Error in distribution to R/3

Question

Is there any way of seeing inbound BDocs in R/3?
I know that my message hit the outbound queue in CRM but the sales doc was not created in R/3.
I read an earlier message that suggested that you could deregister the queue in R/3 and then see if the message arrives, but we do not have any inbound queues registered. My order status changes to Error in distribution in CRM.
Does anybody have any ideas?
BTW - I can create an identical order directly in R/3.

Answer 1

Hi Stuart,
Before try further debugging into the queue, I just
wondering if you have check tcode SMW01 and SMQ1 ?
Normally you can see the error message thru these
Queue monitoring. The error message most of the
time is quiet straight forward to tell you what is wrong.
The error message "Error in Distribution" you see
is from document right? Could you tell the error
message from the Queue. This is the easiest way to
find out what causing the Error (but may be not the
very effective way - depends on the error message).
Refer to your question about deregister, I think
what you mean is deregister the Q-OUT Destination
(which pointed to R/3). By deregister this, your
next document created will stopped in the queue where
you can do DEBUG LUW (this is in tcode SMQ1).
I did this before when debugging BP transfer from CRM
to R/3. In your case, with document, should be same way.
Hope this helps.
Cheers,
Gun.