IPad2 is dead...worked fine, then when I tried to use it an hour later, the screen was black. Home button did nothing; on/off button did nothing. Tried charging overnight...still does nothing at all. Also tried syncing with my desktop; still nothing.
iPad2 is dead...worked fine, then when I tried to use it an hour later, the screen was black. Home button did nothing; on/off button did nothing. Tried charging overnight...still does nothing at all. Also tried syncing with my desktop; still nothing. Got it in March and have never had an issue before this. Thanks.
Have you tried a reset ? Press and hold both the sleep and home buttons for about 10 to 15 seconds, after which the Apple logo should appear - you won't lose any content, it's the iPad equivalent of a reboot.
Similar Messages
-
ipad was working fine then when i went to use it again a few mins later it wont do nothing screen is just black an ipad is charged any info on wha problem could be iv only ad the ipad 3 months from new
Yep re set my iPad an is working fine now cheers
-
Question
Hi, i have a problem on a Facebook game Mafia Wars. I mark it trustable site but... everything else is working fine except when im trying to send a gift to a friend. Mozilla doesnt show me my friends on a list. What should i do..?Question
Hi, i have a problem on a Facebook game Mafia Wars. I mark it trustable site but... everything else is working fine except when im trying to send a gift to a friend. Mozilla doesnt show me my friends on a list. What should i do..? -
I dropped my MacBook pro on the floor around 1 meter height, it landed on its bottom part, the lid was closed but it was on. When I opened it the screen was black and I could hear the fan sound. I restarted it and it took around 8 minutes to start!! Every thing became very slow and freezing all the time, I'm trying to back it up but it's freezing every time! The two fingers tap is not working also :(
Does this mean that the hard drive is damaged or just needs to be fixed in its place properly?
Please help.
Thank youSomething broke. Accidental damage is not covered under Apple's warranty.
It could be just a couple of connecter knocked loose, or the logic board could be cracked.
Take it to Genius Bar to find out, and pray for loose connectors.
Good luck. -
I updated my iMac to 10.7.3 and about an hour later the screen began to flicker with a gray line on the upper side, and it also flicker green and red small pixel lines all over the screen, mainly green. The computer froze with these pixels, so I shut it off and restarted it, and there were this green lines everywere. So I turned it off, and the next day I turned it on and it began to work just fine, but suddenly the same thing happened again, and when I restart the computer again there are these green and some red pixels everywere.
I've read 10.7.3 is giving people many problems, but I never saw that it gave one like this. How can I fix this, or what will Apple do to fix this problem they caused me with their update.
ThanksContact Apple Service, iMac Service or Apple's Express Lane. Do note that if you have AppleCare's protection plan and you're within 50 miles (80 KM) of an Apple repair station, you're eligible for onsite repair since yours is a desktop machine.
-
my iphone 4 has been working fine but when i try to use music, it wont work. For example i try to put a specific kind of song and it will either not play or skip to another.
read http://support.apple.com/kb/TS3217
-
We just moved from the United States to Costa Rica. The first two days my mac worked great. Then all of a sudden I was trying to use a game application and the screen went black and there is a white cursor which I can move around, but I can't escape it. When I restart it seems okay and I see my main screen, but only for a second and then it goes black again.
This computer was brand new in June. Is it the humidity??? What can I do. Please help!!!!No guarantess but try smc and pram resets,
-
The home button for my ipod touch 4th generation does not respond all the time, What do I do?
Try:
http://snapguide.com/guides/calibrate-your-home-button/?utm_expid=69945963-15
fix for Home button
iPhone Home Button Not Working or Unresponsive? Try This Fix
- If you have iOS 5 and later you can turn on Assistive Touch it add the Home and other buttons to the iPods screen. Settings>General>Accessibility>Assistive Touch
- If not under warranty Apple will exchange your iPod for a refurbished one for:
Apple - Support - iPod - Repair pricing
You can do it an an Apple store by:
Apple Retail Store - Genius Bar
or sent it in to Apple. See:
Apple - Support - iPod - Service FAQ
- There are third-party places like the following that will repair the Home button. Google for more.
iPhone Repair, Service & Parts: iPod Touch, iPad, MacBook Pro Screens -
Hello, my isight camer is not working properly, i was using photo booth and suddenly the image was black or too dark and also ichat and facetime are too dark as well, please helpme out i can not find any solution.
read this and see if it helps: http://support.apple.com/kb/ht2090
-
every time i click an action the screen goes black until i unclick. making it impossible to see my work. photoshop cc/ windows 8, every time i click an action the screen goes black until i unclick. making it impossible to see my work. photoshop cc/ windows 8
I've had the same problem, and sorted it using this:
Run the Boot Camp Assistant in OS X as normal and create a partition when asked, then insert your Windows 7 disc to reboot and begin the process proper.
Windows 7 requires the NTFS file system, so once in the installer just select your new partition (labelled BOOTCAMP), click on Drive options (Advanced) and choose to format it. Then select the newly formatted partition and continue.
Windows 7 will begin installing, and once it gets almost to the bottom of its checklist, it’ll try to reboot. Now, if you leave it here, you’ll get so far and see the black screen. Any further attempts to reboot will bring you to the same dead end.
Instead, restart and press a key to boot from the Windows 7 disc when prompted.
Rather than running the installation again, choose the little option at the bottom to Repair your computer. Decline any suggestions that pop up until you see a list of options with Command Prompt at the bottom. Choose that option.
At the Command Prompt, type DEL C:\WINDOWS\SYSTEM32\DRIVERS\ATIKMDAG.SYS to delete the default ATI driver, then close the window and reboot.
This time, Windows should successfully initialise a more appropriate display driver, allowing you into the desktop. From here insert your OS X disc to install the relevant hardware drivers as you normally would, then run Windows update to clear up any leftovers.
Read more: How to install Windows 7 on the new 27in iMac | PC Pro blog http://www.pcpro.co.uk/blogs/2009/10/26/how-to-install-windows-7-onto-the-new-27 in-imac/#ixzz0tinWW9tn -
This happened to me when I received a call. My phone started vibrating when it received the incoming call but the screen was black and kept vibrating like as if the call was still coming in, even though my friend hung up. It kept going and going, so I tried holding down the lock button to turn it off but screen was still black/turned off. Hitting home did nothing. My friend said to try holding down the lock button and home button together to reset it. I tried this and yet nothing happened. I am waiting for the battery to drain out and give it a try.
To reset, you have to press both the home and sleep/wake buttons until the Apple logo appears - takes 10-15 seconds.
-
I accidentally dropped my friend's macbook air that was in a book bag. The keyboard is working because I can see the light but the screen is black and it won't turn off. How should I fix this? Please Help ME!!
I tried to turn it off and it didn't work... and I held on to the shift key too and it still doesn't work..
Please help me..Accidental damage is not covered under Apple warranty. And it seems there is much accidental damage. Only a Genius Bar tech looking at it can tell how much it will cost to repair.
Cost to repair will be high, I suspect (though Genius Bar will confirm/deny.
There is no gentle way to say this sir/ma'am ... someone will need to pay for your friend's MBA repairs. -
I dropped my iPhone 4S and when I went to pick it up, the screen was black how do I fix it or where can I take it to get fixed in Adelaide South Australia?
Look under service
https://locate.apple.com/au/en/
https://locate.apple.com/au/en/service/?pt=1&lat=-34.92862119999999&lon=138.5999 594 -
My Ipod touch 2nd generation was working fine until I tried to charge again from my PC,when I connected the Ipod was getting too hot and smelling like burn cable,the screen turn black and doesn't work anymore. any ideas about what happen?
You can try here:
iPod touch: Hardware troubleshooting
However, from your discription, I suspect that something is broken. Maybe a dead battery. In that case. I would make an appointment at the Genius Bar of an Apple store and see what they say. -
I have an ipod nano ( the small square one) which is 3 mo old. Yesterday, after charging, I noticed that the face was black - totally blank. I tried turning it on but of course nothing happened. I can't tell if it's on or off. No sound, no screen, no nothing. What should I do. I have tried the steps from Apple but I can't even turn it on or off. Please help? THanks
sandoo8 wrote:
I have an ipod nano ( the small square one) which is 3 mo old. Yesterday, after charging, I noticed that the face was black - totally blank. I tried turning it on but of course nothing happened. I can't tell if it's on or off. No sound, no screen, no nothing. What should I do. I have tried the steps from Apple but I can't even turn it on or off. Please help? THanks
What steps?
You are still under warranty. Take the computer to an Apple store or an AASP. Whichever is more convenient for you.
Maybe you are looking for
-
Date comparision not working in BI-Publisher in one scenario.
Hi, Iam using sqlquery as a datamodel for BI-Publisher report. I have a requirement that the input parameters startdate and endate are Date types. When the user enters startdate and enddate and clicks on view, the report should show data which falls
-
Can't download photos from digital camera after latest software update
Hi, since the latest update on the 28.9.08 I have trouble downloading photos from my Canon Eos 400D. I can't use "Digitale Bilder" anymore, nor Adobe Bridge Photo Downloader or iPhoto. I have to use my partners MacBook that doesn't have the update ye
-
IDOC Segment Adding a new field
Hi all! My disclaimer: I know less than nothing about IDOCs. So hopefully I lead you down the right path. I have searched SDN and then tried google. As far as I can tell I've gone thru the right steps. But since it isn't working I must have skip
-
Hi Experts Can you please share me time function to insert in FR reports ASAP please... Thanks in advance KK
-
this the error "returning=false&EUPLocale=true" for the requirements it specifies ver 3.6, new to FireFox can i down grade my version