Can only hear sound through headphones

i can only hear sounds on my ipod touch through my headphones

first try plugging and unplugging your headphones at least a dozen times really fast because somtimes the headphone jack sometimes has debris in it. i used to have the same problem.
if that doesnt work restore it back to factory defaults by going to the setting icon then go to the general bar, after that scroll al the way to the bottom and click reset, then click reset all settings after that if it still wont work do the same thing accept click on erase all content and settings 

Similar Messages

  • Only hear sounds through headphones solution

    I had a problem recently where I could only use my headphones. Being the geek in nature I am I thought long and hard, and figured that it had to something to do with the iPod since that's what I was using last. I think the iPhone gets confused when you pause using the headphone buttun, and locks it in this mode. After fumbling around, reinstalling everything, it occured to me to just put the headphones back on, play the ipod, and stop it using the phone pad, not the headset button --problem solved. A friend just had s=this same problem, and I recommended this solution and it worked for him too. I hope you read this before you go through all the anxiety I did.

    Its safe to assume that this phone was working prior to the update?  I would do a restore through iTunes but this is my personal opinion.  The update didn't effect everyone this way or Apple would have a big problem so it's pretty safe to guess something went wrong with yours.  As far as Facetime goes,  I don't believe they were going to allow it over 3g.  The iPhone 5 supports LTE which is faster than most wifi so its allowed on there but 3g is much much slower.
    Cheers

  • TS2634 I can only get sound through my ipad with the head phones.

    I can only get sound through my ipad with the head phones. I haven't had this problem before. I upgraded about a week ago, but this is the first time the sound has been an issue. When I turn up the volume it shows that it is the volume for the headphones but I can't figure out how to adjust the volume for everything. I have rebooted.

    Also try this if above doesn't work.
    1. Plug and unplug my headphone jack into the iPad four times.
    2. On the fourth time leave the headphone jack connected and rotate the plug clockwise, then remove and try your sound.

  • Can only hear sound out of one ear in iPod 30gb

    My nephew can only hear sound from one ear of his headphones.
    1) he's not becoming deaf and we've tried multiple pairs of headphones that give the SAME result.
    2) the volume settings are correct, so its not that.
    What are the options here? Is there a known fix? If its a hardware issue, can Apple do anything (free under warranty or repair with charge)?
    Thank you for your help!
    - John M.

    maybe that the file only offers one audio track. have tried other players to play it?

  • Help I Can only hear sound from my juke b

    can anyone help me i think i screwed up my computers sound and i dont know how. I can only hear sound from musicmatch jukebox when i play a song. i cannot hear sounds from any of my games or othe applications. please help me!

    Verify that the volume is set to a level you would normally be able to hear.
    Ensure that there is nothing plugged in to the headset jack or the dock connector.
    If the iPhone is in a protective case, make sure that the speaker port isn't blocked by the case.
    Make sure that the speaker and dock port aren't clogged with debris. If necessary, clean it with a clean, small, dry, soft-bristled brush. Carefully and gently brush away any debris.
    If an audio issue occurs when using a specific application, try testing other applications to see if the issue persists.
    If the iPhone is paired with a Bluetooth headset or car kit:
    Try turning off Bluetooth. 
    If you experience difficulties with the Bluetooth feature, follow these troubleshooting steps.
    Restart the iPhone.
    If restarting doesn't fix the issue, ensure that your iPhone is updated to the latest version of iOS.
    If the issue is not resolved, please contact Apple Support.

  • I can only hear sound from one side of the head phone

    I've plug in my bass guitar through a cord and a converter in the line in port on my PC. Then checked 'listen to this device' (head phone) which is connected properly as it worked perfectly when I play any sound in ma PC. But when I play my guitar, I can
    only hear it from one side of the head phone. How to fix it!?

    Is that compatible to give output from both sides (R + L) ? Can you check same thing on other system ? 
    Arnav Sharma | http://arnavsharma.net/ Please remember to click “Mark as Answer” on the post that helps you, and to click “Unmark as Answer” if a marked post does not actually answer your question. This can be beneficial to other community members reading
    the thread.

  • Why all do videos stop when i maximize them on youtube ? i can only hear sound. It hasnt happened before. It works with other browsers. I wouldnt like to change mozilla.

    I think this happened a couple of weeks ago. I sudden realized that everytime i change the quality of a clip on youtube or simply maximize it the video stops playing .. i can only hear the sound. Trying with different browsers works just fine. Please help

    Try to disable the hardware acceleration in the Flash Player.
    See [[Cannot view full screen Flash videos]]
    * http://www.youtube.com/swf_test.html (right-click the player: Settings)
    Flash "Display settings" window:
    * http://www.macromedia.com/support/documentation/en/flashplayer/help/help01.html

  • Can only hear phone through speaker

    Can someone please help me. I updated my iPhone yesterday and now I can only hear callers via the speaker function. The regular ear portal and earphones no longer work. Anyone with experience with this?
    thanks,

    As absurd as that was, it actually worked. None of my system sounds were working either. I had used the iPod function of my iPhone last night, so I'm guessing that's what goofed everything up. Does Apple know about this yet?
    -Mateo

  • Cant hear sound through headphones

    Someone please help. I still can not hear any sound through my headphones or record.

    Try a hard reset and go from there.
    Basic troubleshooting steps  
    17" 2.2GHz i7 Quad-Core MacBook Pro  8G RAM  750G HD + OCZ Vertex 3 SSD Boot HD 
    Got problems with your Apple iDevice-like iPhone, iPad or iPod touch? Try Troubleshooting 101

  • Can't get sound through headphones

    I cannot get sound through earbuds

    Couple of things to check here. 
    1.  Toggle volume buttons on headset
    2.  Check sound settings
    2.  Try a different headset to rule out the phone
    3.  If a second headset does not work check the headphone jack for debris
    4.  If no debris, and the phone is still under warranty, contact Apple Support or go by an Apple Store for service

  • Can't hear sound with headphones

    In Logic Express 7, I can see the levels indicating that the software is recieving a MIDI signal when I play keys on my keyboard, but I can't hear anything in my headphones. What's the solution?

    It may be in the interface software. I use a FireBox and have to make sure the software for it is configured correctly. Also, check your System Prefs to make sure your output is being directed properly.

  • TS2771 I can only hear sounds from my ipod touch with headphones plugged in.

    I am only able to hear any sounds/music from my iTouch with the headphones plugged in to it.  I have the change with buttons selected to "on".  Am I missing something else?

    - Try cleaning out/blowing out the headphone jack. Try inserting/removing the plug a dozen times or so.
    Try the following to rule out a software problem
    - Reset the iPod. Nothing will be lost
    Reset iPod touch: Hold down the On/Off button and the Home button at the same time for at
    least ten seconds, until the Apple logo appears.
    - Reset all settings
    Go to Settings > General > Reset and tap Reset All Settings.
    All your preferences and settings are reset. Information (such as contacts and calendars) and media (such as songs and videos) aren’t affected.
    - Restore from backup
    - Restore to factory settings/new iPod.
    - Make an appointment at the Genius Bar of an Apple store. Seems you have a bad headphone jack.
    Apple Retail Store - Genius Bar
    Apple will exchange your iPod for a refurbished one for this price. They do not fix yours.
    Apple - iPod Repair price
    A third-party place like the following will replace the jack for less. Google for more.
    iPhone Repair, Service & Parts: iPod Touch, iPad, MacBook Pro Screens
    Replace the jack yourself
    iPod Touch Repair – iFixit

  • Cannot hear sound through headphones when running mainstage- Mackie 1220i interface

    I am currently running Logic Studio with my MacBook Pro with a Mackie 1220i mixer/interface. I can hear the processed sound fine on the mic channel and the guitar channel when the headphones are plugged into the mixer but I get no sound when the headphones are plugged into the MacBook Pro. I am trying to set up a concert in Mainstage. Suggestions?

    If you want to hear through the headphones of macbook pro you should change,
    in preferences of manstage,
    Go to audio
    Audio output from Mackie,
    set Built-In Output

  • Windows 7 64bit, MBP Retina, Only system sounds through headphones

    Like others I have been trawling through the support tickets but nothing seems to resolve the issue for me.
    Running Win7 64bit, I plug in my headphones and play audio (FL Studio) and audio continues to play through my speakers and not my headphones.  Interestingly when I turn the brightness or sound up and down the incremental "pip" sounds ARE played through the headphones.  It's as though Windows doesn't know to route the sound from apps through the headphones.  A few nights ago, Youtube started playing through the headphones, I quickly started FL Studio but this still played through the speakers.
    I have installed the latest Boot Camp drivers and the latest Cirrus Logic drivers CS4206B (AB40) but to no avail.
    Any one made progress on this?
    Cheers

    Hey Bill and thanks for your answer.
    Without changing a thing (to my knowledge) Prem 9 is now starting up properly.
    Well 5 out of 6 start ups have been successful!!
    Not sure why this is, but project editing and manipulation all seem to working fine and have even exported an end product!!
    I guess I'll just have to see how things go.
    Thanks again for your suggestions and Happy New Year!!!!

  • I cannot hear sound through my iMac Headphone port,

    I cannot hear sound through my iMac Headphone port, this is a very new computer. I can hear sound through the usb port of the device. How can this be fixed? Headphones are selected as an Output device.
    Please help in any way possible, it is becoming quite a concern as it was just working a matter of hours ago.

    usb does not carry audio at all it's a serial digital bus
    things one connect to usb which play audio act the role of being usb audio cards only 1 audio card can be active at the time so if you connect an usb audio card the internal audio card is muted
    this cause your headset to be muted
    disconnect the usb audio card and you will be able to use your headset
    if you wish to use a headset an an usb audio card at the same time the headset needs to be connected to the usb audio card

Maybe you are looking for

  • HP Laserjet 1100 -no scanner, fax, copier..just basic b/w printer

    Started getting about 1 inch grey line on front left border. Have changed toner cartridge no change. Have cleaned anything that looks like it could contribute, but nothing really dirty? Got any ideas? thanks

  • PDF prints garbage

    On occasion we have PDF documents that will look fine in the reader, but when printed all the characters turn to garbage. This has happened on three different computers (all Windows XP) and two different printers (both HP laserjets but different mode

  • CSS- Background img not showing up in container

    Hello, I am new to css but not to webpages. I used to design pages using tables and now I want to learn and design using css. But I'm having trouble and I figure its a quick fix. Note this website is not on line I am doing my test use IE 7 and Firefo

  • SMTP  - mail service

    Hi, i configured the SMTP for mail service. I can able to send mail to our domain   ( for ex: abc.com )  - default domain i gave SMTP Connection as  :  mail.abc.com  the above scenario --- will work for me if i send mail to our default domain. but i

  • SQL 2008 R2 In-Place Upgrade or Fresh Install to SQL2104

    We have a server running Windows 2008 R2 and SQL 2008 R2 currently.  We will call it SQL01.  This houses databases for about 8 different applications and also has the name hard coded into a lot,  I repeat, a lot of various things. We are at the point