Can n86 charge using usb cable connected to power ...

I know that nokia n86 is chargeable via usb cable connected to the computer/laptop. However, I don't always have a laptop or computer with me while I'm travelling so I was wondering, is it possible to charge my n86 using a usb cable connected to a power socket using a usb adapter like those used to charge mp3 players if I didn't bring the charger with me? will it spoil the phone?
Thanks in advance.

should work fine as long as it is an official USB device. I have a Nokia USB charger and that is rated at 5V/1200mA and I have used a 3rd party USB charger and that has worked also. As I understand it you need something with at least 5V/500mA. I think my 3rd party one was about 600mA

Similar Messages

  • Curve 8330 Shows full charge using USB Cable on Desktop, but isn't fully charged.

    I have an issue with my 8330 and Charging. I plug it into the computer using the supplied USB Cable to download/ upload media while it charges using my desktop. Last night it indicated it was fully charged, so after downloading some things onto it, I shut it down and disconnected it from the desktop.
    This morning I got to work and turned it on and the battery life indicator on the home screen showed it was 3/4 charged. The time on the clock was off also and I had to go in and update the time in the settings tab. When I returned to the home screen from updating the time, the battery indicator showed half full. This is the second incident where after charging the phone either on the USB Cable connection or the wall charger, I've turned it on the next morning only to have half a charge or a little more. Any information on this would be helpful. Thanks!
    Brian

    Try Restoring it (this will remove all data from the iPod), resync, use it until the battery is low, and then fully charge it. And make sure your Dell is set to provide full power to USB ports.

  • Zen Micro wont charge using USB

    Hi,
    Can anyone help me. I have just purchased a Zen Micro and a Zen Touch. The Touch works fine. My wifes micro on the other hand is not - there was no charger in the box. I was under the impression that it can also charge using USB, but my machine (which is quite old btw - P4 650mhz Gateway) does not recognise it. Is it a problem with my machines USB, or is it more likely to be a problem with the Micro? I have purchased a Charger which should be around in the next couple of days (thinking it may need to be charged using a charger on the initial charge).
    Any help would be appreciated,
    Thanks in advance,
    Steve

    Do you know what firmware your wife's Micro has? (Check System > Information from the Micro's main menu to be sure.) Also, what Windows version (and service pack, if any) do you use?
    Do you plan to use "to go" subscription services with the Micro? Current "to go" services include:
    FYE Download Zone (US only)</LI>
    HMV Digital (UK or Ireland)</LI>
    Napster To Go (US, Canada, or UK)</LI>
    Rhapsody To Go (US only)</LI>
    Virgin Digital (UK only; US version doesn't support "to go")</LI>
    Yahoo! Music Unlimited (US only)</LI>
    For the Touch, did you install the drivers from the CD, or download the latest drivers from here? You probably should download the new driver (unless you have 2.x Micro firmware with WinXP SP or 2) to be sure it will support the Micro too.
    Are you connecting the Micro directly to your PC, or thru a hub? If to the PC, is the USB connection you're using on the front or the back of the PC? It's best to connect to a USB jack on the back of the PC if possible, not to a front jack or hub (especially an unpowered hub which won't charge the Micro). It's also possible that the Micro has issues with your PC's USB configuration; you may need to buy a separate USB card (preferably USB 2.0--you probably have USB . jacks).Message Edited by RBBrittain on 09-05-2005 07:09 PM

  • TS3274 How can I connect tv to ipad?  Want it to use netflex but will not connect using USB cable.

    How can I connect tv to ipad?  Want it to use netflex but will not connect using USB cable.

    http://store.apple.com/us/browse/home/shop_ipad/ipad_accessories/cables_docks
    You should find a solution here

  • HOW CAN I CONNECT IPHONE 4 INTERNET TO MY PC USING USB CABLE

    HOW CAN I CONNECT MY IPHONE 4 INTERNET CONNECTION TO MY PC USING USB CABLE AND I HAVE DONE TETHERING IN MY PHONE AND ALSO DOWNLOADED ITUNES USING FLASH DRIVE AS I HAVE NO INTERNET CONNECTION IN MY PC AND IN MY PC THERE IS NO DETECTION OF ANY APPLE DEVICE. PLZ HELP ME

    First, knock off the all caps typing. It is considered shouting, rude, and is just plain hard to read.
    Since you use the term "PC," are you using an Apple computer or something that is Windows based?
    Barry

  • My iPhone 4s is stuck on a black screen that shows a USB cable connecting to iTunes. The phone will not turn on and the iTunes logo as I described only shows up when I plug the phone into the charger or my computer. I have tried the reset in restore mode

    My iPhone 4s is stuck on a black screen that shows a USB cable connecting to iTunes. The phone will not turn on and the iTunes logo as I described only shows up when I plug the phone into the charger or my computer. I have tried the reset in restore mode as well as the DFU? mode and it still will not work. I have the latest version of iTunes on my Mac. My error code was 2002. I also tried it on my laptop (windows 8.1) and none of the above worked. My error code on my laptop was 02. The phone is through Verizon and it has absolutely no damage. It was working fine up until this and I have been trying to fix it for 2 days. Please help! I am unsure of what version the phone was currently running on before this because I have another iphone that's my primary phone and have not used this one in about a month. I do not believe it was updated to IOS 7.

    Your iPhone is in recoverty mode at the moment so to possibly get it back up and running you would need to do a restore as you have been trying. Follow the steps in the article below for the specific error messages you have been receiving. If after following all steps the issue remains book an appointment at a local Apple Retail Store to have the iPhone evaluated.
    Resolve specific iTunes update and restore errors

  • If I suspend wireless connectivity can I then use the camera connection kit along with the usb ethernet adapter to connect to the internet?

    If I suspend wireless connectivity on my Ipad2, can I then use the camera connection kit alond with the Apple USB Ethernet cable to connect to the internet?

    No, you can't.

  • Using old charger and USB cable with new 755

    Just purchased a 755p from Verizon.  I've used a Tungsten E2 for a long time and was wondering if I can use my old charger and USB cable with the 755p.
    Post relates to: Treo 755p (Verizon)

    They are compatible.
    Post relates to: Palm TX

  • Battery charging of ipad2 using USB cable

    I am unable to charge my ipad2 when attached via USB to any of my computers.  It states "not charging" on the ipad.  Are there any settings I need to change in order to charge via USB?

    chris5354 wrote:
    Ipad 2 will charge with usb cable even it show "not charging" it just take a longer time because regular usb port does not give out 10w, let connected overnight and you'll see its charging...
    or you can install a software called ai_chargexxx (i forget the full name) on your PC, just google it
    This is not correct.  If the battery icon on your iDevice doesn't show the lightning bolt, it isn't charging no matter how long you leave it on there.  Most accessory USB ports on computers aren't powered and are bus-powered drawing power from the computers USB interface without a seperate power hookup.  That aside, for devices the require more power than this, they will not work with this type of USB, as in the iPad.  Most USB's that have the juice to power anything are typically found on the back of the computer and typically only provide 500mA which again is pretty low.  That would charge it, but you might as well watch corn grow which would be faster.
    As for the software you speak of, not heard of it, but willing to check it out.

  • Car connection using USB cable

    When attempting to connect phone to stereo using USB cable get message saying USB not recognised ??

    If you have content on the SD Card you can change to Mass Storage mode to get this to work: Main Menu > Settings > Xperia Connectivity > USC Connectivity > USB Connection Mode > Mass Storage.
    What are your thoughts about this forum? Let us know by doing this short survey.
     - Official Sony Xperia Support Staff
    If you're new to our forums make sure that you have read our Discussion guidelines.
    If you want to get in touch with the local support team for your country please visit our contact page.

  • As a Verizon FIOS client, can we just use Ethernet cable to connect to time capsule, or do we need their router to connect to the time capsule?

    As a Verizon FIOS client, can we just use Ethernet cable to connect to time capsule or do we need the Verizon router to connect to time capsule?

    The Time Capsule is indeed a wireless router with simultaneous dual band capability...and a hard drive for backup purposes. You can use that to your advantage if you configure the Time Capsule as I suggested in Bridge Mode.
    The Time Capsule will provide a 802.11n 5 GHz band and a 802.11n/g/b compatible 2.4 GHz band to allow virtually any device to connect to the network.
    I suppose that you could also use the "g" wireless network provided by the Verizon router as a "guest" network or something similar if you really do need another wireless network.
    It might be possible to configure the Time Capsule as the main router on the network....that's a question for Verizon. But even if you might be able to do this, I'm sure it is not supported by Verizon, so you would be on your own in the event of any Internet connection difficulties on your service.
    And, since the Time Capsule does not have a built in modem....you would still need to add a separate modem to the installation anyway.
    That's why my suggestion is to use the Verizon device as the "modem" and let the Time Capsule provide the dual band wireless network and of course, handle the Time Machine backups.

  • Iphone 4 internet cannot connect to pc using USB cable

    Who know whant happen of this.before i can connect to PC and right now update to IOS 7 and cannot connect to PC while using iphone internet.

    Hello there Alex,
    Thank you for using Apple Support Communities.
    It sounds like your personal hotspot is not working when connected to your computer via USB.
    I recommend this article to help troubleshoot what is happening named:
    The instructions are different depending on the version of your OS:
    iOS: Troubleshooting Personal Hotspot
    http://support.apple.com/kb/TS2756
    USB troubleshooting
    If you are using USB to connect your computer to Personal Hotspot and you are unable to get an Internet connection, check your computer's network settings. You may need to adjust your computer's network settings to disconnect and reconnect the USB Ethernet interface.
    Select your operating system for instructions:
    Mac OS X
    Windows XP
    Windows Vista or Windows 7
    Cheers,
    Sterling

  • TA44551 my gen 4 iPod doesn't charge, the usb cable is good(works on other apple products) What should i do?

    my gen 4 iPod doesn't charge, the usb cable is good(works on other apple products) What should i do?

    What normally happens is most people take showers and listen to thier ipods or live around many sources of humidity.  Moisture corrodes the 30 pin connector on the ipod touch.  Clean and inspect the ipod touch's connection pins to resolve most charging/ sync issues.. The pins could also be dirty, bent or broken.  If dirty: Take 91% rubbing alcohol, dip a tooth brush into it, shake the excessive alcohol off leaving the brush damp(don't use to much alcohol, it should not be dripping).  Careful!!! The Pins are Very Fragile! Gently brush the connector pins, long ways, left to right in a few second bursts, inspecting the pins as you go...   If you have an eye loop or magnifying glass you can see inside the connector easily and see if the pins look dirty or bent or broken.  If they are bent you have to VERY GENTLY stand them back up.  If they are bent very far down, chances are you will snap them off trying to straighten them back up.  If they are not severely bent over, use a very small flat head precision screw driver to bend the pin back parallel with the good pins.  Pease note: certain pins are used by the wire for different things such as sync or charging... If your pins are broken off, do a search and find out what the individual pins on the ipod 30 pin connector do to see what is affected.  Worst case is your pins are broken off.  U can attempt to solder the broken pins back on without opening the ipod touch, which is super difficult to do, or you can open the touch and repair/replace to 30 pin connector entirely.  U will need to do some micro soldering to say to least! Don't attempt unless you are confident in your soldering skills and research how to open an ipod touch? You will need some specific tools and watch out for floating LINT!  Get some canned air ;) use a small 1/2 second bursts from 4-6" away because it will steam up you touch if used for to long. Good luck!

  • Xperia L is not charging through USB cable

    HI My Xperia L is not charging through USB cable,i am using original USB cable which is provided by the company in the box, But it was charging through Wall charger.. How can solve this problem

    Step one: pull out the battery Step two: Short the terminals of battery. SImply licking the golden connectors would do so. You would feel salty taste Step three: reinsert the battery and let it charge Magic just happened

  • Using Usb cable?

    I have tried using various mini USB cables to connect my BB to my desktop PC
    I have used a cable with separate power and with out. I always get a message saying there needs to be a connection with more power.
    How is that achieved?
    Thank you

    This may be due to the USB port not being a high-powered USB port, try another USB port in your CPU to see if that rectifies the issue....
    If I successfully help you with an issue, thank you for clicking "kudos" in my post.
    If your issue has been solved, please resolve this thread by marking the post which solved it for you!

Maybe you are looking for