Just got an iphone 4s and the ringer wont work when called the sound works fine just not when called or texted
phone not ringin
Ok...I have been working with it for over an hour. I already did every single thing humanly possible to fix the problem. Finally figured out that the switch is defective. The mute switch on the side will mute the phone just fine, but it will not switch back to UNMUTE. jiggled it a little and it will switch into unmute, but it is very touchy. all the way down is mute, obviously...but all the way up is ALSO mute. it has to be "balancing" in the middle of the two extreemes in order to give sound to the phone...and is literally on a "hairpin" trigger so to speak and will switch itself back into mute with out even being touched.
Similar Messages
-
iv just got an iphone 5c and it say;s some writing at the top off me phone
Is there a question here somewhere? Maybe you should try posting in your native language.
-
It is a 64 GB Iphone 5s and I am running Windows 7 x64 on all of my pcs.
I just got an iphone 5s and now it wont connect to any of my windows 7 PCs, it just gets detected as an unknown device and is unable to be detected correctly. It was connected to one windows 7 pc about a week ago and worked but now I tested it on 4 other computers including a macbook running osx and it isnt detected. I tried the whole Apple Guide and it was no help.install the latest version of itunes
-
I just got an iPhone 4 and I'm trying to use it on the t mobile network. The thing is, I've tried restoring the phone so I could use it. I haven't tried my sim on other phones yet. But I will try to see if it works. The iPhone is supposedly factory unlocked btw. Anyways, when I put in my tmobile sim, it searches for the service, but it always ends up saying NO SERVICE. I checked that my network says that the "phone not allowed". So I don't have 3G on this phone I presume. I heard that you need 3G to have service is that correct? But how do I resolve it? The iPhone does know that my phone carrier is tmobile. It just says no service. And I've tried restoring it three times and turning it off and on and it won't work. I don't have a data plan for tmobile tw! Hopefully someone can help! Thank you so much in advance!
If a phone is sold from one friend to another and wants to use it on a different carrier the friend can contact the carrier it was sold by to request it unlocked. I know AT&T, Verizon, and Sprint will give you the steps to unlock it as long as the original contract it was bought under has been completed. eBay/Craigslist is really not the best place to try to get "unlocked phones" from, if it turns out the phone isn't unlocked then I'm really sorry you got stuck with that one and as stevejobsfan said above I would report them immediately and see if you can recover your money. I sell phones for a living and this happens a lot
-
Hello, I just got an iPhone 4S and it seems that the bluetooth function in it doesn't work. I tried few times to pair it to other non Apple phones but it never worked. Does anyone has an idea how to solve the problem? Tks.
This is not a feature of iPhone, iPad or iOS.
Bluetooth is supported for stereo headsets/speakers, handsfree telephone
devices/headsets, some keyboards, some peer-to-peer apps from the
app store and internet tethering where provided by the carrier.
Other than this it will not connect to a phone/computer/device. (thanks to ckuan for the wording) -
I just got an iPhone 5s, and I restored from a previous back up (mistake) and now I can't restore the phone to start again without "turning off the find my iphone setting" but it's using an old email address as the icloud login, which i don't have a password to / never used for an icloud account. I have gone and changed my settings to a different email on my icloud / apple ID but on my phone it won't let me change the email address for icloud, it's greyed over and keeps trying to verify?
Welcome to the Apple community.
If you mean that Find My Phone is asking for a password to a different Apple ID to your current Apple ID.
This feature has been introduced to make stolen phones useless to those that have stolen them.
However it can also arise when the user has changed their Apple ID details with Apple and not made the same changes to their iCloud account/Find My Phone on their device before upgrading to iOS 7, or if you restore from a previous back up made before you changed your details.
The only solution is to change your Apple ID back to its previous state with Apple at My Apple ID using your current password, you don’t need access to this address if it’s previously been used with your Apple ID, once you have saved these details enter the password as requested on your device and then turn off "find my phone" and delete the account from your device.
You should then change your Apple ID back to its current state, save it once again and then log back in using your current Apple ID. Finally, turn "find my phone" back on once again.
This article provides more information about Activation Lock. -
I just got an iphone 4 and when I go to sync it, it appears in the left hand column but when I click on it there is just a blank screen with the apply logo and a tiny lock.
OK, I think I fixed it.
After trying to restore with an old backup from the phone (it estimated it would take 4 hours) I cancelled and went through the setup menus again, but set it up as a new phone. It then appeared in iTunes and I restored it from the computer, not the phone. It appears to be working, it's syncing my old apps right now.
Summary:
1. Reset settings on phone (hopefully you backed up fairly recently)
2. Set up as NEW iPhone in setup menu on phone
3. Restore from iTunes on computer when it recognizes the phone
4. Cross fingers -
I have just got a iPhone 4s and I can't get the iCloud to work, everytime I turn on auto downloads it defaults back to off, can anyone help?
Welcome to the Apple Community.
Check you are logged into your store account properly (settings > store). Also check there are no restrictions set that might be causing this (settings > general > restrictions) -
I just got an iPhone 4s, and want to sync some music to it, but itunes wont recognize the phone. what do i do to make the phone show up in itunes?
windows http://support.apple.com/kb/TS1538
macs http://support.apple.com/kb/TS1591 -
I just got a iphone 4s and it's registered as a Ipod...how do I get it back to the way it was?
As deggie said, you are the victim of Activation Lock. Activation Lock is described here:
http://support.apple.com/kb/PH13695
Either you need to contact the previous owner to release the phone from Find My iPhone, or if you cannot contact the previous owner, it is likely you received a stolen iPhone and it will be useless to you. -
I just got an iphone 5c and downloaded ringtone maker and made a 30 second 4r ringtone and when I try to drag and drop it in the tones folder of itunes nothing happens. What am I doing wrong?
If the file is a correctly formatted AAC file with the .m4r file extension and less than 40 seconds long, then iTunes should put it into the Tones section of the library and move it into the Tones folder inside your media folder.
I've just checked the current version of iTunes behaves as I've desribed, which it does for me at least.
You may need to have some tones in your library for the tones tab to display when the device is connected.
tt2 -
I have just got a iPhone 4S and it's still registered on the previous owner iCloud and I can't seem to change it to my I cloud help please
As deggie said, you are the victim of Activation Lock. Activation Lock is described here:
http://support.apple.com/kb/PH13695
Either you need to contact the previous owner to release the phone from Find My iPhone, or if you cannot contact the previous owner, it is likely you received a stolen iPhone and it will be useless to you. -
Hi guys, i just got my iPhone 4s and sometimes the signal is lost and i have to restart the phone in order to get reception again. do you thing there is a problem with the phone or with the carrier? thanks
I have the exact same problem. Called my operator who told me it was a hardware issue and Apple is working on a fix...
-
I just got an iPhone 5s and it won't let me add my hotmail email address to my mail. I can add it under outlook but then it doesn't show me all the emails or folders I have, I have to login in via the we page to view them, too inconvenient... Please help!
Open Mail app and then click on Mailboxes(Left up)>Go down and select your Hotmail acoount and then try Refreshing by pulling down the list.
-
I just got an Iphone 4 and everytime the phones rings, my camera flash starts strobing. How can I get it to stop
You have enabled this function in the Settings menu. Follow this guide to disable it: http://snapguide.com/guides/switch-your-iphone-camera-flash-for-incoming-calls/
-
I just got an iPhone 4s, and I can not connect it with my iTunes from my previous account. I have already tried making another account, however it says that I have the wrong security code even though this is not true. What should I do?
Contact iTunes support. There's a link to it on the bottom of every page in the iTunes store.
Maybe you are looking for
-
BSP YHAP_DOCUMENT-working in BSP but not through portals
Hi! I am using the BSP HAP_DOCUMENT to get column access for columns in the appraisal document for 'further participant' role. for this i changed the mode in ydocuments_where_participated.htm to 'X' and also used the BADI HRHAP00_COL_ACCESS. in this
-
I want to change my accont from US to Uk so i want you to reset my balanace .
i want to change my accont from US to Uk so i want you to reset my balanace .
-
Sets Macintosh HD as backup disk when external drive unplugged
When I unplug my laCie drive it sets my Macintosh HD as the target disk the macintosh HD icon in the desktop is the same as is shown next to a backup disk (blue with time machine symbol), what can I do? Also, is there a way of knowing when it has fin
-
Sounds Interesting : SAXParser Not returning Attributes
hi! I implemented the SAXParser but its not getting me the attributes. It does get me the data . e.g. <DATA> <RECORD ID="1"> <FIELD>165</FIELD> </RECORD> <RECORD ID="2"> <FIELD>189</FIELD> </RECORD> </DATA> Here , if i do, element.getLocalName() -- i
-
Snow leopard and quitting apps
Have just installed Snow Leopard 10.6.3 and find that all photoshop applications quit, as well as Excel. I can't see that these are known incompatibles - has anyone else experienced this and what can one do about it? cheers -