Ipod shuffle volume limit
I have a first generation ipod and when i got itunes 7 i got a volume limit too. software is 1.1.4 for shuffle. After i set the volume limit i came back today and there was no box for it in settings, so i cant turn it off or adjust it. My ipod still does the volume limit and this is no help because when there is any other noise it's almost impossible to hear since vol limit is so low.
Welcome to Apple Discussions!
This is not currently a feature for the iPod shuffle.
I would Send Apple Your Feedback.
btabz
Similar Messages
-
ipod shuffle(6th) volumes goes down get screen locked, ipod shuffle volumes goes down get screen locked.
Don`t find screenlock controls neither.
ThanksTry:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- Try on another computer
- Try another cable. Some 5G iPods were shipped with Lightning cable that were either initially defective or failed after short use.
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar -
My iPod's volume limit is stuck on half way
My iPods volume limit is on & stuck on half way & won't move.tried restoring factory settings but no joy.
If you restored to factory settings/new iPod and still have the problem that points to a hardware problem. I would make an appointment at the Genius Bar of an Apple store.
Apple Retail Store - Genius Bar -
Hi
I think the kids have set a combination code on the volume limit of my iPod Nano. Can I get it off and how? If I have to do some kind of reset can I re-sync my playlists from my iTunes library? Have over 1000 songs on and would hate to have to import/purchase again.
All help gratefully received.
Thanx.Restore your iPod. Restoring will erase the iPod's hard drive, reload the software and put it back to default settings. Once the restore is complete follow the on screen instructions and it should connect to iTunes and give you a prompt to automatically update your library onto the fresh installation. If you want to update manually or using selected playlists choose no and it will default to manual mode and you can choose whatever setting you like: Restoring iPod to factory settings with iTunes 7
-
i locked my son's ipod max volume level because he was turning it up too loud for his ears (my opinion) anyway now i need to unlock the volume controls and cant remember the combo i set. how do i over ride this, or get the code to reset
so i can adujust the max volume again
thanks shaneIf you forgot the combination, you will need to restore iPod.
See: How to restore the iPod to factory settings. -
HELP...I got a 3rd Gen Nano for Christmas...I NEVER put a combo number into the volume limit...and now it won't let me turn the volume up...it says wrong combo..but I never put one in so of course I don't know what it is. Does anyone know how to RESET the control??? I've tried doing the reset..but it doesn't clear the volume limit.
Thanks, I will try that....someone else told me I have to bring it in to the Apple Store....which I may have to do anyway....has anyone heard of the battery recall??? I saw it on the news...apparently the lithium batteries could cause a fire.
-
I have 3.66 GB of music in my library and want to purchase an iPod Shuffle, which will only store 2 GB. How do I copy only certain playlists to my iPod Shuffle instead of my entire library?
Hello, Nancy.
Great question and this is definitely something that can be done. Below, I have provided a couple of links that go over how to manually manage music. The first article, allows you to drag and drop certain content. The second article, goes over how to sync just playlist and artist. I have attached a screen shot of the section to which I am referring. See the section labeled "Syncing music automatically to iPod shuffle (3rd and 4th generation)".
Managing content manually on iPhone, iPad, and iPod
http://support.apple.com/kb/ht1535
Syncing music to iPod shuffle
http://support.apple.com/kb/HT1719
Cheers,
Jason H. -
My ipod nano volume limit?!
Well, my ipod nano second generation has very low volume. Even set to full under settings and normal, its not even as loud as my old mp3 player.
But my mates ipod is very loud when he turns it up, is there a reason why mine dosn't play sounds loud?
Its english;
I checked the headphones on his and there is no problem with those.My iPod nano was bought from US and it was loud enough when needed but after the latest software update, the volume levels went down. So, I guess I got the EU package and that explains the change.
-
I am connecting the shuffle to an external stereo device using the 3.5mm connector, but the volume is set all the down. How do you adjust the volume on the unit itself without having the headphones connected (with the volume control) ?
Turn the volume UP while earphones are attached (sufficiently high that you can
hear music without putting earphones in your ear), then remove and connect patch cable... you should be able to adjust volume to your liking with the volume control
of the stereo device. -
IPod Shuffle: How to set the maximum volume limit
How do I get back to the volume default I set at the onset of using my shuffle?
I have speakers in my Ski Helmet and would now like to turn up the volume louder than I have currently set for my in ear earpods.
Any help is appreciated.
bIf you're talking about the Maximium Volume Limit:
Setting the Maximum Volume Limit
You can set a limit for the maximum volume on iPod shuffle. You can also set a
password in iTunes to prevent this setting from being changed by someone else.
If you’ve set a volume limit on iPod shuffle, the status light blinks orange three times if
you try to increase the volume beyond the limit.
To set the maximum volume limit for iPod shuffle:
1 Set iPod shuffle to the desired maximum volume.
2 Connect iPod shuffle to your computer.
3 In iTunes, select iPod shuffle in the Source pane.
4 Click the Settings tab.
5 Select “Limit maximum volume.”
6 Drag the slider to the desired maximum volume.
The initial slider setting shows the volume the iPod shuffle was set to when you
selected the “Limit maximum volume” checkbox.
7 To require a password to change this setting, click the lock and enter a password.
If you set a password, you must enter it before you can change or remove the
maximum volume limit.
Note: The volume level may vary if you use different earphones or headphones.
To remove the maximum volume limit:
1 Connect iPod shuffle to your computer.
2 In iTunes, select iPod shuffle in the Source pane.
3 Click the Settings tab.
4 Deselect “Limit maximum volume.”
Enter the password, if required.
Note: If you forget the password, you can restore iPod shuffle. See “Updating and
Restoring iPod shuffle Software” on page 26 for more information. -
I cannot remember my password for volume limit on iPod shuffle
I cannot remember the password for volume control on iPod shuffle.
Hello sasrichey,
You'll need to restore your iPod if you cannot recall the code used to lock the volume limit.
Note: If you forget the combination, you can restore iPod.
Setting the maximum volume limit on iPod
http://support.apple.com/kb/TA38403
Cheers,
Allen -
Ipod shuffle 3rd gen volume control issue
I have IPod Touch and IPod Shuffle 3rd gen and I bought a new pair of headphones in the Apple store in London few months back and the headphones were totally fine when used in IPod Touch. Yesterday I put them into my IPod Shuffle and I am experiencing a problem with the volume - I can't put it up or down.
It's not the "limit volume" thing, I already tried that...
Any suggestions..?Hey paralelopipak,
Thanks for the question. After reviewing your post, it sounds like the headphones have a volume problem only on this iPod. I would recommend that you read this article, it may be able to help you resolve or isolate the issue.
Resetting iPod shuffle
Thanks for using Apple Support Communities.
Have a nice day,
Mario -
The iPod was working fine, then after about 45 minutes of use i looked as if battery drained.
I charged it fully again (until green light) and then turned it on, green light and then orange light blinks five times...
I can't play /pause, or turn volume up or down from the remote... tried with original Apple earphones, and two Bose MIE2i (original and sports models)...
Any ideas of what can be wrong? or how can I fix it?
Already tried restoring it to factory settings.... it didn't solved the problem...Hey there PakoArreola!
I have a website here for you that can help you troubleshoot this issue with your iPod shuffle:
Apple - Support - iPod - iPod shuffle (3rd generation) Troubleshooting
http://www.apple.com/support/ipod/five_rs/shuffle3gen/
Thanks for being a part of the Apple Support Communities!
Regards,
Braden -
Why does my Ipod play at a low volume? When I have my earbuds in I have to have it at almost full volume, and when I plug it into a boombox it doesn't play as loud as the radio or a cd. I have the volume limit turned all the way up in the settings also. All my songs on my Ipod were burned from cd's(if that helps) thanks.
Sorry, I have the same issue.
So far searching threads here is not coming up with anything.
I have set aside my restore discs, to start the process of ripping the drive clean.
I tried Omni Sweep, but all it did was confirm the space I counted up.
Still does not show what's hidding. 113GB worth on mine.
That software really boggs down the system.
I could not load an email with it running.
Good LUck as well. -
I have purchased the new iPOD 160 GB classic, ... the problem is I can't figure out the code for the volume limit... none of the common ones like 1111 or 5555 are working ... anybody with the same problem please help ...[:(]
If you can't remember the code, you'll have to restore the iPod.
http://docs.info.apple.com/article.html?artnum=303414
Maybe you are looking for
-
Hi, The client is asking us to change the format of the out of th object into another format. With The existing format the result is DisplayFare: 4,673.23 and the formula used is : WhilePrintingRecords; global currencyvar DisplayFare; global currency
-
How do I add metadata to a PDF to specify the document's natural language?
I have a PDF which isn't in US English. Can I add metadata to the document to say what language it is in? Is there a standard way of doing this? I see I can add Name:Value pairs to Custom Properties in Reader. Is that the right way of going about it?
-
How do I get Bookmarks Toolbar to open when Firefox opens without having to click to open it?
When I open FIrefox I want the Bookmarks Toolbar to be there by default without having to click to open it. It is very frustrating having to add it each time I open Firefox. Help! Thanks.
-
Batch split in invoice...
hi all, a material is sent to the customer from two batches. in delivery, i am using batch split. while creating invoice, 3 items are formed for one material. is there a way to combine these three items into one?
-
Flash SA Projector crashes when in fullscreen mode
I've created a Flash SA Projector, it's a slideshow of sorts. It is on a timer and changes "slides" every 12 secs. It runs great inf Fullscreen Mode and normal mode. It is self running and I've let it run by itself for several hours. However, it cras