Automatic dispatch of Planned Order - Reg.,

Question

Hi
Here i'm trying to dispatch a planning order automatically, when a work center capacity got fully loaded. What is the necessary settings has to be done?
Kindly explain clearly
Regards,
Gopi

Answer 1

Dear ,
When you are dispatching the operation for Planned Order /Production order in that day , system checks the availble capacity load in that work centre .If required capacity is not avalaible based on the work centre available capacity (Capacity Tab-Available capacity -Check overload CM05 for workcentre in that week) , operation will not be dipatched and Scheduling logg will be created
.I suggest that you need to check the Available Capacity (can be viewed weekly /monthly -Select the weekly grid -double click -system will dipaly the daily load in a week ) of the work centre and then go back to CM25 with your work centre -select Overall Profile -Enter Work centre -Strategy -Mark "Date Entry while dispatching " which will hel you to dipatch the date based available capacity CM05.Or else try to use CM21-Graphical view (goto -settings-scale-daily split -chek the available capacity date -dispatch.
In CM01/CM05 , please enter Plant /Work Centre in CM05-Hit DETAIL Capacit list or Varibale View -it will display with weekly bais capcity set up based on the .Select the week where this date fall on or If you want to look the daily baisi load , then goto Planning tab-Profile-Option Profile -select as appropirate to analysis the load daily /weekly
Setting Required :
1. Settings for Available Capacity
2. Setting for Capacity requirements
3. Settings for Capacity evaluation and leveling
1.Materials Master define the Production scheduler and production scheduling profile
2.Work Center - Define the capcity planner group,activate checkbox Relevant for Finite sceduling,on the capacity header define the shift timings,break timings and unit of measure,no of individual capaity, enter formula for scheduling in capacity view.
3.Routing - enter the values for the standard values. Use control key with scheduling.
4.In transaction OPU5 and OPU3Z - define the scheduling parameters for planned order and productiion orders and activate the checkbox Capacity requirement and Scheduling. what is the settings in OPPQ and OPPR for the "Start in Past" parameter, you need to keep them consistent with the OPU5 settings.
Capacity Setup :
Define time profile in OPD2.
Define the strategy profile in OPDB
Define the Overall profiles in OPD0.
In the order control OPJK I have maintained check capacity with SAPSFCG013 profile.
Define Scheduling parameters for Production orders-OPKP-Maintain Capacity Checked /Finite Scheduling Cheked /Scheduing Type -BW/FW .
Hope this will help u in analysis the set up.Revert if u need any help
Regards
JH
Edited by: Jiaul Haque on Apr 28, 2010 2:04 PM