I have a Sony Sa ns300, will it work with airport express to allow me to play iTunes in another room?

I have a Sony NS 300 will it work with airport express?

Not from the iPad, but you can from a computer.

Similar Messages

  • I have East/West Symphony.  Will it work with Logic express and do I have to have that little red usb drive in the computer to authorize it?

    I have East/West Symphony. 
    Will it work with Logic express and do I have to have that little red usb drive in the computer to authorize it?
    Also, would it work with Garageband??

    Thanks-that's the same driver I'm using now.
    The M-audio techs were unable to tell me if Quattro would work with LE8, so I've been wasting my time and money trying to make it work.
    They also gave me conflicting opinions as to whether or not "tip" polarity was an issue when using an after-market adapter. One said definitely yes, one or two others said definitely no.
    Their phone tech line has a 20 to 40 minute wait when I call. The online support system is confusing, which even they admit. I don't think my next interface will be from M-audio.
    Thanks very much for the response, it helps me get beyond this phase.
    Is the Quattro of any use for anybody else (i.e., can I sell it or give it away)?

  • HT4260 Will this work with AirPort Expresses?

    Has anyone set up a roaming network as shown in an Apple Knowledge Base article entitlted “Wi-Fi base stations: Setting up and configuring a roaming network,” where the slave units are AirPort Expresses?

    Has anyone set up a roaming network as shown
    Sure, works just fine.
    Unfortunately, that Knowledge Base article....while providing good general information.....is a few years out of date, and does not apply to the setup for Macs running the Lion or Mountain Lion operating system.
    Apple has yet to update the article, but we can provide the "how to" with Lion and Mountain Lion if you are interested.

  • I have the 6.1 eval will it work with ny acquition board

    I have the 6.1 eval will it work with ny acquition board.

    Hello;
    Yes, just make sure to point to the DAQ board during the uinstallation of the evaluation version.
    Regards
    Filipe A.
    Applications Engineer
    National Instruments

  • HT204387 I have samsung sbh700 headset. Will it work with my ipad4.if yes then how

    I have samsung sbh700 headset. Will it work with my ipad4.if yes then how

    apps are linked to the ID used to download them and can only be updated with that ID.  That said if you adopt a new ID you will not lose apps and data

  • Time Machine will NOT work with Airport Disks!

    It looks like Time Machine will not work with Airport Disks after all. All references to Airport have been removed from the Time Machine page:
    http://www.apple.com/macosx/features/timemachine.html
    It also specifically says: "You can designate just about any HFS+ formatted FireWire or USB drive connected to a Mac as a Time Machine backup drive. Time Machine can also back up to another Mac running Leopard with Personal File Sharing, Leopard Server, or Xsan storage devices."
    Surely, they would have included the Airport Extreme Base Station in this list if it was supported.
    I really hope there will be another firmware update for the AEBS which will bring compatibility with Time Machine, because Time Machine was the only reason for me to buy an AEBS. (I only use it as a small backup server, I don't even have wireless networking enabled. There were other solutions, e.g. from Synology, which are faster and more reliable than AEBS disk sharing, but Synology stated their network drives would not be compatible with Time Machine.)

    Here's how you can potentially use your AirDisk with TimeMachine (beware that YMMV), but it should work as it works with every other "unsupported" device.
    1) Mount your AirDisk so it appears on your Mac
    2) Open Terminal.app
    3) change directories to the AirDisk's root folder located in "/Volumes"
    ie: cd "/Volumes/AirDisk Name"
    4) execute this command to "bless" the drive to be used with time machine:
    touch .com.apple.timemachine.supported
    5) Start TimeMachine and if all went well, it should recognize your AirDisk drive and use it for TM.
    This should also work on NFS shares, SMB shares, AFP shares, basically anything. It has worked up until the last developer seed, so unless they yanked this at the last minute, it should still work.
    Now, the reason why Apple removed this feature may be due to the unreliability of the AirDisk, so be cautious.

  • My two iMacs frequently go offline when I have our iPad and two iPhones-5 connected with Airport Express (2nd edition). If I disable WiFi on my three "i" devices no problem. Any thoughts on this?

    My two iMacs frequently go offline when I have my iPad and two iPhones-5 connected with Airport Express (2nd edition). If I disable WiFi on my three "i" devices the offline problem stops. Any thoughts on this?

    .....doesn't that seems to suggest the modem?
    That is what I have suggested....twice now. From posts above:
    My opinion would be that it is likely not the ISP, unless you have complete loss of Internet service for all devices at the same time......it is the Comtrend device....
    and
    I believe that the problem lies with the modem, and not the ISP signal.
    Your ISP will likely have a different opinion, though. Please keep us posted on your progress.

  • Will any non USB printer work with Airport express?

    WIll any non USB based printer work with airport express?

    If you have an iPad, you might want to concentrate on printers that are AirPrint compatible, so that you can print from the iPad.
    See this Apple support document for more details.
    http://support.apple.com/kb/HT4356

  • We have a Lexmark Pinnacle Pro901 and cannot get the printer to work with airport express - any suggestions?

    Can anyone give us suggestions on how to get our Lexmark Pinnacle Pro 901 to work with airport express? We cannot get airport express to recognize the printer.

    Refresh all your devices before reconfiguring printer to connect to your computer.
    a Shutdown computer
    b Pull out printer power cord from the socket. Let it stay for at least 30 seconds then plug it back.
    c Powercycle your router (unplug your router for at least 30 then plug it back. This will not change the settings of the router. This will just refresh the device)
    d Once router is ready , put back brick at the back of the printer to turn it on
    e Wait one minute
    f Turn on computer
    Repair your disk permission: http://bit.ly/OeD7U3
    Run Cleanup tool http://bit.ly/vnukXY
    Download updated driver from Lexmark website http://bit.ly/ToA1fo
    Run firmware update http://bit.ly/AcNqbg

  • Will ipod touch work with airport express?

    will ipod touch work with airport express?

    Is your Touch running iOS 5.n? If so, you can administer the AX with the AirPort Utility which you can download directly from the Apple App Store.

  • Will a TiBook with Tiger OS work with Airport Express?

    Will a TiBook with Tiger OS work with Airport Express?

    Use AirPort Utility 5.3.2 for Tiger. It will work with the current Express.

  • Have Thundbolt on my mac will not work with my thunderbolt drive

    I have a port on my Imac, but it will not work with my ThunderBolt Drive

    Agree on cables, you don't want something generic when it comes to thunderbolt in my experience. It's thos accessories that add up and they are profitable for a reason. Cheap isn't always good with accessories.

  • Can I have cable modem connected to iMac but shared with Airport Express?

    I have my internet access to my iMac through a cable modem wired to the Mac. I use the Airport Express to play music from the Mac wirelessly to my stereo. Can I then share the internet access I have on the iMac through the AX without actually connecting the modem to the AX? The wiring is easier to get to the Mac than it would be to get wiring from the cable modem to the Airport Express at the stereo. I want to be able to access the internet wirelessly from a PC laptop that I also have.
    Thanks

    Yes, you can do that. Using the AirPort Utility, you would set the AirPort Express up to create a wireless network giving it whatever name you want. When it gives you an error message that nothing is connected over ethernet, you can click the button to ignore that message and it will perform as you are requesting.
    Note that if your internet connection stops working when you do this, then you may need to change your network port priority so ethernet is higher than AirPort.
    Mac OS X 10.5 Help: Changing the priority of your network connections
    http://docs.info.apple.com/article.html?path=Mac/10.5/en/8853.html

  • 1.5 TB Seagate drive will not work with Airport Extreme.

    I have a 1.5 TB external drive connected to airport extreme.  I cannot get this drive to be recognizedby the computers connected to the Airport Extreme.  The drive show up as "-1.4 TB - Seagate FreeAgent 0138"  under disks in Airport Utility can plug it in directly to my Mac Air and a PC and the drive will work. When I plug the drive in directly to a PC or Mac Air,  it is recognized and can be used. 
    I can plug in a 250 GB external drive into the Airport extreme and they will work.
    Also,  the 1.5 TB works when plugged locally to a PC or Mac using USB. 
    Anyone know how to get it to work with the Airport Extreme?

    Assuming that the drive has been formatted in Mac OS Extended (Journaled) or MS-DOS FAT32, you almost always need to use a powered hub with a drive attached to the USB port on the AirPort Extreme...even if the drive has its own power supply.....because the USB port is under powered and will not supply enough current to most hard drives.

  • Old USB Quattro interface--will it work with Logic Express 8?

    I have an old m-audio USB Quattro interface (4in/out) which I used with Cubase years ago. I have it hooked up to my wife's intel iMac with more than enough RAM. Logic seems to run fine, but I get a very weak signal through the interface. Apparently I have the correct driver. I don't mind buying a new interface if this one is not going to work, but the hard part may be in determining whether or not it will work. M-Audio doesn't seem to know (I'm less than thrilled with their support). Any experience or thoughts on this?
    thanks!

    Thanks-that's the same driver I'm using now.
    The M-audio techs were unable to tell me if Quattro would work with LE8, so I've been wasting my time and money trying to make it work.
    They also gave me conflicting opinions as to whether or not "tip" polarity was an issue when using an after-market adapter. One said definitely yes, one or two others said definitely no.
    Their phone tech line has a 20 to 40 minute wait when I call. The online support system is confusing, which even they admit. I don't think my next interface will be from M-audio.
    Thanks very much for the response, it helps me get beyond this phase.
    Is the Quattro of any use for anybody else (i.e., can I sell it or give it away)?

Maybe you are looking for

  • How can I capture a semi transparent window?

    Hello all I am trying to grab an image of a semi transparent window into a bitmap. I have tried using both CopyFromScreen and BitBlt using the window handle but in both cases all I get is the image from behind the window I want to catch, it's like th

  • Use of "PSA in Char format" option in data source

    Hi, When I am looking in to the datasource in SAP BW, I have seen the option "PSA in Char format",what is the differnce between the data loading into the PSA with char format or with typed structure. Are we not able to correct data in the PSA if we h

  • 6300 - How do I set my signature in SMS please?

    I have recently purchased the Nokia 6300 - But for the life of me I cant see where to put a default Signature for text messages - I have to keep typing my name at the end of every SMS! Can someone help me please? Have looked in manual but cant find a

  • Fetched Groups - CMR

    I'm having problems with CMR fields. My ejb-jar.xml & sun-ejb-jar.xml files are correct. Can anyone explain me the use of fetched groups ? Explanation of the tag <fetched-with></fetched-with>? Thankx D.Geerts The following errors occurs all the time

  • I'm trying to make a purchase and it's referring me to you

    What do I need to do to resolve why I cannot make a purchase.