U310 IdeaPad Touch :The Touch Screen Stopped Working. No Previous Posts Have Helped.
Drivers all show working properly. Not intermittent. Tried settings and no help. No response when touching screen at all. Can't calibrate. Bios has no update available. Nothing in manual under troubleshooting. Any quick fix suggestions have likely been tried, but open to all ideas.
If all else fails, and assuming the digitizer is bad, what does repair entail and any rough estimate?
Is there any recall? I see this issue on the forum a lot with not many folks getting it resolved.
TIA!!
hi c2nah777,
Welcome to Lenovo Community Forums!
Have you tried booting the system in Recovery Mode (One Key Recovery), You're not going to Recover the system since your only going to check the touchscreen in that mode "Outside Windows"
See if the touhcscreen works there,
If Yes, I would suggest doing a factory Reset First Before jumping into a hardware Repair.
If No, Then I think you're correct with the digitizer.
Regards
Solid Cruver
Did someone help you today? Press the star on the left to thank them with a Kudo!
If you find a post helpful and it answers your question, please mark it as an "Accepted Solution"! This will help the rest of the Community with similar issues identify the verified solution and benefit from it.
Follow @LenovoForums on Twitter!
Similar Messages
-
I have a problem in iPhone . When you receive a contact and press the key at the top to cancel the contact screen stopped working .ataml times after the last restart device
Since restarting did not help, reset your iPhone, see: Turn your iOS device off and on (restart) and reset http://support.apple.com/kb/ht1430
If that still does not solve it, check, if the contact you are trying to add is problematic. Try to save a different contact. Does that work?
If not, reinstall the Contacts app. This is only possible by restoring your iPhone, unfortunately.
See: Use iTunes to restore your iOS device to factory settings http://support.apple.com/kb/HT1414 -
Yoga 13 touch screen stopped working after update KB3000850, please help!
Hi, my Yoga 13 touch screen has been working fine until yesterday. The laptop came with Windows 8, and last year I upgraded to Windows 8.1 without issue. Yesterday, I installed optional update KB3000850 from Windows Update, and immediately the touch screen stopped working. I have tried the following methods, all without success:
* Uninstall KB3000850 from Windows Update
* Use Windows Restore to restore to the point before yesterday
* Re-install Intel Chipset Driver from Lenovo official driver page
* In Device Manager, uncheck all the "allow system to turn off to save power" options for the USB input devices under Human Interface Devices then restart
* Two-button shutdown and restart
* Install Lenovo Driver Manager and let it check for new drivers
* Download Cando multi touch panel driver (Note: I could not install the driver because all I got was a .cab file which does not allow me to install)
As of now my touch screen is still not working. Computer Information page from Settings shows that there is no touch or pen device for my screen.
Can anybody help me with this? Thanks!Very true, this has been a known problem since the first day Lenovo released the Yoga 13.
I need to send Lenovo a bill for my time spent rebooting. So far i am on my 8th reboot. In the past, around 5 reboots after winddows update would work. This time... who knows.
Of course it always happens when you have a deadline.
Please post back if you have found a better soultion than system restore.
Thanks for posting this issue. More users need to bring this to Lenovo's attention. -
My iPod touch 4th generation screen shakes back and forth every once in a while and won't let me use the touch screen. I have restored it at least 5 times to factory setting and it is still happening. The only way to stop it is to hit the sleep button off and then on again. It happens about once every 5 minutes. Please help.
If you successfully (completed all steps without errors) restored to factory settings/new iPod and still have the problem that points to a hardware problem. I would make an appointment at the Genius Bar of an Apple store.
Apple Retail Store - Genius Bar -
Exposé just stopped working, both the key on the keyboard and the multitouch gesture gets no response. Does anyone have any idea why, or how to solve it?
I found a way to fix it. Simply restart the dock by using "killall Dock" in the terminal.
Cheers! -
Brand new ipod-touch internal speaker suddenly stopped working all-together? Please help!
Just got my brand new, white Ipod- Touch and was surfing on youtube, watched a video and mid video the sound just vanished. now no sounds come from the internal speaker whatsoever, but headphones still work. I have tried restarting it as well as reseting, can anyone help me?! Thanks a lot!
That sounds like a mechanical problem. You might want to insert and remove the headphone plug several times and see if it fixed the issue. If it does not, call Apple. 800-275-2273 in the U.S.A. and I think Canada.
-
Why has my music controls in the locked screen stopped working after upgrading to ios. 7.0.2?
I cannot pause, advance track, etc with the in-control feature on ios 7. When my phone is locked and the music is playing, (ie. iTunes, podcasts or any other audio enabled app) the play controls do not work even when I access the in-control feature. I remember this working after I updated. Now it's not. Anyone else had this issues or know a fix?
I have the same issue. with iphone5 with iOS 7.0.2
-
It was initially working but has now stopped the bars are showing as a strong signal , it says Telstra 3G but I cannot get onto any webpages on safari or any other app that needs internet connection. Please help.
You need to restore your iPad from iTunes.
Start iTunes.
Plug in your iPad using the USB cable.
Click on the iPad in the left hand column under "Devices".
In the "Summary" tab, there are options to Back up, Update and Restore.
Choose Restore, choose the backup and let it run.
http://support.apple.com/kb/HT1414
If your old iPad was capable of receiving data on the go, without wifi, then you have a SIM installed. Best to check anyway. You need either the tool supplied in the box, or the end of a paper clip to open the tray
http://support.apple.com/kb/HT5163 -
I have deleted the program and re installed numours times, also ran a full essential scan, spybot and malware byte scans with no results. Any ideas?
Nobody has had or has this problem? I have gone back and forth with itunes "help" people for 2 weeks with no "help" at all. I guess I am going to have to buy a non apple devise and shop @ amazon for my music.
-
I really enjoy the speak screen feature, as the voiceover is too inconvenient and tricky to use. The speak screen option works oerfectly for reading, and helps me as I'm dyslexic. However, the Alex voice stops working after the initial use or soon after. I then have to restart the phone every time in order to get the speak screen to acruelly speak again. Really annoying and was hoping that IOS 8.2 Would fix this, but it appears it had not fixed this bug. Any help with this?
Any problem when connected to another wi-fi network besides your own?
The only additonal troubleshooting options after powering the iPhone off and on, an iPhone reset, and resetting network settings on the iPhone is restoring the iPhone with iTunes from the iPhone's backup and/or restoring with iTunes as a new iPhone or not from the backup.
If no change after restoring as a new iPhone or not from the backup - the same when connected to any wi-fi network besides your own as well as not being able to maintain internet access when connected to your carrier's cellular network, the iPhone has a hardware problem. -
I have run the "fix", I have removed and reinstalled, but my iTunes just stops about 1-2 minutes in and the "ITunes has stopped working" window appears. Any help as to a fix? Are there any other music programs out there that will burn discs if I can't fix this? Thanks....
Hey deaconfan,
If you haven't already, I would run through the troubleshooting steps in the following document:
iTunes for Windows Vista, Windows 7, or Windows 8: Fix unexpected quits or launch issues
http://support.apple.com/kb/TS1717
Welcome to Apple Support Communities!
All the best,
Delgadoh -
While Extending AM LOVs in the standard page stopped working
Hi,
I extended an AM in one of the standard Oracle Apps Page. After substituting the new AM, all the LOVs in the standard page stopped working.
Do you have a solution for this?
Please reply.
Thanks and Regards,If your page contains any LOV then root AM extension is not supported.
Root AM substitution fails when the page contain a LOV.
You can try different approach by extending VO/EO.
--Sushant -
After substituting the new AM a LOV in the standard page stopped work (R12)
I extended an AM in one of the standard Oracle Apps Page. After substituting the new AM, a LOV in the standard page stopped working.
Do someone have a solution for this?
thanks
LouHi,
thanks for all replies.
Recap:
In a std OAF page I need to add a image-link for each row to go to a custom OAF page and show a custom table contents details of linked master id.
I added an image with personalization and create a dyanmic URI in extension of CO to pass id in a new page.
Since here all works fine.
Now, the problem is that I also need to call the procedures from DB to execute DML before access to the custom page.
I added in AM extension of standard page, a code like this below:
+public HashMap defPopulateDetails(String invoiceId, String checkrunId) {+
CallableStatement st = null;
HashMap returnValues = new HashMap(2);
try
+{+
String stmt = "BEGIN XXLOUIS_PKG.ON_INSERT_DETAIL(P_INVOICE_ID => :1," +
+"P_CHECKRUN_ID => :2); END;";+
OADBTransaction tr = getOADBTransaction();
st = tr.createCallableStatement(stmt, 1);
+// Bind the input parameters+
st.setString(1, invoiceId);
st.setString(2, checkrunId);
st.execute();
st.close();
OAExceptionUtils.checkErrors(tr);
+}+
catch (SQLException sqle)
+{+
throw new OAException("ICX", "FWK_TBX_OBJECT_NOT_FOUND");
+}+
return returnValues;
+}+
Can I move it to the Controller ?
My doubt is due to the fact that I thought was a good practice place validation logic in to CO
and place all calls to DB procedures and VO into AM.
If I can move this piece of code from AM in to the CO I belive have not other problems.
thanks
Lou -
Why did my brand new Ipod 5g 32gb touch screen stop working?
So I got this ipod from the Genius Shop for about a month. A few days ago when IOS 7.1 came out, I updated it. However, the ipod seems to lag a little. Today, I was charging my ipod and for some reason, when I turn it on, the touch screen stop working (the ipod is in perfect condition). The home button, volume button and the on/off button all works fine except for the touch screen. I want to restore everything on my computer, but I can't get pass the lock screen (the touch screen seems to stop working). I just can't do anything on this ipod anymore beside turning it on and off. I can't even power it off because the touch screen is no longer touchable. So how can I restore everything, or do something about this ipod to work again. Can I still take this back to the Genius Shop and get another one without additonal charge?
If the reset does not work try the remaining items of:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- Try another cable
- Try on another computer
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar -
My touch screen stopped working...on my brand new replacement iPod touch.
I recieved my replacement while on vacation in Vegas, about five days ago. My new iPod has been kept nice and safe in it's case without any bumps that could damage it. Today, May 4th, I go to school with a perfectly working iPod. On my way home, kept safe in my pocket all day, the touch screen stopped working, and restarting it didn't fix it. It's brand new, so whats wrong and how can I fix it PLEASE!
yes i have the same problem. But also other then the fact that the touch screen doesnt register it is really dark, like there is no light bulb
Maybe you are looking for
-
How can I buy an album marked "partial album"?
I want to buy "30 gold bars" by Status Quo, but it is marked "partial album" instead of the price tag. I can't buy it. What does this mean? Is that going to change? Any idea is welcome! Thank you!
-
I've installed Adobe Flash, but the website still tells me to download the newest version?
I'm on a new mac computer, I need to know how to get Adobe Flash up and working. I've tried uninstalling then installing again, but it's still not working.
-
How to make titles in slideshow?
I am making a slide show in DVD SP and was wondering how can I make titles for my pictures here, is it possible to do in DVD SP? Any help please
-
Using DHCP Airport Extreme WRONG IP ADDY
I connect my modem directly to my computer and the internet works perfectly. I try and use my Airport Extreme using DHCP and my Airport Extreme ALWAYS automatically picks an INVALID IP address. I have no idea why the Airport Extreme is doing this.
-
After Safari 7.06 update, whenever I connect to RSA Juniper Network Connect, my internet connection get disconnected. It was an issue with old Safari versions. It was fixed around 6 months back with one of Safari update. But, now it is broken again.