I was trying to update my newphews iPod touch but for 20 hours now it is still just showing the apple logo
I was trying to update my nephews iPod touch but for some 20 hours now all I am seeing is the apple logo.
Terminate the update.
Reboot the computer
Restore via Itunes.
If necssary:
Try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- Try on another computer
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar
Similar Messages
-
My iphone 3 has completely frozen. Facebook and other apps were not loading properly so I deleted facebook and went to the apps store and reloaded. It was still loading and then my phone just froze - I turned it off and then tried to turn it back on and all I am getting is the apple logo in the middle of the phone and rather stupidly I have never synched it!! I know what an idiot!!! I have tried calling vodafone but not surprise they are closed for technical help at this time of night.
Any suggestions greatly received......
Thank youUnable to Update or Restore
http://support.apple.com/kb/HT1808
See Here for
Frozen or unresponsive iPhone -
I turned off my ipod touch but it wont turn back on its stuck on the apple logo
i turned off my ipod while there were apps dowloading. but its taking a long time to turn back on its just stuck on the apple logo what do i do or do i wait?
Try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar -
so i tried updating my iphone 4 and my whole computer crashed and when i tried to turn it on, it would just show the apple logo and load, then turn off.
See here for
Unable to Update or Restore
http://support.apple.com/kb/HT1808 -
when i plug in my ipod touch (8gb, 3rd generation) it doesn't turn on and the apple logo flashes on and off. before this it wouldn't turn on unless it was plugged in.
Try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar -
What does it mean after you update your phone and then your phone starts to blink on and off showing the apple logo only?
Read http://support.apple.com/kb/ht1808
-
i updated my iphone 4 to ios 6.. when it finished.. my iphone kept blinking just showing the apple logo.. i connected it to my itunes it didnt read.. help!
Follow the instructions here > http://support.apple.com/kb/HT1808
Note: You may need to try it several times to get it to work. -
I really need help this has happend 5 hours ago and the ipod os still showing the apple logo and the buffering icon below it!
It re booted several times till now.
Need help fast!- I suspect that he went to Settings>General>Reset>Erase all content and settings. For 1G or 2G iPod that can take hours and it will likely stall out if not connected to a charging source.
Try the following:
- A reset.
Reset iPod touch: Hold down the On/Off button and the Home button at the same time for at
least ten seconds, until the Apple logo appears.
- The connect to computer and try to restore via iTunes.
- Id something is still showing onthe screen, disconnect from computer/charging source and let the battery fully drain. After charging for an hour, Try the reset and restore.
- If you can turn the iPod off, se if placing the iPod in recovery mode and then restore. For recovey mode:
iPhone and iPod touch: Unable to update or restore -
I plugged in my ipod to recharge it and for some reason, it just stopped and only the apple logo is showing. I may have unplugged it before it was done, not even sure at this point but now only the apple logo and I can't even shut it off. Any ideas of what I can try now? Thanks much.
Have you tried a reset ? Press and hold both the sleep and home buttons for 10 to 15 seconds and see if it then reboots - you won't lose any content, it's the equivalent of a computer reboot. If that doesn't work then you might better help in the iPod forum (this is the iPad forum)
-
Ipod touch won't turn on, just shows the apple logo - even when plugged into Itunes?
I have an Ipod touch 8GB - it's virtually never been used. I have tried to charge it up but nothing happens - it just displays an apple logo. I have plugged it into Itunes but again nothing happens. Any ideas?
Thanks K.Try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- Try on another computer
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar -
I installed the latest update of Mavericks from the App Store today and after restarting my system it doesn't go beyond the Apple logo and the spinning wheel. I tried resetting the NVRAM but it still has the same problem.
1. Startup in Safe Mode
http://support.apple.com/kb/PH14204
2. Repair Disk.
Steps 1 through 7
http://support.apple.com/kb/PH5836 -
ANY IDEAS WHAT I CAN DO
Mike19981 wrote:
I just updated my phone today to ios 7 a iphone 4s once it turned on it wouldnt boot past the apple logo
Perform a Reset ( No Data will be Lost )
Press and Hold the Sleep/Wake Button and the Home Button at the Same Time...
Wait for the Apple logo to Appear...
Usually takes about 15 - 20 Seconds... ( But can take Longer...)
Release the Buttons...
If no joy...
1) Connect to iTunes on the computer you usually Sync with and Restore
http://support.apple.com/kb/HT1414
Make sure you have the Latest Version of iTunes (v11) Installed on your computer
iTunes free download from www.itunes.com/download
2) If necessary Place the Device into Recovery mode...
http://support.apple.com/kb/HT1808
Note on Recovery Mode.
You may need to try this More than Once... Be sure to Follow ALL the Steps...
Once you have Recovered your Device...
Re-Sync your Content or Restore from the most Recent Backup...
Restore from Backup > http://support.apple.com/kb/ht1766 -
Ipod touch 3rd Gen not fully starting up - constantly restarting with the apple logo screen
Hi,
First of all, I cannot get my ipod touch (3rd Gen) to start up so I cannot get model specifics and version numbers - though it is iOS 5.1.1
I have obviously tried to restart it by holding the power and home button for 10 secs but this has not done anything.
At the moment, the ipod switches on and I see the black screen with the white apple logo - this stays on for about 3 minutes, then I get the little spinning circle (but it isn't spinning) for a couple of minutes, before it powers off and does this again... repeatedly. It only stopped because the battery power ran out.
I have connected it to my computer with the latest version of itunes - it appears in the devices list but just has a spinning 'loading' icon and is grayed out. As my ipod restarts the cycle again as above, my computer makes the noise as if i just plugged it back in and the above happens again in itunes.
The problem began when I updated apps (through update apps in app store) and it froze - I turned the ipod off to restart it, and now this is happening.
Any help or advice extremely grateful... I can't even access it to get it restored which is a bit of a problem as I have work notes on it. (Obviously I don't know if notes are backed up on ipod backups through itunes?)
Many, many thanks in advance!Try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- Try on another computer
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar -
After update, Apple TV just shows the Apple Logo, but won't start. up.
I updated my Apple TV 2 today with the new update, it downloaded everything and then installed it. Now it is showing the startup screen (the silver Apple logo) but won't go past that. I tried unplugging it, I tried holding the plat and menu button together to reset it, it still just pops up with the logo and never starts up. I don't know what to do. Any suggestions?
Grab a micro usb cable and restore through iTunes
-
my sons ipod touch is not working at all? plug in to charge doesnt hold charge but shows it is charging? wont even turn on when plugged in? its dead? ask if he dropped in water but he says no he didnt? he says he hasnt used in 2 months then tried to charge it but it didnt do anything?
Hi,
See if this Support Article offers anything for your issue
http://support.apple.com/kb/HT1808
Maybe you are looking for
-
I have a set of check boxes and corresponding text boxes in a HTML form. I want to display the text box value if the corresponding check box is checked. Can anybody tell me how to accomplish this?
-
In ECC 6, for APP the following parameters are used a)payment medium program--RFFOUS_C b)Name of print dataset--LIST1S c)Form for the payment medium: F110_PRENUM_CHCK d)form for the payment advice--F110_D_AVIS we are not able to get check format as w
-
ERP-WM automatic Outbound Delivery Goods Issue upon TO Confirmation
Hello all, We have the following scenario : Stock Transfer Order -> Outbound Delivery -> Transfer Order -> Picking -> TO confirmation When the TO is confirmed, we customized the system to post the Goods-Issue automatically. Now, we would like to stop
-
I know Weblogic, ADF and JDeveloper pretty well, all the way up to 11.1.1.5. I do NOT, however, know Webcenter and am tasked with knowing it, specifically, Spaces. The documentation seems to be all over the map. It makes a lot of product and knowledg
-
All of a sudden, last few days, every morning 6,000 emails appear on my phone as new. these are already opened on both the phone and my outlook account... any thoughts? I have deleted the account and checked the sync settings...