Error 1013!!? (iPhone IMEI: Unknown ICCDI: Unknown)
Hi,
Last week I updated my Iphone to 4.3.3 (it was 4.2.1). After two days, when I wanted to make a call but I couldn't. I realized that the network is lost and it is searching! I just tried to search the network manually, but it didn't fix. Then I turned it off and on! But as it turned on, I noticed a message that said my Iphone needed restore! Also, it said that "iPhone IMEI: Unknown ICCDI: Unknown". I tried to restore my Iphone through different ways, tiny umbrella was one of them. But it didn't work. Moreover, it is like a dead phone! In fact when I restore it, it seems that the process is finished but just at the end of restoration error 1013 pops out.
What should I do? Do you think that there is something wrong with its hardware or I can fix it by myself?
please help me!
Moreover, it is like a dead phone! In fact when I restore it, it seems that the process is finished but just at the end of restoration error 1013 pops out.
There's some advice on that one in the following document:
iTunes: Specific update-and-restore error messages and advanced troubleshooting
Similar Messages
-
My iPhone 3GS 16gb, is stuck in restore mode, downloaded and tried to do a restore multiple times. Keep getting an error The iPhone "iPhone" could not be restored. Unknown error occured (-1). Cannot get it out of restore mode, keeps rebooting!
I have tried to hold the "home" and "power" button to reboot
I have tried powering it off
I have tried, to unplug the cable, hold the "home" button and then plug it in.
Can't check the SN or warranty, cause it is stuck in restore mode.
Is the hard drive gone? Should there be something replaced.http://support.apple.com/kb/TS3694#error1
Error 1 or -1
This may indicate a hardware issue with your device. Follow Troubleshooting security software issues, and restore your device on a different known-good computer. If the errors persist on another computer, the device may need service.
Usually this is caused by your antivirus or firewall blocking iTunes access to the Internet. It can also occur if the phone is jailbroken or if the computer you are using was ever used to jailbreak an iDevice. -
Hi everybody !
AT&T company is unlocked (factory)my iphone4 before 3 days ago so i want to restore to unlock iphone 4 with itunes but it is not restore.
How can I fix this type of error in iphone 4?- "The iphone could not be restored. An unknown error occurred (3194) "
please help me in nepali language(if posible) or english. thank you.http://support.apple.com/kb/TS3694#error3194
This means that either your firewall/antivirus is blocking access to Apple's servers, or you have used your computer to jailbreak an iDevice in the past. The link above tells you how to resolve this issue. -
When i try to connect my iphone to itunes it comes up with a message saying "itunes could not connect to this iphone, an unknown error has occured (0xE8000012)
i have recently bought new laptop and downloaded/installed the newest itunes and this has happened.. any ideas?read
Error -50
Delete Storm Video, QuickTime, iTunes, then reinstall iTunes. See also KB TS1583for error -50 -
ITunes could not connect to iPhone because unknown error (0XE8000001)
Anyone getting this error? iTunes could not connect to iPhone because unknown error occurred (0XE8000001)
I've had the same issue for a week now. Just tried to sync on my home iMac (week long problem at work on MacBook Pro, but trying a clean install at home didn't change things).
-
Why is my iphone saying "unknown error" when I try to download or update an app?
Why is my iphone saying "unknown error" when I try to download or update an app?
For answers, look to the right in the "More Like This" box. You'll find your issue has already been addressed.
-
Hi iPhone experts...I need your valuable suggestion...
My iphone 4 ios7 was having an censor issue...after fixing the censor issue...It's worked only for 4 hrs....after that it's came to Restore mode.
While I am trying to restore ..throwing an error "The iPhone could not be restored. An unknown error occurred(1)."
It's out of warranty.....
1.) I would like to know if there was any Mother board issues?
and also would like to know
2.) without doing anything suddently why it's went to restore mode?
3.) if that really a mother board issue, is it repairable(Location- Hyderabad-India)
Thanks in advance for your helpTry restoring it again. If it fails with the same error message, that pretty much always indicates a hardware failure. The phone will have to be replaced.
-
When restoring and updating my iPhone I am getting the following message " iTunes could not update to the carrier settings for your iPhone.an unknown error occurred (1630).can anyone please with a knowledge tell me what I should do please. Thank you
The search bar can be very valuable...........
In using it, I found out other's have had this issue and it likely means you have a 3G iPad? If you do, go into settings and turn off cellular data, then try to update again and you should be OK........ -
IPhone says Unknown error has occurred when getting an app or update
IPhone says "Unknown error has occurred" when getting an app or update.
What should I do?I also have this problem. I am thinking i am going to call customer support about this tomorrow. If i get it fixed i will post on here.
-
Hello,
this morning I received the following error message when the iPhone connected to iTunes: i
tunes could not check for an update to the carrier settings for your iphone. an unknown error occurred (1635)
any ideas? thxI get the same error (although in Dutch ;-)).
It also says something like (I'm translating): "Make sure your network settings are correct and your networkconnection is active or try again later." Is there a way to find out these "correct networksettings"?
I now get it for a week, eacht time I connect my iPhone to itunes... -
i am having problem when i am updating my iphone 4 to ios 5 ..it get update n took 50 minutes then at the end when it was processing file ...suddenly an error comes that an unknown error accurred {9006}..please help me..how will i update my iphone 4
Error 9006: Following Troubleshooting security software frequently resolves this error. There may be third-party software installed that modifies your default packet size in Windows by inserting a TcpWindowSize entry into your Registry. Your default packet size being set incorrectly can cause this error. Contact the manufacturer of the software that installed the packet size modification for assistance.
-
trying to sync my ipod and now this is what it say.. itunes could not connect to this iphone. an unknown error occured (OxE8000084)
Perhaps this support article will help:
http://support.apple.com/kb/TS3221
If not, check out the several other threads on the problem, some of which are listed under "more like this" at the right. You might find additional suggestions in one of those.
Regards. -
When i was restoring iphone 4s-'unknown error occured (2)' Any Ideas Please?
When i was restoring iphone 4s-'unknown error occured (2)' Any Ideas Please?
Disable security software or firewalls. This article addresses every error code itunes has. If you aren't sure how to disabled your security software or firewalls look at this article under the section for error '2'
http://support.apple.com/kb/TS3694 -
itunes could not connect to the iphone an unknown error occurred 0xE8000003 please help me with this error any one have idea ?
http://support.apple.com/kb/ts3221
-
when I click on check for update I get error, iTunes could not check for an update to the carrier settings for your iPhone. an unknown error occurred 1630
Make sure your network setting are correct and your network connection is active or try again latter.update your itunes to 10.5.2 and error is not showing up anymore..
Maybe you are looking for
-
Copying iphoto titles to backup drive
i've used the batch change function in iphoto to name and number a series of photos, but when i copy them to my external hard drive for a backup, the titles don't copy; i just have a string of IMG titles and no way of telling which photo is which. ho
-
In both of the RAD environment which I have previously used, there are property editors for a collection of a particular property type. In Borland's VCL the property editor is built-in once one uses a VCL collection as a property, while in .Net one c
-
No icon for JWindow in taskbar
Hi, When I make an app based on a JFrame and run it, i get the icon for the app in the taskbar so that i can see its running aswell as use to minimise/maximise the app. But when I make a app based on a JWindow, the icon is not present. Does anyone kn
-
Hi CRM Experts, I have to develop a Web UI report in CVRM 2007 for displaying Activity List. I know how t o develop a report in SAP gui but what I want to know is how to develop a web UI report in CRM 2007? Please let me know the steps. Regards, Sang
-
How change n900 xterm to sv_SE.ISO-8859-1?
I ssh from n900 to a debian server, which has locale sv_SE.ISO-8859-1. This mostly works fine, except when reading/writing email in mutt. I have had this problem with other terminals and usually solve it by changing locale to ISO-8859-1 (yes, I am no