Customizing incorrectly maintained message is appearing in SES, w/o Mat Doc

Question

Dear all
Customizing incorrectly maintained message is appearing in service entry sheet in ML81N without showing the mat doc no.  We want to get rid off this message and material document number has to appear.
When we create SES message came "Customizing incorrectly maintained" & Message no. SE729. When we release the SES then Material Document is not showing in foreground.

Answer 1

Dear Santosh,
Reason and Prerequisites
You have recently made an upgrade
Number of entries in table T162V is different to the number of columns in table control for screen SAPLMLSP/400.
Solution
The variants maintained before and after upgrade are probably different.
Since different customers maintain different number of entries for each variant, it would not be possible to release a standard note to all customers to fix this. Moreover this cannot be fixed using the Note Assistant, the changes have to be done manually.
The entries in the Table 'T162V'(for each of the 6 variants) should always be the same as that of the columns in the table control(TC_View).
Table Control(Screen)  Screen 400 SAPLMSP(TC for services ).
Below is the standard logic to verify if the customising is correct.
Determine number of lines in customizing tables
  describe table t162v_tab lines lv_t162vlines.
Determine number of columns in table control
    describe table tc_view-cols lines lv_tclines.
  lv_tclines = 6 * lv_tclines.
  Here 6 signifies the 6 variants for the TC.
  if lv_t162vlines ne lv_tclines.
    message s729.
  endif.
Please make sure that the entries maintained in T162V are the same as the columns maintained in the Table Control (TC).
For this case, you can use SM31 transaction to maintain the same number of entries in table T162V as in TC.
Please see the attached files "SE729_A.doc" and "SE729_B.doc" for further help, that explain exactly how to check the situation and how to use SM31.
The most important thing is that you have the same number of entries in lv_t162vlines as in lv_tclines.
After all changes are made please test the behaviour again.
=======================================
Issue two
The button for services selection is missing and when you want to record a new entry sheet, the system show messagge SE 729.
This is owing to the incomplete coding of the user-exit that must be performed by the user.
When the SAP enhancement SRVEDIT is not active, the call of the user-exit is not performed and the value of I_EDIT_KZ is set to 'X', and never changed.
When you activate your project, which contains the SAP enhancement, you
need to write the code of the include ZXMLUU18, so that the export parameter E_EDIT of EXIT_SAPLMLSR_001 returns a value. Without code, the parameter value will be blank, hence I_EDIT_KZ will be blank, and the end result is the [Service selection] button disappears. Time out's can also be a result.
Regards
Utsav