Unable to find data in s677 table

Question

Hi I had maintained planned data in md63 for month 1-5 of 2012 but unable to find it in table s677, help.

Answer 1

Hi Allen,
Referring to replies:
1. You entered values directly in MD63
2. No updates in table-S677 or PBIM.
Let me clarify few things.
SIS-S677 is custom info structure (Not a standard SIS) designed to your requirement. That means you're working on S&OP Flexible Planning module.
So as a prerequisite to this module you must maintain below mix of Config & master data:
1. Sales Info Structure i.e. S677 with update groups & rules. To capture any sales history.
2. Planning Type: It's config and Planning type defines the content and the layout of the lines in the planning table.
3. Planning hierarchy: It's a Master data and is a combination of characteristic values based on the characteristics of one information structure.
4. Planning Table: It's the place where a Planning is done.
After all above set-up, you would be able to enter in Planning Table for planning the products.
Steps for Planning/Forecasting:
1. Based on your SIS Update groups & Rules, a S677 will be updated with sales quantities with Version-00 and same will be used to calculate forecast.
2. Using forecast model setup, a forecasting can be run in Planning Table for a particular product.
3. Forecast/planning values then will be saved in Planning Table. Once you save these values & come out of Planning Table, these values will be updated in S677 with version-A00.
4. Then you need to transfer Forecast/Planning values to Demand Management from Planning Table.
5. Check if values can be seen in Demand Management (MD63). If yes, a seperate SAP standard table-PBIM, PBHI etc. will be updated. These values in MD63 are called as Planned Ind Requirement (PIR).
6. Once PIR can be seen in MD63, you can run MRP Run.
7. Once MRP finished, you can go-ahead with further processing.
This is how the complete scenario is. Check if it's okay and then revert if any further issue.
Regards,
Anup