HDMI Switch Help please!!
Hi everyone! So I am not tech savvy AT ALL and received Apple TV as a gift. I'm very anxious to set it up - but it's not going well. Any help would be appreciated
I have a LCD Panasonic VIera with 1 HDMI input that goes directly to my Time Warner DVD (also only 1 HDMI). I have no component cables so it's just that cord that provides me with my lovely time warner tv.
SO I bought a 3 input hdmi switch and went from the output directly to TV and then out my Time warner & Apple TV in the inputs. But it doesn't work.
My cable is on input 3 and the only thing it did do was assign Apple TV to that input (so that my cable was non-existent)
What am I doing wrong!! Thank you - and happy thanksgiving!!
Any ideas?
Put your cable into the HDMI switch input #1 and AppleTV on #2 or 3. Since the ATV is always on (almost) it will block your cable signal if you connect the cable to #1. With the ATV plug into #3 the signal will get through to your TV as long as your cable box is off. Once you turn the cable box on, it gets priority to the TV through the HDMI switch since it's in the #1 socket. With the cable box off, the AppleTV in #3 can get through to the TV.
Similar Messages
-
Satellite P75-A7100 No HDMI Audio Help Please!
Had to make device dual boot due to work circumstances with 7 32bit on one side and 8.1 64 bit on the other side. Read the posts and lots of tinkering with but still no audio out on the HDMI on either sides. Primarily looking to accomplish on the 8.1 side. Went through thre reccomended driver install directly from the TOSHIBA page in the order reccomended:
1. Chipset
2. HD4600
3. Conexant Audio Driver
No luck with the video being fine and no audio. Not recognizing the audio connection in the drivers portion even under disconnected and disabled devices.
Also downloaded latest HD4600 driver from intel and tried to manually install AUDIO portion but getting the windows Error 10 and not allowing. From what I read that is the fix but no luck there.
Any suggestions or direction please?Satellite P75-A7100
Downloads here.
I don't really know anything about this. I stopped by because you didn't mention looking for the HDMI audio here.
Control Panel > Sound > Playback tab
If you don't see it there, right-click in that panel and make sure all devices are showing. I once needed to change the default device there in order to enable the HDMI sound.
Just a a thought. If that's not your trouble, I can't help.
-Jerry -
My video ipods album artwork keep switching HELP PLEASE!!!
for certain songs or certain albums the album artwork will be another albums album artwork and i cannot figure out what to do! please help me!
it sounds like you did everything you were supposed to. so does it do it on just the ipod or does it do it in itunes also?
-
I downloaded an upgrade to my adobe reader today, and ever since my search engine has switched to yahoo and wont change back to google. I have a macbook pro, help please? Does anyone know how I can change this back? I have tried through my settings but it doesnt work
Hi Timia,
If you are using Safari as a web browser :-
Open Safari, go to Safari menu > Preferences > General, and put Google as the homepage. Then, choose Google as your default search engine.
If you are using Google Chrome as the web browser :-
Open Google Chrome.
In the top right corner of the page, click the Chrome menu Chrome menu > Settings.
In the "Search" section, select Google from the drop-down menu.
Let me know if you still experience any issue.
Regards,
Aadesh -
I have just tried to connect my Mac book pro to an LG Plasma TV via an iWires Mini DisplayPort to HDMI cable. All I get on my TV is the Mac wallpaper and nothing else. I am missing something really silly, could anyone help please.
Hi there. I also bought an iWires mini Display port to HDMI cable and have an LG LED/LCD TV. I plugged it in to my MB Pro and followed the very small writing that came in the package and got both audio and video going. You need to change the audio settings from within System Preferences on your Mac to select your TV as the audio output.
My concern is the data latency - do you experience a delay between moving your mouse on the MBPro and the TV displaying the movement? It is only a fraction of a second, but certainly enough to be annoying, especially in a cable as expensive as the iWire. -
I just switched from Outlook to Mail and now the sent messages are not being displayed. Help, please.
Back up all data. Rebuild the mailbox.
-
iPod touch 2G. Not syncing, not restoring, not switching on. iTunes 10.4.1. Help Please!
- What happens when you try to sync and restore?
- If iTunes is not seing the iPod see if restting the iPod will either fix the problem or allow you to see it in iTunes so you can restore the iPod
Reset iPod touch: Press and hold the On/Off Sleep/Wake button and the Home
button at the same time for at least ten seconds, until the Apple logo appears.
- Next place the iPod in recovery mode and then try to restore the iPod. For recovery mode see:
iPhone and iPod touch: Unable to update or restore -
HI!
I have a small network. I have 3 300-28 cisco switches. I already connected my 3 servers and clients with the switch 1 and now I want to add more clients and I need to add my other two switches in the network. Please guide me with the simple configuration So I can connect them all and avoid loop (stp). ThanksHi Nagaraja Thanthry!
Thanks for your reply. I am implementing it tomorrow. By just conecting the switches together at trunk ports will there be no loop? I don't want my network chowk. I hope it will work well. I might need further help, please reply.
1. I will do setting on all switches. Assign IP addresses to switches (to Vlan 1 default).
2. Set one port (e.g 28) as trunk and all others as Access on all three switches.
3. Then I will connect the switches with each other at trunk ports. Hope there will be no loop in this setting.
4. Do I need to set any setting for stp in switches ?
Please reply one by one thanks.
I am using 192.168.0.1 255.255.255.0 IP range.
Best Regards, -
Hi! I have an account from UK and I want to switch to the US.
I can't because I still have Pounds 0,65 left!
I can't buy any app because it's not enough credit but I can't add an american credit card either. I don't have credit cards from UK. HELP please!!
I want an account from the US since my credit card is american.
Thank you!Contact iTunes support in the UK and request that they zero out your account so that you can change the country in your account.
-
My iPhone 4 although fully charges has just switched itself off and won't turn back on again. I've tried taking the sim card out but nothing happens. I'm just coming to the end of a 2 year contract and never had any problems with it before. Help please.
Start here
http://support.apple.com/kb/HT1430 -
Apple iPAD 2. Needs password to unlock iPAD; however there is a permanent keyboard displayed on the screen that does not respond to touch. iPAD switches on with button but does not turn off using it at moment. Can you help please?
Try a reboot by holding both the power and home buttons until the apple logo appears, ignore the red slider if that appears. See if that clears the glitch.
-
i lost my i-phone 4s yesterday night around 7.15 p.m i am keep on trying to reach my number but still the mobile is switched off,please help me how to find it
The only way to locate any lost/stolen iPhone is through Find My Phone or a similar app. However, this requires that Find My Phone be setup/activated, on your phone, before it was lost/stolen. You would then login at iCloud.com & try to locate it. This requires the phone be turned on & have an Internet connection. There is no other way to locate a lost/stolen iPhone. Apple can't/won't help you, nor will your carrier. Report the loss to the Police, your carrier & Insurance company. Change all of your passwords.
-
Hi. My iphone 4s switch of without any reason. Help please
Help please.
My iphone 4s switch off often without a reason. what can I do?Have you tried either a reset or restore? If not, do so.
-
I woke up to my iPhone with a plug in picture to ITunes. I did a back up and restore according to the instructions on ITunes. I now lost all my apps, my voice control goes on automatically and my screens are switching by themselves even during texting....HELP Please! What is the next step before I throw this thing through the window?
Try a reset by pressing the home and sleep buttons until you see the Apple logo, ignoring the slider. Takes about 5-15 secs of button holding and you won't lose any data or settings.
-
my iOS6.0.1 software update was interrupted and now my phone won't switch on and it's permanently stuck on the start up apple. help please?
Connect and select iPhone in computer iTunes, in Summary page click Check for Update button.
Maybe you are looking for
-
Queries running under JBoss Not Working
I'm using Kodo 2.3.2 running under JBoss. It seems like if I attempt to run the same JDOQL query within a single transaction under JBoss the second time I run the query I see that Kodo appears to be querying the entire extent of my class instead of p
-
I want to try to boot up a Powerbook G4 externally with my MacBook Pro.
My wife has a PowerBook G4 that has had a hard drive failure according to the Apple people. Her computer won't boot, it just turns on and the little color wheel spins forever. I want to try to recover some data from her computer. I could try loading
-
Je souhaiterai brancher ma PS3 sur mon imac que je viens d'acheter aujourd'hui.
Je viens d'acheter un imac 27 pouces et j'aimerai brancher ma PS3 sur ce bel écran. J'ai relié ma PS3 via mini displayPort to HDMI converter with Audio. Mais je n'y arrive pas. Un coup de main par pitié. Merci d'avance.
-
Migrate from ingres on vms to oracle 8i
Is there any way one can use the migration utility to convert a database from ingres (vms) to 8i? null
-
I have a new iPad and having trouble with my calendar. When I edit an appointment made on my computer, and hot done....it just disappears? What am I doing wrong, please help?!