Strange download/upload speeds using the airport express as a repeater

HI,
i am having strange speed issues. Let me start off by stating my AirPort Extreme is on the middle floor of a 3 story condo. The condo has 2ft concrete slabs between floors. I have a repeater for the first floor as my signal strength was poor. I get great speeds on the same floor as the AirPort Extreme 45/15. On the 1st floor with the airport express, I get 4 down/12 up. My upload speed is always faster by a wide margin. On the 3rd floor (no repeater) I get similar results. I don't understand how my upload speeds are preserved, yet my download speeds via the repeater or 3rd are awful.
HElp! I'm using 2.4gHz for better penetration and I have changed the channels to help with congestion. Any ideas ?

Having the upload speed not change is odd indeed, but the loss of download speeds can almost invariably be attributed to the concrete walls in your condo. These do a poor job of allowing Wi-Fi signals to pass through them. Your actual Internet speeds are not affected by them, but the overall bandwidth speeds between the Internet server and your computer will be.
The best solution, albeit maybe not practical, would be to interconnect each of these base stations with an Ethernet connection and reconfigure the entire network for roaming.

Similar Messages

Can I use the airport express as a repeater/range expander but without being connected to the modem with the ethernet cable?

I have a mac pro (2010 mid) to set up the airport

My 2003 Airport Extreme I guess does not provide this "enable extension of other Wireless Device" option in Airport Untility under "Wireless", because it is too old?
Correct. You will need one of the "square" AirPort Extreme versions if you want to do this.
Another question, do I need to buy a new Airport Extreme to be able to extend my Wi-Fi signal with the New Airport Express I just bought?
Yes, or another new AirPort Express. But, you cannot connect a hard drive to an AirPort Express. You can with an AirPort Extreme in case you were planning to add a hard drive.
One last question, I believe I understood that if I have the new Airport Extreme and use it with my Airport Express to extend the Wi-Fi Signal, I will be able to do this without my DSL Ethernet cable connected to the Airport Express?
The DSL cable will need to be connected to the AirPort that you designate as the "main" router on the network....assuming that you want to be able to connect to the Internet.
The other AirPort will connect using wireless only....assuming that it is located where it can get a good wireless signal.

Can you use the Airport Express A1264 as an AP and a DHCP server at the same time?

Can you use the Airport Express A1264 as an Access Point and a DHCP server at the same time?
I would like to use it as a DHCP server and AP at the same time in my LAN (no internet, just local machines through a few switches). I was lead to belive this could be the case from a few networking friends that haven't been friendly enough to help me out setting it up.

I need it to act as a dLink/Cisco/Linksys/etc basic wifi router, in the fact that you can access it via wifi, and it will spit out DHCP addresses (192.168.1.xxx) to everything wired downstream of it.
I want to simultaniously provide a Wifi connection and a LAN connection at the same time
Thanks,
BRad

Can I connect multiple Mac's using the Airport Express?

As subject. I have got an Intel iMac and a MacBook. Can I connect them using the Airport Express? Or in another word, to create a network among them that I can see the other Mac on one Mac?
Sorry, if I raised a silly question. But really like to know.
Many thanks in advance.
Gary

Can I connect them using the Airport Express?
Yes
Or in another word, to create a network among them that I can see the other Mac on one Mac?
Yes

Can i use the airport express in my hotel with wired connection?

I'm going to be traveling quite a bit coming up and staying in hotels with wired internet connections in the room. Can i use the airport express to connect with the hotel's internet connection and then my ipad and/or iphone 4S? I'm new to Apple products so will certainly appreciate any info that may help. Thank you!

You will need to have AirPort Utility installed on the iPad and/or iPhone. It is free on the App Store
App Store - AirPort Utility
Connect the AirPort Express 802.11n to the hotel Ethernet jack using an Ethernet cable
Power up the AirPort Express and wait 40-45 seconds
Tap Settings, then tap Wi-Fi on the iPad
Tap the AirPort Express under the heading of Set up an AirPort Base Station
AirPort Utility will take a moment to to analyze the connection and then you can proceed with the easy guided setup
Once the AirPort Express is configured, you should not have to set it up again at the next hotel. But, you could if you want to.

How many airport express can I add to my network for the purpose of using the airport express to send audio signal to different rooms in the house? I'm interested I'm running about six different zones.

How many airport express can I add to my network for the purpose of using the airport express to send audio signal to different rooms in the house? I'm interested I'm running about six different zones.
What I'm looking to do is to have self powered in ceiling speakers in every room in my house with out having to run wires to every room to carry the audio signal. I would like to use the airport express to do the job of carting the audio signal.
Here's my set up now I have an airport extreme and one airport express that I use to carry audio to one room.

FWIW. I have used up to four AirPort Express Base Stations (AX) for streaming sucessfully in pretty much the way you have described. I didn't have a need to try more so I can't attest that more would or would not work.

Can I use the airport express with a desktop computer that is not wire less- I want to have wifi in the house for an iphone

Can i use the airport express with a desktop computer not wifi- I want wifi for my iphone

I can't seem to find any information anywhere. It seems like it should work since the AX is showing up on his wifi settings on both his iPhone and iPod. Not to mention the Apple "Genius" told him that it should work. However, they also told him that it came with an ethernet, USB and the stereo patch cables...

Can I use the Airport Express as a cable modem?

I am trying to set up wireless internet in my home, and I am planning to purchase an Airport Express. Can I use the Airport Express as a cable modem, or do I have to purchase a modem from the ISP and then connect the AE to the output of the cable modem?
Thanks,
Adrian

No, the AirPort base stations do not perform the functions of a DSL or cable modem, so you will still need to acquire one.

Using the AirPort Express to Join an existing Wireless Network

Hello,
I am hoping you can provide me with some help on this... I recelty acquired a PowerMac G4 with a 450 MHz processor, CD-RW/DVD-ROM drive, Zip Drive, 1 GB RAM, and two 40 GB HD... The system has OS 10.4 installed, and it is has built-in Ethernet...
I was told I could use the Airport Express to connect to an existing wireless network, so I purchased an Airport Express base Station... Thing is, to e honest, I am having a bit of a problem getting started...
- First, to connect from the AirPort Express to my G4, do I need a special kind of Ethernet cable, or will the usual kind do?
- Second do I need to istall the software first, or have the Airport express connected to the G4 before I do?
How would I go about setting this up, step-by-step?
Any information would be appreciated...
Thanks for your time...

OK, thanks. Hopefully, the Netgear is creating a wireless network using WPA/WPA2 security. That will make it much easier for the AirPort Express (AX) to join the wireless network. It can join networks with using WEP security, but password issues almost always arise using WEP.
Since you must enter the exact security settings and password for the wireless network, it would help tremendously to know this in advance. Otherwise, it's going to be a series of "trial and errors" and likely frustration, later on.
When you have a moment, check the security settings on the Netgear router.
It might be one of the following: WPA2 Personal, WPA/WPA2 Personal, WEP 128, WEP 40.

I currently have wireless, but i am looking into this to maybe have faster wireless. if this is hooked up, will the existing wireless/ethernet to pcs still function without changing them to use the airport express?

i currently have wireless, but i am looking into this to maybe have faster wireless. if this is hooked up, will the existing wireless/ethernet to pcs still function without changing them to use the airport express?

let me fix this a bit. i currently have dsl and a 2wire wireless router, and i currently do not have one or a mac. im getting one for when i start college and this is a must if it will improve my internet. but i now connect wirelessly to the 2wire router. if this is set up, will the current 2wire wireless still be useable?

Can I use the Airport Express to create a secure wireless network in a wireless-only hotel?

Can I use the Airport Express to log onto an unsecured hotel wireless network, without an ethernet cable, to create a secure wireless network for my MacbookAir, IPad, IPhone, etc.? If so, how is that done?

will the Airport Express allow you to log onto a hotel wireless network, and broadcast a secure wireless network in your room for your wireless devices, like the Ipad, Iphone, etc.?
The bottom line with a single AirPort Express is no.
The AirPort Express can only "extend" a wireless network when the network is being provided by another Apple router.
As you might imagine, it is extremely unlikely that that the hotel network....which no doubt uses professional wireless access points provided by a manufacturer of commercial systems.....would be compatible with an AirPort Express.
In many years of travel domestically and internationally, I cannot recall a time when a single AirPort Express would "extend" the signal provided by a hotel's wireless network.
However, if you had two AirPort Express devices handy, you might be able to configure one to "join" the hotel network and provide an Ethernet signal to the second AirPort Express, which would be configured to "create" your own "private" wireless network.

HT3728 I do not need another wireless network but want to use the airport express for printer access only. Can this be done and how?

I do not need another wireless network but want to use the airport express for printer access only. Can this be done and how?

You can configure the AirPort Expess to "Join a wireless network" and enable the Ethernet port so that Ethernet devices will be able to connect.
In order to print from the iOS devices, you will need to have an application like Printopia installed on your Mac. The Mac must be active when you want to print.
More details here: Printopia - AirPrint to Any Printer - Print from iPad - Print from iPhone ...
There is a free trial available for Printopia, so make sure that it will work before you buy the AirPort Express.

I am currently using the Airport Express to work with a Bose Wave radio. 3.5 MM jack out and phono connectors into Bose. Is there a way to hook to a new Bose Wave which does not have phono input plugs?

I am currently using the Airport Express to work with a Bose Wave radio. 3.5 MM jack out of the Express and phono connectors into Bose. Is there a way to hook to a new Bose Wave which does not have phono input plugs?

The latest Bose Wave SoundTouch music system still uses a single 3.5 mm analog Aux port. You would connect the two using an analog audio cable with 3.5 mm stereo jacks on either end.
An example cable would be located here.

While using the airport express can I listen to music streaming from the Internet?

While using the airport express can I listen to music streaming from the Internet?

The music must be in your iTunes library.
Or, you can try to add a special application like Airfoil that may allow you to stream any audio signal on your computer to the AirPort Express. It might work.
http://www.rogueamoeba.com/airfoil/

Using the airport express

I am interested in streaming my iTunes music to my stereo. The airport express is ofcourse perfect for this but I have a few questions before I spend the money on this. I want to make sure I can do this.
I have an iMac up in my bedroom connected to a netgear wireless router. It is however connected using an ethernet cable and not wirelessly. I am using the wireless for my iBook downstairs in my kitchen. I don't want to extend the range of my network at all and I know I can't because my router dosen't support WDS. If my iMac is connected by cat 5, can I still stream music to the airport express on a seperate wireless network? Do I need to be on the same network as the airport express exclusively? I want to only use the airport express only for sending music to my stereo downstairs in my living room. Can the airport express be a device on my existing network??? I will not be using it for printer sharing or internet connection. Can this be done????
Thanks for your help!!!

I found the answer in the FAQ on the support page. I can set it to join the network in client mode. I went out and bought one and it connected in a snap and I am playing music all over my house!

Strange download/upload speeds using the airport express as a repeater

Similar Messages

Maybe you are looking for