2
  ip address 10.123.10.202 255.255.255.0
  switchport description Core Link connection
  no shutdown
interface GigabitEthernet1/3
  no shutdown
interface GigabitEthernet1/4
  no shutdown
interface mgmt0
  ip address 10.111.2.200 255.255.0.0
From there, had to configure the FCIP connection:
fcip profile 1
  ip address 10.123.10.201
  tcp max-bandwidth-mbps 30 min-available-bandwidth-mbps 20  round-trip-time-ms 5
fcip profile 2
  ip address 10.123.10.202
  tcp max-bandwidth-mbps 30 min-available-bandwidth-mbps 20  round-trip-time-ms 5
interface fcip1
  use-profile 1
  peer-info ipaddr 10.198.10.201
  channel-group 1 force
  no shutdown
interface fcip2
  use-profile 2
  peer-info ipaddr 10.198.10.202
  channel-group 1 force
  no shutdown
Thats really it.  The default gateway needed to be on the same subnet/VLAN as the Gigabit interfaces NOT the mgmt interface.  Found that out the hard way but that wasnt a big deal to figure out.
From there, do the following command:
sho fcip sum
Tun prof    Eth-if    peer-ip       Status T W T Enc Comp  Bandwidth   rtt
                                           E A A            max/min    (us)
1   1    GE1/1      10.198.10.201    TRNK  Y N N  N   N       30M/20M  5000
2   2    GE1/2      10.198.10.202    TRNK  Y N N  N   N       30M/20M  5000
But that was it.  Thanks for the help.